- 您現在的位置：買賣IC網 > PDF目錄384736 > MIC4723 (Micrel Semiconductor,Inc.) 3A 2MHz Integrated Switch Buck Regulator PDF資料下載
參數資料
| 型號： | MIC4723 |
| 廠商： | Micrel Semiconductor,Inc. |
| 英文描述： | 3A 2MHz Integrated Switch Buck Regulator |
| 中文描述： | 第3A 2MHz的集成開關降壓穩壓器 |
| 文件頁數： | 8/19頁 |
| 文件大?。?/td> | 527K |
| 代理商： | MIC4723 |
Micrel, Inc.
MIC4723
Pin Description
VIN
Two pins for VIN provide power to the source of the
internal P-channel MOSFET along with the current
limiting sensing. The VIN operating voltage range is from
2.7V to 5.5V. Due to the high switching speeds, a 10μF
capacitor is recommended close to VIN and the power
ground (PGND) for each pin for bypassing. Please refer
to layout recommendations.
May 2007
8
M9999-052307-A
BIAS
The bias (BIAS) provides power to the internal reference
and control sections of the MIC4723. A 10
resistor
from VIN to BIAS and a 0.1μF from BIAS to SGND is
required for clean operation.
EN
The enable pin provides a logic level control of the
output. In the off state, supply current of the device is
greatly reduced (typically <1μA). Do not drive the enable
pin above the supply voltage.
FB
The feedback pin (FB) provides the control path to
control the output. For adjustable versions, a resistor
divider connecting the feedback to the output is used to
adjust the desired output voltage. The output voltage is
calculated as follows:
+
×
=
1
R2
R1
V
V
REF
OUT
where V
REF
is equal to 1.0V.
A feedforward capacitor is recommended for most
designs using the adjustable output voltage option. To
reduce current draw, a 10K feedback resistor is
recommended from the output to the FB pin (R1). Also, a
feedforward capacitor should be connected between the
output and feedback (across R1). The large resistor
value and the parasitic capacitance of the FB pin can
cause a high frequency pole that can reduce the overall
system phase margin. By placing a feedforward
capacitor, these effects can be significantly reduced.
Feedforward capacitance (C
FF
) can be calculated as
follows:
1
C
FF
×
×
π
200kHz
R1
2
=
SW
The switch (SW) pin connects directly to the inductor
and provides the switching current necessary to operate
in PWM mode. Due to the high speed switching on this
pin, the switch node should be routed away from
sensitive nodes. This pin also connects to the cathode of
the free-wheeling diode.
PGOOD
Power good is an open drain pull down that indicates
when the output voltage has reached regulation. When
power good is low, then the output voltage is within
±10% of the set regulation voltage. For output voltages
greater or less than 10%, the PGOOD pin is high. This
should be connected to the input supply through a pull
up resistor. A delay can be added by placing a capacitor
from PGOOD to ground.
PGND
Power ground (PGND) is the ground path for the
MOSFET drive current. The current loop for the power
ground should be as small as possible and separate
from the Signal ground (SGND) loop. Refer to the layout
considerations for more details.
SGND
Signal ground (SGND) is the ground path for the biasing
and control circuitry. The current loop for the signal
ground should be separate from the power ground
(PGND) loop. Refer to the layout considerations for more
details.
相關PDF資料 |
PDF描述 |
|---|---|
| MIC49200-1.8WR | 2A LOW VOLTAGE LDO WITH DUAL INPUT VOLTAGES |
| MIC49200 | 2A LOW VOLTAGE LDO WITH DUAL INPUT VOLTAGES |
| MIC49200-1.0WR | 2A LOW VOLTAGE LDO WITH DUAL INPUT VOLTAGES |
| MIC49200WR | 2A LOW VOLTAGE LDO WITH DUAL INPUT VOLTAGES |
| MIC5011 | Minimum Parts High- or Low-Side MOSFET Driver(高/低邊MOS場效應管驅動器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MIC4723_08 | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:3A 2MHz Integrated Switch Buck Regulator |
| MIC4723YML | 制造商:Rochester Electronics LLC 功能描述: 制造商:RF Micro Devices Inc 功能描述: |
| MIC4723YML TR | 功能描述:直流/直流開關調節器 3A 2MHz Buck Regulator in MLF RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| MIC4723YML-TR | 功能描述:Buck Switching Regulator IC Positive Adjustable 1V 1 Output 3A 12-VFDFN Exposed Pad, 12-MLF? 制造商:microchip technology 系列:- 包裝:剪切帶（CT） 零件狀態:停產 功能:降壓 輸出配置:正 拓?fù)?降壓 輸出類型:可調式 輸出數:1 電壓 - 輸入（最小值）:2.7V 電壓 - 輸入（最大值）:5.5V 電壓 - 輸出（最小值/固定）:1V 電壓 - 輸出（最大值）:5.5V 電流 - 輸出:3A 頻率 - 開關:2MHz 同步整流器:無 工作溫度:-40°C ~ 125°C （TJ） 安裝類型:表面貼裝 封裝/外殼:12-VFDFN 裸焊盤，12-MLF? 供應商器件封裝:12-MLF?（4x4） 標準包裝:1 |
| MIC4723YMME | 功能描述:直流/直流開關調節器 3A 2MHz Buck Regulator in epad MSOP-10 Pkg RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
發布緊急采購，3分鐘左右您將得到回復。