參數資料
型號： MPZ2012S101A
廠商： Texas Instruments, Inc.
英文描述： 2.7-W CONSTANT OUTPUT POWER CLASS-D AUDIO AMPLIFIER WITH INTEGRATED BOOST CONVERTER
中文描述： 2.7鎢恒定輸出功率D類音頻放大器，具有集成升壓轉換器
文件頁數： 5/28頁
文件大小： 753K
代理商： MPZ2012S101A
www.ti.com
APPLICATION INFORMATION
FULLY DIFFERENTIAL AMPLIFIER
Advantages of Fully Differential Amplifiers
BOOST CONVERTER
Boost Terms
TPA2013D1
SLOS520 – AUGUST 2007
The TPA2013D1 is a fully differential amplifier with differential inputs and outputs. The fully differential amplifier
consists of a differential amplifier with common-mode feedback. The differential amplifier ensures that the
amplifier outputs a differential voltage on the output that is equal to the differential input times the gain. The
common-mode feedback ensures that the common-mode voltage at the output is biased around VCC/2 regardless
of the common-mode voltage at the input. The fully differential TPA2013D1 can still be used with a single-ended
input; however, the TPA2013D1 should be used with differential inputs when in a noisy environment, like a
wireless handset, to ensure maximum noise rejection.
Input-coupling capacitors not required:
–
The fully differential amplifier allows the inputs to be biased at voltage other than mid-supply. The inputs of
the TPA2013D1 can be biased anywhere within the common mode input voltage range listed in the
Recommended Operating Conditions table. If the inputs are biased outside of that range, input-coupling
capacitors are required.
Midsupply bypass capacitor, C
(BYPASS), not required:
–
The fully differential amplifier does not require a bypass capacitor. Any shift in the midsupply affects both
positive and negative channels equally and cancels at the differential output.
Better RF-immunity:
–
GSM handsets save power by turning on and shutting off the RF transmitter at a rate of 217 Hz. The
transmitted signal is picked-up on input and output traces. The fully differential amplifier cancels the signal
better than the typical audio amplifier.
The TPA2013D1 consists of a boost converter and a Class-D amplifier. The boost converter takes a low supply
voltage, VDD, and increases it to a higher output voltage, VCC. VCC is the power supply for the Class-D amplifier.
The two main passive components necessary for the boost converter are the boost inductor and the boost
capacitor. The boost inductor stores current, and the boost capacitor stores charge. As the Class-D amplifier
depletes the charge in the boost capacitor, the boost inductor charges it back up with the stored current. The
cycle of charge/discharge occurs at a frequency of fboost.
The TPA2013D1 allows a range of VCC voltages, including setting VCC lower than VDD.
The following is a list of terms and definitions used in the boost equations found later in this document.
C
Minimum boost capacitance required for a given ripple voltage on VCC.
L
Boost inductor
fboost
Switching frequency of the boost converter.
ICC
Current pulled by the Class-D amplifier from the boost converter.
IL
Average current through the boost inductor.
R1 and R2
Resistors used to set the boost voltage.
VCC
Boost voltage. Generated by the boost converter. Voltage supply for the Class-D
amplifier.
VDD
Supply voltage to the IC.
ΔIL
Ripple current through the inductor.
ΔV
Ripple voltage on VCC due to capacitance.
Copyright 2007, Texas Instruments Incorporated
Submit Documentation Feedback
13
Product Folder Link(s): TPA2013D1
相關PDF資料
PDF描述
MQ172-3PA-11 3 CONTACT(S), FEMALE, TELECOM AND DATACOM CONNECTOR, SURFACE MOUNT, RECEPTACLE
MQ172X-4PA-11 4 CONTACT(S), FEMALE, TELECOM AND DATACOM CONNECTOR, SURFACE MOUNT, RECEPTACLE
MQFL-270-12D-Z-ES 2-OUTPUT 120 W DC-DC REG PWR SUPPLY MODULE
MR-50F+ RECTANGULAR CONNECTOR
MR-50FG+ RECTANGULAR CONNECTOR
相關代理商/技術參數
參數描述
MPZ2012S101AT 制造商:TDK Innoveta 功能描述:Ferrite Beads Multi-Layer Chip Bead 100Ohm 25% 100MHz 4A 0805 T/R
MPZ2012S101AT000 制造商:TDK 功能描述:
MPZ2012S101ATD25 制造商:TDK 功能描述:FERRITE CHIP BEADS - Tape and Reel
MPZ2012S102A 功能描述:電磁干擾濾波珠子、扼流圈和陣列 0805 1000ohms 100MHz Rdc 0.15ohms 1.5A RoHS:否 制造商:AVX 阻抗: 最大直流電流:35 mA 最大直流電阻: 容差: 端接類型:SMD/SMT 電壓額定值:25 V 工作溫度范圍:- 25 C to + 85 C 封裝 / 箱體:0603 (1608 metric)
MPZ2012S102AT 制造商:TDK 功能描述:Ferrite Beads Multi-Layer Chip Bead 1KOhm 25% 100MHz 1.5A 0805 制造商:TDK 功能描述:MPZ Series 1 kO 25 % 100 MHz 1.5 A 0805 Multi-Layer Chip Ferrite Bead 制造商:TDK 功能描述:MPZ Series 1 kO ?25 % 100 MHz 1.5 A 0805 Multi-Layer Chip Ferrite Bead
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*