- 您現在的位置：買賣IC網 > PDF目錄371098 > MF0256M-07ATxx (Mitsubishi Electric Corporation) 8/16-bit Data Bus Flash ATA PC Card PDF資料下載
參數資料
| 型號： | MF0256M-07ATxx |
| 廠商： | Mitsubishi Electric Corporation |
| 英文描述： | 8/16-bit Data Bus Flash ATA PC Card |
| 中文描述： | 16位產品數據總線閃存阿拉木圖PC卡 |
| 文件頁數： | 19/31頁 |
| 文件大?。?/td> | 222K |
| 代理商： | MF0256M-07ATXX |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁
MITSUBISHI STORAGE CARD
MF0XXXX-07BTXX / -07BFXX series
ATA PC CARDS
Jun.2000
. Rev. 1.0
MITSUBISHI
ELECTRIC
19/31
Standby(96h, E2h)
This command causes the card to set BSY, enter the
Standby mode, clear BSY and generate an interrupt.
Standby Immediate(94h, E0h)
This command causes the card to set BSY, enter the
Standby mode, clear BSY and generate an interrupt.
Translate Sector(87h)
This command allows the host to know the number
of times an user sector has been erased and
programmed. This card doesn't support the Hot
Count value.
Wear Leveling(F5h)
Although this command is supported for backward
compatibility, it has no actual function. The card will
always return good status at the completion of this
command.
Write Buffer(E8h)
This command enables the host to overwrite contents of
the card
’
s sector buffer with any data pattern desired.
This command has the same protocol as the Write
Sector(s) command and transfers 512 bytes.
Write Long Sector(32h, 33h)
This command is similar to the Write Sector(s) except
the contents of the Sector Count register are ignored and
only one sector is written. The 512 data bytes and 4 ECC
bytes are transferred from the host and then written from
the buffer to the flash.
Write Multiple(C5h)
This command is similar to the Write Sector(s)
command. Interrupts are not presented on each sector,
but on the transfer of a block which contains the number
of sectors defined by Set Multiple command.
Write Multiple without Erase(CDh)
This command is similar to the Write Multiple
command. The sectors should be pre-erased with the
Erase Sector command before this command is issued. If
the sector is not pre-erased, Write Multiple command
operation will occur.
Write Sector(s)(30h, 31h)
This command transfers data from the host to the card.
Data transfer starts at the sector specified by the
Cylinder, Head, and Sector Number registers, and
proceeds for the number of sectors specified in the Sector
Count register.
Write Sector without Erase(CDh)
This command is similar to the Write Sector(s)
command. The sectors should be pre-erased with the
Erase Sector command before this command is issued. If
the sector is not pre-erased, Write Sector command
operation will occur.
Write Verify(3Ch)
This command is similar to the Write Sector(s)
command, except each sector is verified immediately
after being written.
相關PDF資料 |
PDF描述 |
|---|---|
| MF1037S-1 | FOR PERSONAL HANDYPHONE SYSTEM |
| MF1037S-2 | DIODE ZENER SINGLE 300mW 16Vz 5mA-Izt 0.0556 0.1uA-Ir 11.2 SOT-23 3K/REEL |
| MF1050V-2 | FOR DIGITAL MOBILE TELEPHONE, Rx |
| MF1050V-4 | FOR DIGITAL MOBILE TELEPHONE, Rx |
| MF1050S-1 | FOR DIGITAL MOBILE TELEPHONE, Rx |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MF0256M-07BTXX | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:8/16-bit Data Bus Flash ATA PC Card |
| MF0256M-11ATXX | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:8/16-bit Data Bus Flash ATA PC Card |
| MF02A | 制造商:IDEC CORPORATION 功能描述:REFLEX NPN NO+NC 12-30 VDC |
| MF02ADHR | 制造商:Brady Corporation 功能描述:SIGN KEEP LOCKED SHUT 200X200MM |
| MF02AEX | 制造商:IDEC CORPORATION 功能描述:REFLEX NPN NO+NC 12-30 VDC |
發布緊急采購，3分鐘左右您將得到回復。