- 您現在的位置：買賣IC網 > PDF目錄45316 > MD83C154CXXX-25P883D (ATMEL CORP) 8-BIT, MROM, 25 MHz, MICROCONTROLLER, CDIP40 PDF資料下載
參數資料
| 型號： | MD83C154CXXX-25P883D |
| 廠商： | ATMEL CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, MROM, 25 MHz, MICROCONTROLLER, CDIP40 |
| 封裝： | 0.600 INCH, CERAMIC, DIP-40 |
| 文件頁數： | 89/231頁 |
| 文件大?。?/td> | 61013K |
| 代理商： | MD83C154CXXX-25P883D |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁當前第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁第206頁第207頁第208頁第209頁第210頁第211頁第212頁第213頁第214頁第215頁第216頁第217頁第218頁第219頁第220頁第221頁第222頁第223頁第224頁第225頁第226頁第227頁第228頁第229頁第230頁第231頁
179
ATmega165A/PA/325A/PA/3250A/PA/645A/P/6450A/P [DATASHEET]
8285E–AVR–02/2013
The Three-wire mode timing is shown in Figure 21-3 on page 178 At the top of the figure is a USCK cycle refer-
ence. One bit is shifted into the USI Shift Register (USIDR) for each of these cycles. The USCK timing is shown for
both external clock modes. In External Clock mode 0 (USICS0 = 0), DI is sampled at positive edges, and DO is
changed (Data Register is shifted by one) at negative edges. External Clock mode 1 (USICS0 = 1) uses the oppo-
site edges versus mode 0, i.e., samples data at negative and changes the output at positive edges. The USI clock
modes corresponds to the SPI data mode 0 and 1.
Referring to the timing diagram (Figure 21-3 on page 178), a bus transfer involves the following steps:
1.
The Slave device and Master device sets up its data output and, depending on the protocol used, enables
its output driver (mark A and B). The output is set up by writing the data to be transmitted to the Serial Data
Register. Enabling of the output is done by setting the corresponding bit in the port Data Direction Register.
Note that point A and B does not have any specific order, but both must be at least one half USCK cycle
before point C where the data is sampled. This must be done to ensure that the data setup requirement is
satisfied. The 4-bit counter is reset to zero.
2.
The Master generates a clock pulse by software toggling the USCK line twice (C and D). The bit value on
the slave and master’s data input (DI) pin is sampled by the USI on the first edge (C), and the data output is
changed on the opposite edge (D). The 4-bit counter will count both edges.
3.
Step 2. is repeated eight times for a complete register (byte) transfer.
4.
After eight clock pulses (i.e., 16 clock edges) the counter will overflow and indicate that the transfer is com-
pleted. The data bytes transferred must now be processed before a new transfer can be initiated. The
overflow interrupt will wake up the processor if it is set to Idle mode. Depending of the protocol used the
slave device can now set its output to high impedance.
21.3.2
SPI Master Operation Example
The following code demonstrates how to use the USI module as a SPI Master:
SPITransfer:
sts
USIDR,r16
ldi
r16,(1<<USIOIF)
sts
USISR,r16
ldi
r16,(1<<USIWM0)|(1<<USICS1)|(1<<USICLK)|(1<<USITC)
SPITransfer_loop:
sts
USICR,r16
lds
r16, USISR
sbrs
r16, USIOIF
rjmp
SPITransfer_loop
lds
r16,USIDR
ret
The code is size optimized using only eight instructions (+ ret). The code example assumes that the DO and USCK
pins are enabled as output in the DDRE Register. The value stored in register r16 prior to the function is called is
transferred to the Slave device, and when the transfer is completed the data received from the Slave is stored back
into the r16 Register.
The second and third instructions clears the USI Counter Overflow Flag and the USI counter value. The fourth and
fifth instruction set Three-wire mode, positive edge Shift Register clock, count at USITC strobe, and toggle USCK.
The loop is repeated 16 times.
The following code demonstrates how to use the USI module as a SPI Master with maximum speed (fsck = fck/4):
相關PDF資料 |
PDF描述 |
|---|---|
| MR83C154CXXX-20/883R | 8-BIT, MROM, 20 MHz, MICROCONTROLLER, CQCC44 |
| MD83C154XXX-30/883 | 8-BIT, MROM, 30 MHz, MICROCONTROLLER, CDIP40 |
| MQ83C154CXXX-30P883D | 8-BIT, MROM, 30 MHz, MICROCONTROLLER, CQFP44 |
| MQ80C154-12P883R | 8-BIT, 12 MHz, MICROCONTROLLER, CQFP44 |
| MR83C154CXXX-L16P883D | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CQCC44 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MD83C154-L16 | 制造商:TEMIC 制造商全稱:TEMIC Semiconductors 功能描述:CMOS 0 to 36 MHz Single Chip 8-bit Microcontroller |
| MD83C154T-12 | 制造商:TEMIC 制造商全稱:TEMIC Semiconductors 功能描述:CMOS 0 to 36 MHz Single Chip 8-bit Microcontroller |
| MD83C154T-16 | 制造商:TEMIC 制造商全稱:TEMIC Semiconductors 功能描述:CMOS 0 to 36 MHz Single Chip 8-bit Microcontroller |
| MD83C154T-20 | 制造商:TEMIC 制造商全稱:TEMIC Semiconductors 功能描述:CMOS 0 to 36 MHz Single Chip 8-bit Microcontroller |
| MD83C154T-25 | 制造商:TEMIC 制造商全稱:TEMIC Semiconductors 功能描述:CMOS 0 to 36 MHz Single Chip 8-bit Microcontroller |
發布緊急采購，3分鐘左右您將得到回復。