- 您現在的位置：買賣IC網 > PDF目錄359200 > MPXM2010 (飛思卡爾半導體(中國)有限公司) 10kPa On-Chip Temperature Compensated & Calibrated Silicon Pressure Sensors(10kPa片內溫度補償和校準硅壓力傳感器) PDF資料下載
參數資料
| 型號： | MPXM2010 |
| 廠商： | 飛思卡爾半導體(中國)有限公司 |
| 英文描述： | 10kPa On-Chip Temperature Compensated & Calibrated Silicon Pressure Sensors(10kPa片內溫度補償和校準硅壓力傳感器) |
| 中文描述： | 10kPa片上溫度補償 |
| 文件頁數： | 1/8頁 |
| 文件大?。?/td> | 128K |
| 代理商： | MPXM2010 |
MPXM2010 SERIES
1
Sensor Device Data
Freescale Semiconductor
10 kPa
On-Chip Temperature
Compensated & Calibrated
Silicon Pressure Sensors
The MPXM2010 device is a silicon piezoresistive pressure sensors providing a highly
accurate and linear voltage output — directly proportional to the applied pressure. The
sensor is a single, monolithic silicon diaphragm with the strain gauge and a thin--film
resistor network integrated on--chip. Thechip islaser trimmedfor precisespan andoffset
calibration and temperature compensation.
Features
Temperature Compensated Over 0
°
C to +85
°
C
Available in Easy--to--Use Tape & Reel
Ratiometric to Supply Voltage
Gauge Ported & Non Ported Options
Application Examples
Respiratory Diagnostics
Air Movement Control
Controllers
Pressure Switching
Figure 1 shows a block diagram of the internal circuitry on the stand--alone pressure
sensor chip.
V
S
Figure 1. Temperature Compensated Pressure Sensor Schematic
3
SENSING
ELEMENT
THIN FILM
TEMPERATURE
COMPENSATION
AND
CALIBRATION
CIRCUITRY
2
4
V
out+
V
out--
1
GND
VOLTAGE OUTPUT versus APPLIED DIFFERENTIAL PRESSURE
The differential voltage output of the sensor is directly proportional to the differential
pressure applied.
The output voltage of the differential or gauge sensor increases with increasing
pressure applied to the pressure side (P1) relative to the vacuum side (P2). Similarly,
output voltage increases as increasing vacuum is applied to the vacuum side (P2)
relative to the pressure side (P1).
Preferred
devices are Freescale Semiconductor recommended choices for future use and best overall value.
MPXM2010
Rev. 2, 10/2004
Freescale Semiconductor
Technical Data
Freescale Semiconductor, Inc., 2004. All rights reserved.
MPXM2010
SERIES
0 to 10 kPa (0 to 1.45 psi)
25 mV FULL SCALE SPAN
(TYPICAL)
PIN NUMBER
Gnd
1
2
+V
out
3
4
V
S
--V
out
Freescale Semiconductor Preferred Device
MPXM2010D/DT1
CASE 1320
MPXM2010GS/GST1
CASE 1320A
SCALE 1:1
SCALE 1:1
MPAK PACKAGE
相關PDF資料 |
PDF描述 |
|---|---|
| MPXM2051G | 50 kPa On-Chip Temperature Compensated and Calibrated Silicon Pressure Sensors |
| MPXM2053D | 50kPa On-Chip Temperature Compensated & Calibrated Silicon Pressure Sensors(50kPa片內溫度補償和校準硅壓力傳感器) |
| MPXM2053GST1 | 50 kPa On-Chip Temperature Compensated & Calibrated Silicon Pressure Sensors |
| MPXM2053D | Sensor |
| MPXM2053DT1 | Sensor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MPXM2010D | 功能描述:板上安裝壓力/力傳感器 M-PAK RoHS:否 制造商:Honeywell 工作壓力:0 bar to 4 bar 壓力類型:Gage 準確性:+ / - 0.25 % 輸出類型:Digital 安裝風格:Through Hole 工作電源電壓:5 V 封裝 / 箱體:SIP 端口類型:Dual Radial Barbed, Same sides |
| MPXM2010DT1 | 功能描述:板上安裝壓力/力傳感器 M-PAK RoHS:否 制造商:Honeywell 工作壓力:0 bar to 4 bar 壓力類型:Gage 準確性:+ / - 0.25 % 輸出類型:Digital 安裝風格:Through Hole 工作電源電壓:5 V 封裝 / 箱體:SIP 端口類型:Dual Radial Barbed, Same sides |
| MPXM2010GS | 功能描述:板上安裝壓力/力傳感器 M-PAK PORTED RoHS:否 制造商:Honeywell 工作壓力:0 bar to 4 bar 壓力類型:Gage 準確性:+ / - 0.25 % 輸出類型:Digital 安裝風格:Through Hole 工作電源電壓:5 V 封裝 / 箱體:SIP 端口類型:Dual Radial Barbed, Same sides |
| MPXM2010GS | 制造商:Freescale Semiconductor 功能描述:Pressure Sensors IC |
| MPXM2010GST1 | 功能描述:板上安裝壓力/力傳感器 M-PAK PORTED RoHS:否 制造商:Honeywell 工作壓力:0 bar to 4 bar 壓力類型:Gage 準確性:+ / - 0.25 % 輸出類型:Digital 安裝風格:Through Hole 工作電源電壓:5 V 封裝 / 箱體:SIP 端口類型:Dual Radial Barbed, Same sides |
發布緊急采購，3分鐘左右您將得到回復。