- 您現在的位置：買賣IC網 > PDF目錄384734 > MIC2169MM (Micrel Semiconductor,Inc.) 500 KHZ PWM SYNCHRONOUS BUCK CONTROL IC PDF資料下載
參數資料
| 型號： | MIC2169MM |
| 廠商： | Micrel Semiconductor,Inc. |
| 英文描述： | 500 KHZ PWM SYNCHRONOUS BUCK CONTROL IC |
| 中文描述： | 500千赫的PWM同步降壓控制IC |
| 文件頁數： | 13/14頁 |
| 文件大?。?/td> | 160K |
| 代理商： | MIC2169MM |
November 2003
13
M9999-111803
MIC2169
Micrel
Design Example
Layout and Checklist:
1. Connect the current limiting (CS) resistor directly
to the drain of top MOSFET Q1.
2. Connect the VSW pin directly to the source of top
MOSFET Q1 thru a 4
to 10
resistor. The pur-
pose of the resistor is to filter the switch node.
3. The feedback resistors R1 and R2 should be
placed close to the FB pin. The top side of R1
should connect directly to the output node. Run
this trace away from the switch node (junction of
Q1, Q2, and L1). The bottom side of R1 should
connect to the GND pin on the MIC2169.
4. The compensation resistor and capacitors should
be placed right next to the COMP/EN pin and the
other side should connect directly to the GND pin
on the MIC2169 rather than going to the plane.
5. The input bulk capacitors should be placed close to
the drain of the top MOSFET.
6. The 1
μ
F ceramic capacitor should be placed right
on the VIN pin of the MIC2169.
7. The 4.7
μ
F to 10
μ
F ceramic capacitor should be
placed right on the VDD pin.
8. The source of the bottom MOSFET should connect
directly to the input capacitor GND with a thick
trace. The output capacitor and the input capacitor
should connect directly to the GND plane.
9. Place a 0.1
μ
F ceramic capacitor in parallel with the
CS resistor to filter any switching noise.
相關PDF資料 |
PDF描述 |
|---|---|
| MIC2169 | 500 KHZ PWM SYNCHRONOUS BUCK CONTROL IC |
| MIC2171BT | Isolated Flyback Switching Regulator with 9V Output |
| MIC2171BU | Isolated Flyback Switching Regulator with 9V Output |
| MIC2171 | Isolated Flyback Switching Regulator with 9V Output |
| MIC2185 | Low Voltage Synchronous Boost PWM Control IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MIC2169YMM | 功能描述:直流/直流開關調節器 Replaced by MIC2169AYMM (Lead Free) RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| MIC2169YMM TR | 功能描述:直流/直流開關調節器 Replaced by MIC2169AYMM TR (Lead Free) RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| MIC2171 | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:100kHz 2.5A Switching Regulator Preliminary Information |
| MIC2171_07 | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:100kHz 2.5A Switching Regulator |
| MIC2171BT | 功能描述:IC REG MULTI CONFIG 2.5A TO220-5 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:20 系列:SIMPLE SWITCHER® 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:12V 輸入電壓:4 V ~ 60 V PWM 型:電壓模式 頻率 - 開關:52kHz 電流 - 輸出:1A 同步整流器:無 工作溫度:-40°C ~ 125°C 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 包裝:管件 供應商設備封裝:16-DIP 其它名稱:*LM2575HVN-12LM2575HVN-12 |
發布緊急采購，3分鐘左右您將得到回復。