- 您現在的位置：買賣IC網 > PDF目錄383644 > MT8982AC (Mitel Networks Corporation) ISO-CMOS ST-BUS⑩ FAMILY Small Digital Switch (MiniDX) PDF資料下載
參數資料
| 型號： | MT8982AC |
| 廠商： | Mitel Networks Corporation |
| 英文描述： | ISO-CMOS ST-BUS⑩ FAMILY Small Digital Switch (MiniDX) |
| 中文描述： | 異意法半導體的CMOS總線⑩家庭小型數字交換機（MiniDX） |
| 文件頁數： | 4/14頁 |
| 文件大小： | 223K |
| 代理商： | MT8982AC |
MT8982
ISO-CMOS
2-34
When an output channel is in message mode, the
data for the output channel originates from the
microcontroller. The microcontroller writes data to
the Connect Memory location which corresponds to
the output link and channel number. The contents of
the Connect Memory are transferred directly to the
serial-to-parallel converter one channel time before it
is to be output. The Connect Memory data is output
MSB first, repetitively once per frame, until it is
changed by the microcontroller.
If the output channel is configured in tristate mode,
the TDM serial stream output will be placed in high
impedance during that channel time. This mode is
entered by configuring the channel into connection
mode and then setting the tristate control bit. All
channels on both output TDM streams can be
tristated by pulling pin 16 (ODE) low. This overrides
the individual channel programming.
The Data and Connect Memories are dynamic
memories. They are refreshed by the sequential
addressing generated by C4i.
Microcontroller Interface
The MT8982 is controlled via a synchronous, serial
microport. The microport is compatible with Intel's
MCS-51 serial port Mode 0 specifications, Motorola's
Serial Peripheral Interface (SPI) specifications, and
National's MicroWire specifications. The port
consists of a transmit data line (TxD), a receive data
line (RxD), a chip select line (CS), and a
synchronous clock input (SCLK). All memory
locations and control functions on the MiniDX are
accessed through this port. The microport may also
be configured in serial bus mode where data is
clocked into the Connect Memory in the same way
as STi0 and STi1 are clocked into Data Memory.
In serial microport mode, CS must be low to enable a
microport access. SCLK clocks the serial microport
data in or out through RxD and TxD, LSB first. The
TxD output driver is tristated when it is inactive. This
allows RxD and TxD to be connected together for a
single TxD/RxD line as used in the INTEL MCS-51
microcontrollers. Figure 3 shows a serial microport
access cycle.
A microport access cycle (microcycle) begins with a
falling edge on CS. Eight bits of data are clocked
into RxD by the rising edge of SCLK. Two of these
eight bits indicate whether the microcycle operation
is a read or a write, the rest of the bits are used for
addressing. These eight bits are defined as the
command/ address byte (Table 1). If the microcyle
operation is a write, another eight bits are clocked
Figure 3 - Serial Microport Timing
D
0
D
1
D
2
D
3
D
4
D
5
D
6
D
7
D
0
D
1
D
2
D
3
D
4
D
5
D
6
D
7
D
0
D
1
D
2
D
3
D
4
D
5
D
6
D
7
D
0
D
1
D
2
D
3
D
4
D
5
D
6
D
7
D
0
D
1
D
2
D
3
D
4
D
5
D
6
D
7
RxD
TxD
SCLK
CS
Minimum delay between accesses equals 3.0
μ
sec.
The Mini Dx:
- latches received data in on the rising edge of SCLK
- outputs transmit data on the falling edge of SCLK
The falling edge of CS indicates that a COMMAND/ADDRESS byte will be transmitted. Subsequent byte is always data.
Subsequent write microcycles may flow without raising CS. CS must go high after a read microcycle.
COMMAND/ADDRESS
DATA INPUT/OUTPUT
COMMAND/ADDRESS
相關PDF資料 |
PDF描述 |
|---|---|
| MT8982AE | ISO-CMOS ST-BUS⑩ FAMILY Small Digital Switch (MiniDX) |
| MT8982AN | ISO-CMOS ST-BUS⑩ FAMILY Small Digital Switch (MiniDX) |
| MT8982AS | ISO-CMOS ST-BUS⑩ FAMILY Small Digital Switch (MiniDX) |
| MT8982-1 | ISO-CMOS ST-BUS⑩ FAMILY Small Digital Switch (MiniDX) |
| MT8982 | Small Digital Switch (MiniDX)(小數字開關（無阻塞的CMOS定時開關）) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MT8982AE | 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:ISO-CMOS ST-BUS⑩ FAMILY Small Digital Switch (MiniDX) |
| MT8982AN | 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:ISO-CMOS ST-BUS⑩ FAMILY Small Digital Switch (MiniDX) |
| MT8982AS | 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:ISO-CMOS ST-BUS⑩ FAMILY Small Digital Switch (MiniDX) |
| MT8985 | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:Enhanced Digital Switch |
| MT8985AE | 制造商:MITEL 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。