- 您現在的位置：買賣IC網 > PDF目錄376195 > MSK4351U (Electronic Theatre Controls, Inc.) 50 AMP, 500 VOLT IGBT PLUS DIODE FULLY ISOLATED SMART POWER 3-PHASE MOTOR DRIVE POWER HYBRID PDF資料下載
參數資料
| 型號： | MSK4351U |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | 50 AMP, 500 VOLT IGBT PLUS DIODE FULLY ISOLATED SMART POWER 3-PHASE MOTOR DRIVE POWER HYBRID |
| 中文描述： | 50安培，500伏特IGBT的普樂士二極管完全隔離的智能電源3相電機驅動電源雜交 |
| 文件頁數： | 5/6頁 |
| 文件大?。?/td> | 405K |
| 代理商： | MSK4351U |
TYPICAL SYSTEM OPERATION
The MSK4351 is designed to be used with a +270 volt high voltage bus, +15 volt low power bus, and +5 volt logic signals.
Proper derating should be applied when designing the MSK4351 into a system. High frequency layout techniques with ground
planes on a printed circuit board is the only method that should be used for circuit construction. This will prevent pulse jitter caused
by excessive noise pickup on the current sense signal or the error amp signal.
Ground planes for the low power circuitry and high power circuitry should be kept separate. The two sections of the hybrid are
completely isolated, and can float relative to each other without referencing one to the other. An RC filter will filter out the current
spikes and keep the detected noise for that circuit down to a minimum.
The logic signals coming from the typical motor controller IC are set up for driving N channel low side and P channel high side
switches directly, and are usually 15 volt levels. Provision should be made for getting 5 volt logic signals to the MSK4351 of the
correct assertion levels. Typically, the low side signals out of the controller are high active and the high side are low active.
Inverters are shown in the system schematic for the high side controller output.
PRELIMINARY Rev. A 11/01
5
相關PDF資料 |
PDF描述 |
|---|---|
| MSK4351D | 50 AMP, 500 VOLT IGBT PLUS DIODE FULLY ISOLATED SMART POWER 3-PHASE MOTOR DRIVE POWER HYBRID |
| MSK4351ED | 50 AMP, 500 VOLT IGBT PLUS DIODE FULLY ISOLATED SMART POWER 3-PHASE MOTOR DRIVE POWER HYBRID |
| MSK4358S | 25 AMP, 500 VOLT IGBT PLUS DIODE FULLY ISOLATED SMART POWER 3-PHASE MOTOR DRIVE POWER HYBRID |
| MSK4358ED | 25 AMP, 500 VOLT IGBT PLUS DIODE FULLY ISOLATED SMART POWER 3-PHASE MOTOR DRIVE POWER HYBRID |
| MSK4358 | 25 AMP, 500 VOLT IGBT PLUS DIODE FULLY ISOLATED SMART POWER 3-PHASE MOTOR DRIVE POWER HYBRID |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MSK4354D | 制造商:MSK 制造商全稱:M.S. Kennedy Corporation 功能描述:10 AMP, 600 VOLT IGBT SMART POWER 3-PHASE MOTOR DRIVE HYBRID |
| MSK4354ED | 制造商:MSK 制造商全稱:M.S. Kennedy Corporation 功能描述:10 AMP, 600 VOLT IGBT SMART POWER 3-PHASE MOTOR DRIVE HYBRID |
| MSK4354ES | 制造商:MSK 制造商全稱:M.S. Kennedy Corporation 功能描述:10 AMP, 600 VOLT IGBT SMART POWER 3-PHASE MOTOR DRIVE HYBRID |
| MSK4354EU | 制造商:MSK 制造商全稱:M.S. Kennedy Corporation 功能描述:10 AMP, 600 VOLT IGBT SMART POWER 3-PHASE MOTOR DRIVE HYBRID |
| MSK4354HD | 制造商:MSK 制造商全稱:M.S. Kennedy Corporation 功能描述:10 AMP, 600 VOLT IGBT SMART POWER 3-PHASE MOTOR DRIVE HYBRID |
發布緊急采購，3分鐘左右您將得到回復。