- 您現在的位置：買賣IC網 > PDF目錄9018 > MK1725GILF (IDT, Integrated Device Technology Inc)IC CLK GEN SPRD SPECTRUM 16TSSOP PDF資料下載
參數資料
| 型號： | MK1725GILF |
| 廠商： | IDT, Integrated Device Technology Inc |
| 文件頁數： | 3/8頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC CLK GEN SPRD SPECTRUM 16TSSOP |
| 標準包裝： | 96 |
| 類型： | 時鐘發生器 |
| PLL： | 是 |
| 輸入： | 時鐘，晶體 |
| 輸出： | CMOS |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 1:4 |
| 差分 - 輸入:輸出： | 無/無 |
| 頻率 - 最大： | 136MHz |
| 除法器/乘法器： | 無/是 |
| 電源電壓： | 3.135 V ~ 3.465 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 16-TSSOP |
| 包裝： | 管件 |
MK1725
QUAD OUTPUT SPREAD SPECTRUM CLOCK GENERATOR
SSCG
IDT QUAD OUTPUT SPREAD SPECTRUM CLOCK GENERATOR
3
MK1725
REV G 033109
MK1725
QUAD OUTPUT SPREAD SPECTRUM CLOCK GENERATOR
SSCG
External Components
Decoupling Capacitor
As with any high performance mixed-signal IC, the MK1725
must be isolated from system power supply noise to perform
optimally.
A decoupling capacitor of 0.01F must be connected
between each VDD and the PCB ground plane.
Series Termination Resistor
Clock output traces over one inch should use series
termination. To series terminate a 50
trace (a commonly
used trace impedance), place a 33
resistor in series with
the clock line, as close to the clock output pin as possible.
The nominal impedance of the clock output is 20
.
Crystal Load Capacitors
The device crystal connections should include pads for
small capacitors from X1 to ground and from X2 to ground.
These capacitors are used to adjust the stray capacitance of
the board to match the nominally required crystal load
capacitance. Because load capacitance can only be
increased in this trimming process, it is important to keep
stray capacitance to a minimum by using very short PCB
traces (and no vias) between the crystal and device. Crystal
capacitors must be connected from each of the pins X1 and
X2 to ground.
The value (in pF) of these crystal caps should equal (CL
-6)*2. In this equation, CL= crystal load capacitance in pF.
Example: For a crystal with an 18 pF load capacitance, each
crystal capacitor would be 24 pF [(18-6) x 2 = 24].
PCB Layout Recommendations
For optimum device performance and lowest output phase
noise, the following guidelines should be observed.
1) The 0.01F decoupling capacitors should be mounted on
the component side of the board as close to the VDD pin as
possible. No vias should be used between the decoupling
capacitors and VDD pins. The PCB trace to VDD pins
should be kept as short as possible, as should the PCB
trace to the ground via.
2) The external crystal should be mounted just next to the
device with short traces. The X1 and X2 traces should not
be routed next to each other with minimum spaces, instead
they should be separated and away from other traces.
3) To minimize EMI the 33
series termination resistor (if
needed) should be placed close to the clock outputs.
4) An optimum layout is one with all components on the
same side of the board, minimizing vias through other signal
layers. Other signal traces should be routed away from the
MK1725. This includes signal traces just underneath the
device, or on layers adjacent to the ground plane layer used
by the device.
10
CLK4
Output
Clock 4 output. Frequency and spread amount are determined
by table above. Weak internal pull-down when tri-state.
11
GND
Power
Connect to ground.
12
VDD
Power
Connect to +3.3 V.
13
S2
Input
Select pin 2. Determines frequency and spread amount on
output clocks as per table above. Internal pull-down.
14
PDTS
Input
Power Down Tri-state. Powers down entire chip and tri-states
outputs when low. Internal pull-up resistor.
15
VDD
Power
Connect to +3.3V.
16
X2
Input
20 MHz to 34 MHz crystal input. Float for clock input.
Pin
Number
Pin
Name
Pin
Type
Pin Description
相關PDF資料 |
PDF描述 |
|---|---|
| MK1714-02RILF | IC CLK MULT SPRD SPECTRUM 20QSOP |
| VI-B31-MV-F2 | CONVERTER MOD DC/DC 12V 150W |
| MK2772-01SLFTR | IC CLK SRC VCXO/SET-TOP 20-SOIC |
| VI-23R-MW-F3 | CONVERTER MOD DC/DC 7.5V 100W |
| VI-2NY-MU-F4 | CONVERTER MOD DC/DC 3.3V 132W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MK1725GILFTR | 功能描述:時鐘發生器及支持產品 QUAD OUTPUT SPREAD SPECTRUM CLK GENER. RoHS:否 制造商:Silicon Labs 類型:Clock Generators 最大輸入頻率:14.318 MHz 最大輸出頻率:166 MHz 輸出端數量:16 占空比 - 最大:55 % 工作電源電壓:3.3 V 工作電源電流:1 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-56 |
| MK1725GLF | 功能描述:時鐘發生器及支持產品 QUAD OUTPUT SPREAD SPECTRUM CLK GENER. RoHS:否 制造商:Silicon Labs 類型:Clock Generators 最大輸入頻率:14.318 MHz 最大輸出頻率:166 MHz 輸出端數量:16 占空比 - 最大:55 % 工作電源電壓:3.3 V 工作電源電流:1 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-56 |
| MK1725GLFT | 制造商:ICS 制造商全稱:ICS 功能描述:Quad Output Spread Spectrum Clock Generator |
| MK1725GLFTR | 功能描述:IC CLK GEN SPRD SPECTRUM 16TSSOP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:2,000 系列:- 類型:PLL 時鐘發生器 PLL:帶旁路 輸入:LVCMOS，LVPECL 輸出:LVCMOS 電路數:1 比率 - 輸入:輸出:2:11 差分 - 輸入:輸出:是/無 頻率 - 最大:240MHz 除法器/乘法器:是/無 電源電壓:3.135 V ~ 3.465 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:32-LQFP 供應商設備封裝:32-TQFP（7x7） 包裝:帶卷 (TR) |
| MK1726-01 SLFTR | 制造商:Integrated Device Technology Inc 功能描述:PLL Clock Synthesizer Single 8-Pin SOIC T/R |
發布緊急采購，3分鐘左右您將得到回復。