- 您現在的位置：買賣IC網 > PDF目錄374441 > MIW5049 (Minmax Technology Co., Ltd.) 10W, Wide Input Range DIP, Single & Dual Output DC/DC Converters PDF資料下載
參數資料
| 型號： | MIW5049 |
| 廠商： | Minmax Technology Co., Ltd. |
| 英文描述： | 10W, Wide Input Range DIP, Single & Dual Output DC/DC Converters |
| 中文描述： | 10W的，寬輸入范圍下滑，單 |
| 文件頁數： | 6/8頁 |
| 文件大?。?/td> | 247K |
| 代理商： | MIW5049 |
Test Configurations
Input Reflected-Ripple Current Test Setup
Input reflected-ripple current is measured with a inductor
Lin (4.7uH) and Cin (220uF, ESR < 1.0[ at 100 kHz) to
simulated source impedance.
Capacitor Cin, offsets possible battery impedance.
Current ripple is measured at the input terminals of the
module, measurement bandwidth is 0-500KHz.
Peak-to-Peak Output Noise Measurement Test
Use a Cout 0.47uF ceramic capacitor.
Scope measurement should be made by using a BNC
socket, measurement bandwidth is 0-20 MHz. Position the
load between 50 mm and 75 mm from the DC/DC Converter.
Design & Feature Considerations
Maximum Capacitive Load
The MIW5000 series has limitation of maximum connected
capacitance on the output.
The power module may operate in current limiting mode
during start-up, affecting the ramp-up and the startup time.
The maximum capacitance can be found in the data
sheet.
Overcurrent Protection
To provide protection in a fault (output overload) condition,
the unit is equipped with internal current limiting circuitry and
can endure current limiting for an unlimited duration. At the
point of current-limit inception, the unit shifts from voltage
control to current control. The unit operates normally once the
output current is brought back into its specified range.
Overvoltage Protection
The output overvoltage clamp consists of control circuitry,
which is independent of the primary regulation loop, that
monitors the voltage on the output terminals.
The control loop of the clamp has a higher voltage set
point than the primary loop.
This provides a redundant voltage control that reduces the
risk of output overvoltage.
Input Source Impedance
The power module should be connected to a low
ac-impedance input source. Highly inductive source
impedances can affect the stability of the power module.
In applications where power is supplied over long lines and
output loading is high, it may be necessary to use a capacitor
on the input to insure startup.
By using a good quality low Equivalent Series Resistance
(ESR < 1.0[ at 100 kHz) capacitor of a 12uF for the 12V,
4.7uF for the 24V input devices and a 2.2uF for the 48V
devices, capacitor mounted close to the power module helps
ensure stability of the unit.
Output Ripple Reduction
A good quality low ESR capacitor placed as close as
practicable across the load will give the best ripple and noise
performance.
To reduce output ripple, it is recommended that 3.3uF
capacitors are used on output.
MIW5000 Series
6
MINMAX
REV:0 2005/04
+Out
-Out
+Vin
-Vin
DC / DC
Converter
Load
Battery
+
Lin
+
Cin
To Oscilloscope
Current
Probe
+Out
-Out
+Vin
-Vin
Single Output
DC / DC
Converter
Resistive
Load
Scope
Copper Strip
Cout
+Out
-Out
+Vin
-Vin
Dual Output
DC / DC
Converter
Resistive
Load
Scope
Copper Strip
Cout
Com.
Scope
Cout
+
+Out
-Out
+Vin
-Vin
DC / DC
Converter
Load
DC Power
Source
+
-
Cin
+Out
-Out
+Vin
-Vin
Load
DC Power
Source
+
-
Cout
Single Output
DC / DC
Converter
+Out
-Out
+Vin
-Vin
Load
DC Power
Source
+
-
Cout
Com.
Dual Output
DC / DC
Converter
相關PDF資料 |
PDF描述 |
|---|---|
| MJ10001 | POWER TRANSISTORS(20A,350-400V,175W) |
| MJ10001 | SWITCHMODE SERIES NPN SILICON POWER DARLINGTON TRANSISTORS |
| MJ10001 | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| MJ10002 | FLUSH LIGHT, YELLOW; Colour:Yellow; Height, above panel:11.5mm; IP rating:IP 66; Shock resistance:>30; Temp, op. max:70(degree C); Temp, op. min:-25(degree C) RoHS Compliant: NA |
| MJ10002 | SWITCHMODE SERIES NPN SILICON POWER DARLINGTON TRANSISTORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MIWBAEI | 功能描述:電線導管 Box Adapter, In Wall, Electric Ivory RoHS:否 制造商:Panduit 類型:Slotted SideWall Open finger design wiring cut 材料:Polypropylene 顏色:Light Gray 大小: 最大光束直徑: 抗拉強度: 外部導管寬度:25 mm 外部導管高度:25 mm |
| MIWBAIG | 功能描述:電線導管 Box Adapter, In Wall, Intl Gray RoHS:否 制造商:Panduit 類型:Slotted SideWall Open finger design wiring cut 材料:Polypropylene 顏色:Light Gray 大小: 最大光束直徑: 抗拉強度: 外部導管寬度:25 mm 外部導管高度:25 mm |
| MIWBAIW | 功能描述:電線導管 Box Adapter, In Wall, Off White RoHS:否 制造商:Panduit 類型:Slotted SideWall Open finger design wiring cut 材料:Polypropylene 顏色:Light Gray 大小: 最大光束直徑: 抗拉強度: 外部導管寬度:25 mm 外部導管高度:25 mm |
| MIWBAWH | 功能描述:電線導管 Box Adapter, In Wall, White RoHS:否 制造商:Panduit 類型:Slotted SideWall Open finger design wiring cut 材料:Polypropylene 顏色:Light Gray 大小: 最大光束直徑: 抗拉強度: 外部導管寬度:25 mm 外部導管高度:25 mm |
| MIWI 140 GREY | 制造商:Belden Inc 功能描述:MIWI 140 GREY |
發布緊急采購，3分鐘左右您將得到回復。