參數資料
型號: MP1593DN
廠商: MONOLITHIC POWER SYSTEMS INC
元件分類: 穩壓器
英文描述: 3A, 28V, 385KHz Step-Down Converter
中文描述: 7.6 A SWITCHING REGULATOR, 435 kHz SWITCHING FREQ-MAX, PDSO8
封裝: MS-012BA, SOIC-8
文件頁數: 4/11頁
文件大?。?/td> 326K
代理商: MP1593DN
MP1593 – 3A, 28V, 385KHz STEP-DOWN CONVERTER
MP1593 Rev. 1.9
9/14/2006
www.MonolithicPower.com
4
MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.
2006 MPS. All Rights Reserved.
TYPICAL PERFORMANCE CHARACTERISTICS
(continued)
Refer to Typical Application Schematic on Page 1
E
100
95
90
85
80
75
70
65
60
55
50
LOAD CURRENT (mA)
Efficiency vs
Load Current
0
500 1000 1500 2000 2500 3000 3500
V
IN
= 9V
V
IN
= 12V
V
IN
= 24V
100
95
90
85
80
75
70
65
60
55
50
E
0
500 1000 1500 2000 2500 3000 3500
LOAD CURRENT (mA)
Efficiency vs
Load Current
V
IN
= 5V
V
IN
= 24V
V
IN
= 12V
I
L
1A/Div.
V
OUT
10mV/Div.
V
SW
10V/Div.
V
IN
100mV/Div.
Switching
Waveforms
PIN FUNCTIONS
Pin # Name Description
1
BS
High-Side Gate Drive Boost Input. BS supplies the drive for the high-side N-Channel MOSFET
switch. Connect a 10nF or greater capacitor from SW to BS to power the high-side switch.
Power Input. IN supplies power to the IC. Drive IN with a 4.75V to 28V power source. Bypass IN
to GND with a suitably large capacitor to eliminate noise on the input to the IC. See
Input
Capacitor.
Power Switching Output. SW is the switching node that supplies power to the output. Connect
the output LC filter from SW to the output load. Note that a capacitor is required from SW to BS
to power the high-side switch.
GND Ground. Note: Connect the exposed pad to Pin 4.
Feedback Input. FB senses the output voltage and regulates it. Drive FB with a resistive voltage
divider from the output voltage to ground. The feedback threshold is 1.222V. See
Setting the
Output Voltage.
Compensation Node. COMP is used to compensate the regulation control loop. Connect a series
RC network from COMP to GND. In some cases, an additional capacitor from COMP to GND is
required. See
Compensation.
Enable Input. EN is a digital input that turns the regulator on or off. Drive EN high to turn on the
regulator; low to turn it off. An Under-Voltage Lockout (UVLO) function can be implemented by
the addition of a resistor divider from V
IN
to GND. For complete low current shutdown the EN pin
voltage needs to be less than 0.7V. For automatic startup leave EN disconnected.
Soft-Start Control Input. SS controls the soft-start period. Connect a capacitor from SS to GND
to set the soft-start period. A 0.1
μ
F capacitor sets the soft-start period to 10ms. To disable the
soft-start feature, leave SS disconnected.
2
IN
3
SW
4
5
FB
6
COMP
7
EN
8
SS
相關PDF資料
PDF描述
MP2000_06 Low Input Voltage 150mA Linear Regulator
MP2000DJ Low Input Voltage 150mA Linear Regulator Evaluation Board
MP2000 Low Input Voltage 150mA Linear Regulator
MP2000DJ-1.0 Low Input Voltage 150mA Linear Regulator
MP2000DJ-ADJ Low Input Voltage 150mA Linear Regulator
相關代理商/技術參數
參數描述
MP1593DN-LF 功能描述:開關變換器、穩壓器與控制器 3A 28V 385kHz Step-Down Converter RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel
MP1593DN-LF-Z 功能描述:開關變換器、穩壓器與控制器 3A 28V 385kHz Step-Down Converter RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel
MP15A0.5 功能描述:變阻器 50watt .5ohm RoHS:否 制造商:Ohmite 類型:Wirewound 功率額定值:25 W 電阻:25 Ohms 電壓額定值:500 V 容差:10 % 端接類型:Solder Lug 轉數:300 錐度:Linear
MP15A1 功能描述:變阻器 50watt 1ohm RoHS:否 制造商:Ohmite 類型:Wirewound 功率額定值:25 W 電阻:25 Ohms 電壓額定值:500 V 容差:10 % 端接類型:Solder Lug 轉數:300 錐度:Linear
MP15A1000 功能描述:變阻器 50watt 1K RoHS:否 制造商:Ohmite 類型:Wirewound 功率額定值:25 W 電阻:25 Ohms 電壓額定值:500 V 容差:10 % 端接類型:Solder Lug 轉數:300 錐度:Linear