- 您現在的位置：買賣IC網 > PDF目錄45327 > MJ80C32XXX-36/883 (TEMIC SEMICONDUCTORS) 8-BIT, 36 MHz, MICROCONTROLLER, QCC44 PDF資料下載
參數資料
| 型號： | MJ80C32XXX-36/883 |
| 廠商： | TEMIC SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, 36 MHz, MICROCONTROLLER, QCC44 |
| 封裝： | LCC-44 |
| 文件頁數： | 9/14頁 |
| 文件大?。?/td> | 1018K |
| 代理商： | MJ80C32XXX-36/883 |
4
8393BS-MCU Wireless-02/13
ATmega256/128/64RFR2
Spectrum Signal (DSSS) processing with spreading and despreading. The device is
fully compatible with IEEE802.15.4-2011/2006/2003 and ZigBee standards.
The ATmega256/128/64RFR2 provides the following features: 256K/128K/64K Bytes of
In-System Programmable (ISP) Flash with read-while-write capabilities, 8K/4K/2K Bytes
EEPROM, 32K/16K/8K Bytes SRAM, up to 35 general purpose I/O lines, 32 general
purpose working registers, Real Time Counter (RTC), 6 flexible Timer/Counters with
compare modes and PWM, a 32 bit Timer/Counter, 2 USART, a byte oriented 2-wire
Serial Interface, a 8 channel, 10 bit analog to digital converter (ADC) with an optional
differential input stage with programmable gain, programmable Watchdog Timer with
Internal Oscillator, a SPI serial port, IEEE std. 1149.1 compliant JTAG test interface,
also used for accessing the On-chip Debug system and programming and 6 software
selectable power saving modes.
The Idle mode stops the CPU while allowing the SRAM, Timer/Counters, SPI port, and
interrupt system to continue functioning. The Power-down mode saves the register
contents but freezes the Oscillator, disabling all other chip functions until the next
interrupt or hardware reset. In Power-save mode, the asynchronous timer continues to
run, allowing the user to maintain a timer base while the rest of the device is sleeping.
The ADC Noise Reduction mode stops the CPU and all I/O modules except
asynchronous timer and ADC, to minimize switching noise during ADC conversions. In
Standby mode, the RC oscillator is running while the rest of the device is sleeping. This
allows very fast start-up combined with low power consumption. In Extended Standby
mode, both the main RC oscillator and the asynchronous timer continue to run.
Typical supply current of the microcontroller with CPU clock set to 16MHz and the radio
transceiver for the most important states is shown in the Figure 3-2 below.
Figure 3-2 Radio transceiver and microcontroller (16MHz) supply current
16,6mA
4,7mA
4,1mA
250nA
18,6mA
0
5
10
15
20
Deep Sleep
SLEEP
TRX_OFF
RX_ON
BUSY_TX
Radio transceiver and microcontroller (16MHz) supply current
I(
D
E
V
D
,E
V
D
)
[m
A
]
1.8V
3.0V
3.6V
The transmit output power is set to maximum. If the radio transceiver is in SLEEP mode
the current is dissipated by the AVR microcontroller only.
In Deep Sleep mode all major digital blocks with no data retention requirements are
disconnected from main supply providing a very small leakage current. Watchdog timer,
MAC symbol counter and 32.768kHz oscillator can be configured to continue to run.
700nA
RPC enabled
□ 10.1mA
RPC disabled
相關PDF資料 |
PDF描述 |
|---|---|
| MK10DX256ZVLQ10 | 32-BIT, FLASH, 100 MHz, RISC MICROCONTROLLER, PQFP144 |
| MK10DX256ZVLQ10R | FLASH, 100 MHz, RISC MICROCONTROLLER, PQFP144 |
| MK10DX256ZVMD10R | FLASH, 100 MHz, RISC MICROCONTROLLER, PBGA144 |
| MK1418S | 24.576 MHz, OTHER CLOCK GENERATOR, PDSO8 |
| MK1491-06SLF | 49.152 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO28 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MJ8100 | 制造商:ASI 功能描述:8100 N11E4C |
| MJ8100R | 制造商:SEME-LAB 制造商全稱:Seme LAB 功能描述:Bipolar PNP Device in a Hermetically sealed TO39 |
| MJ-82-1 | 制造商:SPC Multicomp 功能描述:SOCKET PCB DC POWER 制造商:SPC Multicomp 功能描述:SOCKET, PCB, DC POWER 制造商:SPC Multicomp 功能描述:SOCKET, PCB, DC POWER; Gender:Receptacle; Connector Mounting:PCB; Contact Termination:Through Hole Vertical; Connector Mounting Orientation:PCB; Connector Type:Standard Power Entry ;RoHS Compliant: Yes |
| MJ8250FE | 制造商:Ohmite Mfg Co 功能描述: |
| MJ8251F | 制造商:Ohmite Mfg Co 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。