- 您現在的位置：買賣IC網 > PDF目錄45375 > MPM21CUB600B (INTEL CORP) 32-BIT, 600 MHz, MICROPROCESSOR, XMA PDF資料下載
參數資料
| 型號： | MPM21CUB600B |
| 廠商： | INTEL CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 32-BIT, 600 MHz, MICROPROCESSOR, XMA |
| 封裝： | MMC-2 |
| 文件頁數： | 33/64頁 |
| 文件大?。?/td> | 826K |
| 代理商： | MPM21CUB600B |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁當前第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁
Celeron
Processor Mobile Module MMC-2
at 700 MHz, 650 MHz, 600 MHz, 550 MHz, 500 MHz, and 450 MHz
243357-005
Datasheet
33
The following list includes additional specifications and clarifications of the power sequence
timing and Figure 6 provides an illustration.
1. The VR_ON signal may only be asserted to a logical high by a digital signal after V_DC
≥
7.5V, V_5
≥ 4.5V, and V_3 ≥ 3.0V.
2. The Rise Time and Fall Time of VR_ON must be less than or equal to 1.0
S.
3. VR_ON has its VIL max = +0.4V and VIH min = +3.0V.
4. The VR_PWRGD will get asserted to logic high (3.3V) after V_CORE is stabilized and V_DC
reaches 7.5V. This signal should not and can not be pulled up by the system electronics.
5. In the power-on process, Intel recommends to raise the higher voltage power plane first
(V_DC), followed by the lower power planes (V_5, V_3), and finally assert VR_ON after
above voltage levels are met on all rails. The power-off process should be the reverse process,
i.e. VR_ON gets deasserted, followed by the lower power planes, and finally the higher power
planes.
Table 23. Voltage Signal Definitions and Sequences
Signal
Source
Definition and Sequences
V_DC
System Electronics
V_DC is required to be between 7.5V and 21.0V DC and is driven by
the system electronics’ power supply. V_DC powers the mobile
module DC-to-DC converter for the processor core and I/O voltages.
The mobile module cannot be hot inserted or removed while
V_DC is powered on.
V_5
System Electronics
V_5 is supplied by the system electronics for the voltage regulator.
V_3
System Electronics
V_3 is supplied by the system electronics for the 443BX and powers
the mobile module’s linear regulators for generating the V_CLK and
V_CPUPU voltage rails. V_3 stays on during suspend.
V_3S
System Electronics
V_3S is supplied by the system electronics and is shut off during
suspend.
VR_ON
System Electronics
VR_ON is a 3.3-V signal that enables the voltage regulator circuit.
When driven active high the voltage regulator circuit is activated. The
signal driving VR_ON should be a digital signal with a rise/fall time of
less than or equal to 1.0
S. (V
IL,max=0.4V, VIH,min =3.0V.)
V_CORE
Module
A result of VR_ON being asserted, V_CORE is an output of the DC-
DC regulator on the mobile module and is driven to the core voltage of
the processor.
VR_PWRGD
Module
Upon sampling the voltage level of V_CORE (minus tolerances for
ripple), VR_PWRGD is driven active high. If VR_PWRGD is not
sampled active within 1 second of the assertion of VR_ON, then the
system electronics should deassert VR_ON. After V_CORE is
stabilized, VR_PWRGD will assert to logic high (3.3V). This signal
must not be pulled up by the system electronics. VR_PWRGD should
be "logically ANDed" with V_3S to generate the PIIX4E/M input signal,
PWROK. The system electronics should monitor VR_PWRGD to verify
it is asserted high prior to the active high assertion of PIIX4E/M
PWROK.
V_CPUPU
Module
V_CPUPU is 1.5V. The system electronics uses this voltage to power
the PIIX4E/M-to-processor interface circuitry.
V_CLK
Module
V_CLK is 2.5V. The system electronics uses this voltage to power the
HCLK[0:1] drivers for the processor clock.
相關PDF資料 |
PDF描述 |
|---|---|
| MPM21CUB450A | 32-BIT, 450 MHz, MICROPROCESSOR, XMA |
| MPM22CGA850B | 32-BIT, 850 MHz, MICROPROCESSOR, XMA |
| MPM22CGC600A | 32-BIT, 600 MHz, MICROPROCESSOR, XMA |
| MPM22CGA800A | 32-BIT, 800 MHz, MICROPROCESSOR, XMA |
| MPM22PDA266B | 32-BIT, 266 MHz, MICROPROCESSOR, XMA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MPM-25S | 制造商:MPD 制造商全稱:MicroPower Direct, LLC 功能描述:Universal Input, 25W Miniature, PC Mount AC/DC Power Supplies |
| MPM-25S-05 | 制造商:MPD 制造商全稱:MicroPower Direct, LLC 功能描述:Universal Input, 25W Miniature, PC Mount AC/DC Power Supplies |
| MPM-25S-12 | 制造商:MPD 制造商全稱:MicroPower Direct, LLC 功能描述:Universal Input, 25W Miniature, PC Mount AC/DC Power Supplies |
| MPM-25S-15 | 制造商:MPD 制造商全稱:MicroPower Direct, LLC 功能描述:Universal Input, 25W Miniature, PC Mount AC/DC Power Supplies |
| MPM-25S-24 | 制造商:MPD 制造商全稱:MicroPower Direct, LLC 功能描述:Universal Input, 25W Miniature, PC Mount AC/DC Power Supplies |
發布緊急采購，3分鐘左右您將得到回復。