參數資料
型號: MCZ33883EG
廠商: 飛思卡爾半導體(中國)有限公司
英文描述: H-Bridge Gate Driver IC
中文描述: H橋門驅動器集成電路
文件頁數: 10/21頁
文件大?。?/td> 323K
代理商: MCZ33883EG
Analog Integrated Circuit Device Data
Freescale Semiconductor
10
33883
FUNCTIONAL DESCRIPTION
INTRODUCTION
FUNCTIONAL DESCRIPTION
INTRODUCTION
The 33883 is an H-bridge gate driver (or full-bridge pre-
driver) with integrated charge pump and independent high-
and low-side driver channels. It has the capability to drive
large gate-charge MOSFETs and supports high PWM
frequency. In sleep mode its supply current is very low.
FUNCTIONAL TERMINAL DESCRIPTION
SUPPLY VOLTAGE TERMINALS (VCC AND VCC2)
The VCC and VCC2 terminals are the power supply inputs
to the device. V
CC
is used for the output high-side drivers and
the charge pump. V
CC2
is used for the linear regulation. They
can be connected together or independent with different
voltage values. The device can operate with V
CC
up to 55 V
and V
CC2
up to 28 V.
The VCC and VCC2 terminals have undervoltage (UV)
and overvoltage (OV) shutdown. If one of the supply voltage
drops below the undervoltage threshold or rises above the
overvoltage threshold, the gate outputs are switched LOW in
order to switch off the external MOSFETs. When the supply
returns to a level that is above the UV threshold or below the
OV threshold, the device resumes normal operation
according to the established condition of the input terminals.
INPUT HIGH- AND LOW-SIDE TERMINALS
(IN_HS1, IN_HS2, AND IN_LS1, IN_LS2)
The IN_HSn and IN_LSn terminals are input control
terminals used to control the gate outputs. These terminals
are 5.0 V CMOS-compatible inputs with hysteresis. IN_HSn
and IN_LSn independently control GATE_HSn and
GATE_LSn, respectively.
During wake-up, the logic is supplied from the G_EN
terminal. There is no internal circuit to prevent the external
high-side and low-side MOSFETs from conducting at the
same time.
SOURCE OUTPUT HIGH-SIDE TERMINALS
(SRC_HS1 AND SRC_HS2)
The SRC_HSn terminals are the sources of the external
high-side MOSFETs. The external high-side MOSFETs are
controlled using the
IN_HSn
inputs.
GATE HIGH- AND LOW-SIDE TERMINALS
(GATE_HS1, GATE_HS2, AND GATE_LS1,
GATE_LS2)
The GATE_HSn and GATE_LSn terminals are the gates
of the external high- and low-side MOSFETs. The external
high- and low-side MOSFETs are controlled using the
IN_HSn
and
IN_LSn inputs.
GLOBAL ENABLE (G_EN)
The G_EN terminal is used to place the device in a sleep
mode. When the G_EN terminal voltage is a logic LOW state,
the device is in sleep mode. The device is enabled and fully
operational when the G_EN terminal voltage is logic HIGH,
typically 5.0 V.
CHARGE PUMP OUT (CP_OUT)
The CP_OUT terminal is used to connect an external
reservoir capacitor for the charge pump.
CHARGE PUMP CAPACITOR TERMINALS
(C1 AND C2)
The C1 and C2 terminals are used to connect an external
capacitor for the charge pump.
LINEAR REGULATOR OUTPUT (LR_OUT)
The LR_OUT terminal is the output of the internal
regulator. It is used to connect an external capacitor.
GROUND TERMINALS
(GND_A, GND1 AND GND2)
These terminals are the ground terminals of the device.
They should be connected together with a very low
impedance connection.
相關PDF資料
PDF描述
MCZ33884EG Switch Monitor Interface
MCZ33887EK 5.0 A H-Bridge with Load Current Feedback
MCZ33889BEG System Basis Chip with Low Speed Fault Tolerant CAN Interface
MCZ33927EK Transistor; Type: Amplifiers/Bipolar; VCEO (V): -100; Ic (A): -1; Pc (W): 0.9; hFE: 140 to 350; VCE (sat) (V) max: -0.5; Package: TO-92Mod
MCZ33970EG Dual Gauge Driver Integrated Circuit with Improved Damping Algorithms
相關代理商/技術參數
參數描述
MCZ33883EG 制造商:Freescale Semiconductor 功能描述:SEMICONDUCTOR
MCZ33883EGR2 功能描述:功率驅動器IC FULL BRIDGE GATE DRIVER RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube
MCZ33884EG 功能描述:多路器開關 IC SW DETECT INTERFACE RoHS:否 制造商:Texas Instruments 通道數量:1 開關數量:4 開啟電阻(最大值):7 Ohms 開啟時間(最大值): 關閉時間(最大值): 傳播延遲時間:0.25 ns 工作電源電壓:2.3 V to 3.6 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UQFN-16
MCZ33884EG 制造商:Freescale Semiconductor 功能描述:SWITCH MONITOR INTERFACE 24SOIC
MCZ33884EGR2 功能描述:多路器開關 IC SW DETECT INTERFACE RoHS:否 制造商:Texas Instruments 通道數量:1 開關數量:4 開啟電阻(最大值):7 Ohms 開啟時間(最大值): 關閉時間(最大值): 傳播延遲時間:0.25 ns 工作電源電壓:2.3 V to 3.6 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UQFN-16