參數資料
型號: MIC5158BN
廠商: Micrel Inc
文件頁數: 10/13頁
文件大小: 271K
描述: IC REG CTRLR SGL FIX/ADJ 14-DIP
標準包裝: 25
類型: 正,固定式或可調式
輸出數: 1
輸出電壓: 5V,1.3 V ~ 36 V
電流 - 電源: 4.5mA
輸入電壓: 3 V ~ 36 V
工作溫度: -40°C ~ 85°C
封裝/外殼: 14-DIP(0.300",7.62mm)
供應商設備封裝: 14-DIP
包裝: 管件
MIC5156/5157/5158
Micrel, Inc.
MIC5156/5157/5158
10
August 2005
Current Limiting
Current sensing requires a low-value series resistance (R
s
)
between V
DD
 and D (drain). Refer to the typical applications.
The internal current-limiting circuit limits the voltage drop
across the sense resistor to 35mV. Equation (2) provides the
sense resistor value required for a given maximum current.
2)
S
 =
35mV
I
LIM
 
where:
 
R
S
 = sense resistor value
 
I
LIM
 = maximum output current
Most current-limited applications require low-value resistors.
See Application Hints 21 and 25 for construction hints.
Non-Current-Limited Applications
For circuits not requiring current limiting, do not use a sense
resistor between V
DD
 and D (drain). See gure (3). The con-
troller will not limit current when it does not detect a 35mV
drop from V
DD
 to D.
S
G
MIC5156
D
V
DD
V
IN
Figure 3. No Current Limit
3.3V Microprocessor Applications
For computer designs that use 3.3V microprocessors with 5V
logic, the FLAG output can be used to suppress the 5V sup-
ply until the 3.3V output is in regulation. Refer to the external
components shown with the MIC5156 Block Diagram.
SMPS Post Regulator Application
A Super LDO regulator can be used as a post regulator for a
switch-mode power supply. The Super LDO regulator can pro-
vide a signicant reduction in peak-to-peak ripple voltage.
High-Current Switch Application
All versions of the MIC5156/7/8 may be used for current-lim-
ited, high-current, high-side switching with or without voltage
regulation. See gure (4a). Simply leave the S terminal
open. A 16V zener diode from the gate to the source of the
MOSFET protects the MOSFET from overdrive during fault
conditions.
G
MIC5156-x.x
D
V
DD
V
IN
V
G
Gate Supply
Enable
hutdown
EN
GND
R
S
S
Figure 4a. High-Side Switch
If a MIC5157 or MIC5158 is used and is shutdown for a
given time, the charge pump reservoir V
CP
 will bleed off. If
recharging the reservoir causes an unacceptable delay in the
load reaching its operating voltage, do not use the EN pin
for on/off control. Instead, use the MIC5158, hold EN high to
keep the charge pump in continuous operation, and switch
the MOSFET on or off by overriding the error amplier input
as shown in gure (4b).
GND
S
EA
MIC5158
G
EN
utput Off
utput On
1N4148
V
IN
V
DD
Figure 4b. Fast High-Side Switch
Battery Charger Application
The MIC5158 may be used in constant-current applications
such as battery chargers. See gure (5). The regulator supplies
a constant-current (35mV ?R3) until the battery approaches
the oat voltage:
 
FL
 = 1.235 (1 +    )
R1
R2
where:
 
V
FL
 = oat voltage
At oat voltage, the MOSFET is shut off. A trickle charge is
supplied by R4.
相關PDF資料
PDF描述
MIC5159BM6 TR IC REG CTRLR SGL POS ADJ SOT23-6
MIC5190BMM TR IC REG CTRLR SGL POS ADJ 10-MSOP
MIC5191BMM TR IC REG CTRLR SGL POS ADJ 10-MSOP
ML4800CP IC PFC CTRLR AVERAGE CURR 16DIP
ML4824CS2 IC PFC PWM CTRLR COMBO 16-SOIC
相關代理商/技術參數
參數描述
MIC5158YM 功能描述:低壓差控制器 - LDO Super LDO Regulator-5 volt/adj -(Lead Free) RoHS:否 制造商:Micrel 最大輸入電壓:5.5 V 輸出電壓:Adjustable 輸出電流:10 mA 負載調節: 輸出類型:Adjustable, Fixed 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-6
MIC5158YM TR 功能描述:低壓差控制器 - LDO Super LDO Regulator-5 volt/adj -(Lead Free) RoHS:否 制造商:Micrel 最大輸入電壓:5.5 V 輸出電壓:Adjustable 輸出電流:10 mA 負載調節: 輸出類型:Adjustable, Fixed 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-6
MIC5158YM 制造商:Micrel Inc 功能描述:IC VOLTAGE REGULATOR
MIC5158YM 制造商:Micrel Inc 功能描述:Linear Voltage Regulator IC
MIC5158YN 功能描述:低壓差控制器 - LDO Super LDO Regulator-5 volt/adj -(Lead Free) RoHS:否 制造商:Micrel 最大輸入電壓:5.5 V 輸出電壓:Adjustable 輸出電流:10 mA 負載調節: 輸出類型:Adjustable, Fixed 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-6