參數(shù)資料
    型號: MKT075102F101T
    廠商: Sharma Electro Components Inc.
    英文描述: FILM CAPACITORS
    中文描述: 薄膜電容器
    文件頁數(shù): 3/29頁
    文件大?。?/td> 1151K
    代理商: MKT075102F101T
    ELECTRICAL - BASIC PARAMETERS
    1.1 RATED CAPACITANCE
    The nominal or rated value of capacitance is measured at 25 °C in an measuring bridge with 1K Hz
    source, free of harmonics. Please refer to relevant series for the range of capacitance value covered.
    Capacitance is frequency and temperature dependent. The variation pattern of capacitance with
    temperature and frequency is explained in sections 2.1 and 2.2.
    1.2 CAPACITANCE TOLERANCE
    The permitted variation of actual value from the nominal value is termed the tolerance. The tolerance
    is expressed in percentage. The standard tolerances for plastic film capacitors are ±5% (J), ±10% (K)
    and ±20% (M).
    1.3 RATED VOLTAGE
    The voltage at which the capacitor can operate continuously up to a temperature of 85 °C (unless
    otherwise specified) is the rated voltage. As this is a critical parameter for choosing a capacitor, the
    case sizes are listed in a matrix of capacitance value and rated voltage.
    1.4 CATEGORY VOLTAGE
    The maximum voltage that may be applied continuously over the temperature range is termed the
    category voltage. This is same as the rated voltage up to 85 °C unless otherwise specified in the
    climactic category of the product. Above 85 °C a derating has to be applied depending upon the
    dielectric.
    1.5 OPERATING TEMPERATURE
    This is the temperature range with in which the capacitor can function as specified in the climactic
    category. Please refer to relevant sections for derating above the temperature at which the full rated
    voltage can be applied.
    1.6 DISSIPATION FACTOR
    This is the measurement of tangent of loss angle (tan d) and is expressed as a percentage.
    Measurement of dissipation factor is carried out at 1 K Hz. or 10 K Hz. as specified in the data sheet
    of the relevant series at 25 °C. Dissipation factor is temperature and frequency dependent. The
    nature of variation of dissipation factor with temperature and frequency for different dielectric are
    explained in Figures 2.3A to 2.3C and 2.4A to 2.4C.
    1.7 INSULATION RESISTANCE
    Insulation Resistance is the electrical resistance offered by the capacitor. The Insulation Resistance
    is measured directly in Mega Ohms where as for higher capacitance values it is expressed in seconds
    as the product of M Ohm and μF.
    1.8 PULSE RISE TIME
    The pulse rise time or dv/dt rating is the capability of the capacitor to handle rapid changes in voltage
    or pulse. This is expressed in terms of Volts per μseconds. The dv/ dt rating of a capacitor depends
    upon the dielectric as well as the design and construction of the capacitors. The dv/dt values of
    different types of capacitors are listed in the corresponding data sheets of the capacitors.
    ELECTRICAL - EFFECTS AND RELATIONS
    2.1 TEMPERATURE DEPENDENCE OF CAPACITANCE
    Capacitance of plastic film capacitors vary with temperature. However the pattern of variation is
    different for different plastic film dielectrics such as Polystyrene, Polyester and Polypropylene. The
    The variation patterns for these dielectrics are shown in figure 2.1A, 2.1B and 2.1C. The rate of
    change of capacitance with temperature is termed the Temperature Coefficient. The nominal values
    of temperature coefficient for different dielectrics are shown below.
    2.2 FREQUENCY DEPENDENCE OF CAPACITANCE
    Capacitance reduces with increase in frequency. The
    variation pattern for different dielectrics are shown in
    figure 2.2A, 2.2B and 2.2C.
    2.3 TEMPERATURE DEPENDENCE OF
    DISSIPATION FACTOR
    The dissipation factor varies with temperature. Each
    dielectric follows a unique variation pattern. The variation
    pattern for different dielectrics are shown in figure 2.3A,
    2.3B and 2.3C.
    PERFORMANCE CHARACTERISTICS
    Figure 2.1B
    Figure 2.1C
    Figure 2.2A
    Figure 2.2C
    Figure 2.2B
    Polyester
    Capacitance Change Vs. Temperature
    Polypropylene
    Capacitance Change Vs. Temperature
    Polystyrene
    Capacitance Change Vs. Frequency
    Polyester
    Capacitance Change Vs. Frequency
    Polypropylene
    Capacitance Change Vs. Frequency
    DIELECTRICS
    POLYSTYRENE
    POLYESTER
    POLYPROPYLENE
    TEMPERATURE
    COEFFICIENT
    -150 ppm
    +400 ppm
    -200 ppm
    Figure 2.1A
    Polystyrene
    Capacitance Change Vs. Temperature
    Sharma Film Capacitors
    相關PDF資料
    PDF描述
    MKT075102F251 FILM CAPACITORS
    MKT075102F251A FILM CAPACITORS
    MKT075102F251T FILM CAPACITORS
    MKT075102F500 FILM CAPACITORS
    MKT075102M101T FILM CAPACITORS
    相關代理商/技術參數(shù)
    參數(shù)描述
    MKT075102F251 制造商:SHARMA 制造商全稱:Sharma Electro Components,Inc 功能描述:FILM CAPACITORS
    MKT075102F251A 制造商:SHARMA 制造商全稱:Sharma Electro Components,Inc 功能描述:FILM CAPACITORS
    MKT075102F251T 制造商:SHARMA 制造商全稱:Sharma Electro Components,Inc 功能描述:FILM CAPACITORS
    MKT075102F500 制造商:SHARMA 制造商全稱:Sharma Electro Components,Inc 功能描述:FILM CAPACITORS
    MKT075102F500A 制造商:SHARMA 制造商全稱:Sharma Electro Components,Inc 功能描述:FILM CAPACITORS