CLKOUT period jitter, measured at" />
參數資料
型號： MPC5554EVB
廠商： Freescale Semiconductor
文件頁數： 14/58頁
文件大?。?/td> 0K
描述： BOARD EVALUATION MPC5554
標準包裝： 1
類型： 微控制器
適用于相關產品： MPC5554
所含物品： 評估板和演示軟件
相關產品： MPC5554MZP132R2-ND - IC MCU 2M FLASH 132MHZ 416-PBGA
MPC5554MZP132-ND - IC MCU 2M FLASH 132MHZ 416-PBGA
MPC5554MVR132R2-ND - IC MCU 2M FLASH 132MHZ 416-PBGA
MPC5554MVR132-ND - IC MCU 2M FLASH 132MHZ 416-PBGA
MPC5554AZP132-ND - IC MPU 2M FLASH 132MHZ 416-PBGA
Electrical Characteristics
MPC5554 Microcontroller Data Sheet, Rev. 4
Freescale Semiconductor
21
19
CLKOUT period jitter, measured at fSYS max:
13, 14
Peak-to-peak jitter (clock edge to clock edge)
Long term jitter (averaged over a 2 ms interval)
CJITTER
—
5.0
0.01
%
fCLKOUT
20
Frequency modulation range limit 15
(do not exceed fsys maximum)
CMOD
0.8
2.4
%fSYS
21
ICO frequency
fico = [fref_crystal (MFD + 4)] (PREDIV + 1)
16
fico = [fref_ext (MFD + 4) ] (PREDIV + 1)
fico
48
fMAX
MHz
22
Predivider output frequency (to PLL)
fPREDIV
420 17
MHz
1 Nominal crystal and external reference values are worst-case not more than 1%. The device operates correctly if the frequency
remains within ± 5% of the specification limit. This tolerance range allows for a slight frequency drift of the crystals over time.
The designer must thoroughly understand the drift margin of the source clock.
2 All internal registers retain data at 0 Hz.
3 Up to the maximum frequency rating of the device (refer to Table 1).
4 Loss of reference frequency is defined as the reference frequency detected internally, which transitions the PLL into self-clocked
mode.
5 The PLL operates at self-clocked mode (SCM) frequency when the reference frequency falls below f
LOR. SCM frequency is
measured on the CLKOUT ball with the divider set to divide-by-two of the system clock.
NOTE: In SCM, the MFD and PREDIV have no effect and the RFD is bypassed.
6 Use the EXTAL input high voltage parameter when using the FlexCAN oscillator in crystal mode (no quartz crystals or
resonators). (Vextal – Vxtal) must be 400 mV for the oscillator’s comparator to produce the output clock.
7 Use the EXTAL input low voltage parameter when using the FlexCAN oscillator in crystal mode (no quartz crystals or
resonators). (Vxtal –Vextal) must be 400 mV for the oscillator’s comparator to produce the output clock.
8 I
xtal is the oscillator bias current out of the XTAL pin with both EXTAL and XTAL pins grounded.
9 C
PCB_EXTAL and CPCB_XTAL are the measured PCB stray capacitances on EXTAL and XTAL, respectively.
10 This specification applies to the period required for the PLL to relock after changing the MFD frequency control bits in the
synthesizer control register (SYNCR). From power up with crystal oscillator reference, the lock time also includes the crystal
startup time.
11 PLL is operating in 1:1 PLL mode.
12 V
DDE = 3.0–3.6 V.
13 Jitter is the average deviation from the programmed frequency measured over the specified interval at maximum f
sys.
Measurements are made with the device powered by filtered supplies and clocked by a stable external clock signal. Noise
injected into the PLL circuitry via VDDSYN and VSSSYN and variation in crystal oscillator frequency increase the jitter percentage
for a given interval. CLKOUT divider is set to divide-by-two.
14 Values are with frequency modulation disabled. If frequency modulation is enabled, jitter is the sum of (jitter + Cmod).
15 Modulation depth selected must not result in f
sys value greater than the fsys maximum specified value.
16 f
sys = fico (2
RFD).
17 Maximum value for dual controller (1:1) mode is (f
MAX 2) with the predivider set to 1 (FMPLL_SYNCR[PREDIV] = 0b001).
Table 12. FMPLL Electrical Specifications (continued)
(VDDSYN = 3.0–3.6 V; VSS = VSSSYN = 0.0 V; TA = TL to TH)
Spec
Characteristic
Symbol
Minimum
Maximum
Unit
相關PDF資料
PDF描述
MAX6440UTMRRD3+T IC BATTERY MON SNGL SOT23-6
MAX6440UTLSYD3+T IC BATTERY MON SNGL SOT23-6
MPC5553EVBGHS KIT EVAL GREEN HILLS SOFTWARE
MPC5553EVB KIT EVAL MPC5553MZP132
MAX6440UTLSTD7+T IC BATTERY MON SNGL SOT23-6
相關代理商/技術參數
參數描述
MPC5554EVBE 功能描述:開發板和工具包 - 其他處理器 MPC5554 CUSTOMER Qorivva RoHS:否 制造商:Freescale Semiconductor 產品:Development Systems 工具用于評估:P3041 核心:e500mc 接口類型:I2C, SPI, USB 工作電源電壓:
MPC5554EVBE 制造商:Freescale Semiconductor 功能描述:MPC5554 CUSTOMER DEMO BD
MPC5554EVBGHS 功能描述:開發軟件 GREEN HILLS SW Qorivva RoHS:否 制造商:Atollic Inc. 產品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors
MPC5554EVBISYS 功能描述:開發軟件 ISYSTEMS CONTENT Qorivva RoHS:否 制造商:Atollic Inc. 產品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors
MPC5554FS 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Qorivva MPC5554 Family
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*