- 您現在的位置：買賣IC網 > PDF目錄385617 > MM1177A (MITSUMI ELECTRIC) Charge and discharge control for coin-type lithium batteries and manganese dioxide lithium batteries PDF資料下載
參數資料
| 型號： | MM1177A |
| 廠商： | MITSUMI ELECTRIC |
| 英文描述： | Charge and discharge control for coin-type lithium batteries and manganese dioxide lithium batteries |
| 中文描述： | 充放電控制的硬幣式鋰電池，鋰二氧化錳電池 |
| 文件頁數： | 3/3頁 |
| 文件大?。?/td> | 78K |
| 代理商： | MM1177A |
MITSUMI
Charge and discharge control for coin-type lithium batteries and manganese dioxide lithium batteries MM1177
Operation Outline
The constant current, constant voltage charging control charges at a constant current of 4.5mA, until battery
capacity reaches 0%~90%. It then switches to constant voltage control and sets the charge current to "0"
when 100% charged. Output impedance is set at about 50
so charge current gradually drops and eventually
reaches 0mA. The charging current maximum value is set by battery capacitance. Therefore, When the value
falls below 4.5mA, insert a resistor (R) in series in order to lower charging current value.
The discharging control has a built-in switching circuit between the battery and output. After switching off
during excess discharge, all circuit operations are prohibited. Operation reset is achieved by resuming
charging. In the event of an output short, output current is limited (about 5mA~10mA) by the internal switch
function. This reduces the risk of battery heat emission caused by an output short. Also, the switching circuit
and the battery voltage monitoring switch are on different systems. This means that the discharge output
(OUT1) will not prohibit discharge even during a short, and noise from the output load section will not affect
the detection circuit (OUT2).
Application Example
Application Example 1
Application Example 2
Charging Characteristics
Application
example 1
3.275V
Battery voltage
Vanadium lithium battery (MM1177A)
C
Application
example 1
Application example 2
3V
Battery voltage
Manganese dioxide lithium battery (MM1177B)
2.8V
Charging current
(MAX value)
C
1. Charging current over 4mA
2. Charging current under 4mA
Battery voltage-Charging current characteristics
Battery voltage-Charging current characteristics
相關PDF資料 |
PDF描述 |
|---|---|
| MM1177AF | Charge and discharge control for coin-type lithium batteries and manganese dioxide lithium batteries |
| MM1177B | Charge and discharge control for coin-type lithium batteries and manganese dioxide lithium batteries |
| MM1177BF | Charge and discharge control for coin-type lithium batteries and manganese dioxide lithium batteries |
| MM1177 | Charge and discharge control for coin-type lithium batteries and manganese dioxide lithium batteries |
| MM118-06 | 3 PHASE N-CHANNEL INSULATED GATE BIPOLAR TRANSISTOR IGBT BRIDGE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MM1177AF | 制造商:MITSUMI 制造商全稱:Mitsumi Electronics, Corp. 功能描述:Charge and discharge control for coin-type lithium batteries and manganese dioxide lithium batteries |
| MM1177B | 制造商:MITSUMI 制造商全稱:Mitsumi Electronics, Corp. 功能描述:Charge and discharge control for coin-type lithium batteries and manganese dioxide lithium batteries |
| MM1177BF | 制造商:MITSUMI 制造商全稱:Mitsumi Electronics, Corp. 功能描述:Charge and discharge control for coin-type lithium batteries and manganese dioxide lithium batteries |
| MM1180 | 制造商:MITSUMI 制造商全稱:Mitsumi Electronics, Corp. 功能描述:Low-Noise, Low-Satulation Three-Pin Regulator |
| MM118-06 | 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:3 PHASE N-CHANNEL INSULATED GATE BIPOLAR TRANSISTOR IGBT BRIDGE |
發布緊急采購，3分鐘左右您將得到回復。