- 您現在的位置：買賣IC網 > PDF目錄45332 > MK60X256VLQ100 (FREESCALE SEMICONDUCTOR INC) FLASH, 100 MHz, RISC MICROCONTROLLER, PQFP144 PDF資料下載
參數資料
| 型號： | MK60X256VLQ100 |
| 廠商： | FREESCALE SEMICONDUCTOR INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | FLASH, 100 MHz, RISC MICROCONTROLLER, PQFP144 |
| 封裝： | 20 X 20 MM, LQFP-144 |
| 文件頁數： | 21/76頁 |
| 文件大?。?/td> | 1862K |
| 代理商： | MK60X256VLQ100 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁
Table 13. MCG specifications (continued)
Symbol
Description
Min.
Typ.
Max.
Unit
Notes
Dlock
Lock entry frequency tolerance
± 1.49
—
± 2.98
%
Dunl
Lock exit frequency tolerance
± 4.47
—
± 5.97
%
tpll_lock
Lock detector detection time
—
0.15 +
1075(1/
fpll_ref)
ms
1. This parameter is measured with the internal reference (slow clock) being used as a reference to the FLL (FEI clock
mode).
2. These typical values listed are with the slow internal reference clock (FEI) using factory trim and DMX32=0.
3. The resulting system clock frequencies should not exceed their maximum specified values. The DCO frequency deviation
(
Δfdco_t) over voltage and temperature should be considered.
4. These typical values listed are with the slow internal reference clock (FEI) using factory trim and DMX32=1.
5. The resulting clock frequency must not exceed the maximum specified clock frequency of the device.
6. This specification was obtained at TBD frequency.
7. This specification applies to any time the FLL reference source or reference divider is changed, trim value is changed,
DMX32 bit is changed, DRS bits are changed, or changing from FLL disabled (BLPE, BLPI) to FLL enabled (FEI, FEE,
FBE, FBI). If a crystal/resonator is being used as the reference, this specification assumes it is already running.
8. Excludes any oscillator currents that are also consuming power while PLL is in operation.
9. This specification was obtained using a Freescale developed PCB. PLL jitter is dependent on the noise characteristics of
each PCB and results will vary.
10. This specification was obtained at internal frequency of TBD.
11. This specification applies to any time the PLL VCO divider or reference divider is changed, or changing from PLL disabled
(BLPE, BLPI) to PLL enabled (PBE, PEE). If a crystal/resonator is being used as the reference, this specification assumes
it is already running.
6.3.2 Oscillator electrical specifications
This section provides the electrical characteristics of the module.
6.3.2.1 Oscillator DC electrical specifications
Table 14. Oscillator DC electrical specifications
Symbol
Description
Min.
Typ.
Max.
Unit
Notes
VDD
Supply voltage
1.71
—
3.6
V
IDDOSC
Supply current — low-power mode (HGO=0)
32 kHz
4 MHz
8 MHz
16 MHz
24 MHz
32 MHz
—
500
200
300
700
1.2
1.5
—
nA
μA
mA
Table continues on the next page...
Peripheral operating requirements and behaviors
K60 Sub-Family Data Sheet Data Sheet, Rev. 4, 3/2011.
28
Preliminary
Freescale Semiconductor, Inc.
相關PDF資料 |
PDF描述 |
|---|---|
| MK60N512VMD100R | FLASH, 100 MHz, RISC MICROCONTROLLER, PBGA144 |
| MK60X256VLQ100R | FLASH, 100 MHz, RISC MICROCONTROLLER, PQFP144 |
| MK60N512VMC100 | FLASH, 100 MHz, RISC MICROCONTROLLER, PBGA121 |
| MK60N256VMC100 | FLASH, 100 MHz, RISC MICROCONTROLLER, PBGA121 |
| MK68901P05 | MULTIFUNCTION PERIPHERAL, CDIP48 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MK60X256VMD100 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Up to 100 MHz ARM Cortex-M4 core with DSP instructions delivering 1.25 Dhrystone MIPS per MHz |
| MK6116LN-15 | 制造商:STME 功能描述: 制造商:STMicroelectronics 功能描述: 制造商:STMicroelectronics 功能描述:2K X 8 STANDARD SRAM, 150 ns, PDIP24 |
| MK6116N-15 | 制造商:STMicroelectronics 功能描述: |
| MK-612S | 制造商:Silvertronic 功能描述:SET OF LEADS WITH CROC CL |
| MK6192F | 制造商:Ohmite Mfg Co 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。