參數資料
型號： MIC2207
廠商： Micrel Semiconductor,Inc.
英文描述： 3mmx3mm 2MHz 3A PWM Buck Regulator
中文描述： 3mmx3mm 2MHz的3A PWM降壓調節
文件頁數： 9/21頁
文件大?。?/td> 780K
代理商： MIC2207
Micrel
MIC2205
Pin Descriptions
Micrel, Inc 2180 Fortune Drive San Jose, Ca 95131 USA tel +1 (408) 944-0800 fax +1 (408) 474-1000 http://www.micrel.com
April 2005
VIN
Two pins for VIN provide power to the source of the
internal P-channel MOSFET along with the current
limiting sensing. The VIN operating voltage range is
from 2.7V to 5.5V. Due to the high switching speeds,
a 10
μ
F capacitor is recommended close to VIN and
the power ground (PGND) for each pin for
bypassing. Please refer to layout recommendations.
BIAS
The bias (BIAS) provides power to the internal
reference and control sections of the MIC2207. A 10
Ohm resistor from VIN to BIAS and a 0.1uF from
BIAS to SGND is required for clean operation.
EN
The enable pin provides a logic level control of the
output. In the off state, supply current of the device
is greatly reduced (typically <1
μ
A). Do not drive the
enable pin above the supply voltage.
FB
The feedback pin (FB) provides the control path to
control the output. For adjustable versions, a resistor
divider connecting the feedback to the output is used
to adjust the desired output voltage. The output
voltage is calculated as follows:
+
×
=
1
R2
R1
V
V
REF
OUT
where V
REF
is equal to 1.0V.
A feedforward capacitor is recommended for most
designs using the adjustable output voltage option.
To reduce current draw, a 10K feedback resistor is
recommended from the output to the FB pin (R1).
Also, a feedforward capacitor should be connected
between the output and feedback (across R1). The
large resistor value and the parasitic capacitance of
the FB pin can cause a high frequency pole that can
reduce the overall system phase margin. By placing
a feedforward capacitor, these effects can be
significantly reduced. Feedforward capacitance (C
FF
)
can be calculated as follows:
1
C
FF
×
×
π
200kHz
R1
2
=
SW
The switch (SW) pin connects directly to the inductor
and provides the switching current nessasary to
operate in PWM mode. Due to the high speed
switching on this pin, the switch node should be
routed away from sensitive nodes. This pin also
connects to the cathode of the free-wheeling diode.
PGOOD
Power good is an open drain pull down that
indicates when the output voltage has reached
regulation. For a power good low, the output voltage
is within +/- 10% of the set regulation voltage. For
output voltages greater or less than 10%, the
PGOOD pin is high. This should be connected to the
input supply through a pull up resistor. A delay can
be added by placing a capacitor from PGOOD to
ground.
PGND
Power ground (PGND) is the ground path for the
MOSFET drive current. The current loop for the
power ground should be as small as possible and
separate from the Signal ground (SGND) loop. Refer
to the layout considerations fro more details.
SGND
Signal ground (SGND) is the ground path for the
biasing and control circuitry. The current loop for the
signal ground should be separate from the power
ground
(PGND)
loop.
considerations for more details
Refer
to
the
layout
M9999-040705
www.micrel.com
相關PDF資料
PDF描述
MIC2213 Sequenced Portable Power Management IC
MIC2213-1.8 Sequenced Portable Power Management IC
MIC2213-2.6 Sequenced Portable Power Management IC
MIC2213-2.85BML Sequenced Portable Power Management IC
MIC2213-AABML Sequenced Portable Power Management IC
相關代理商/技術參數
參數描述
MIC2207_10 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:3mm x 3mm 2MHz 3A PWM Buck Regulator
MIC2207YML 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:3mmx3mm 2MHz 3A PWM Buck Regulator
MIC2207YML TR 功能描述:直流/直流開關調節器 3A 2MHz Integrated Switch Buck Regulator (Lead Free) RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
MIC2207YML-EV 功能描述:MIC2207 - DC/DC, Step Down 1, Non-Isolated Outputs Evaluation Board 制造商:microchip technology 系列:- 零件狀態:有效 主要用途:DC/DC，步降 輸出和類型:1，非隔離 功率 - 輸出:- 電壓 - 輸出:1.8V 電流 - 輸出:3A 電壓 - 輸入:2.7 V ~ 5.5 V 穩壓器拓?fù)?降壓 頻率 - 開關:2MHz 板類型:完全填充 所含物品:板 使用的 IC/零件:MIC2207 標準包裝:1
MIC2207YMLTR 制造商:Micrel 功能描述:DC-DC Converter Single Buck 2.7 - 5.5V
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*