• <dfn id="mlhmn"><input id="mlhmn"><s id="mlhmn"></s></input></dfn>
  • <dd id="mlhmn"><tr id="mlhmn"><div id="mlhmn"></div></tr></dd>
    <form id="mlhmn"><form id="mlhmn"><div id="mlhmn"></div></form></form>
  • <dd id="mlhmn"><tr id="mlhmn"><menu id="mlhmn"></menu></tr></dd>
  • 參數資料
    型號: MCP4551T-502E/MS
    廠商: Microchip Technology
    文件頁數: 51/88頁
    文件大?。?/td> 0K
    描述: IC POT DGTL 5K SGL 8-MSOP
    標準包裝: 2,500
    接片: 257
    電阻(歐姆): 5k
    電路數: 1
    溫度系數: 標準值 150 ppm/°C
    存儲器類型: 易失
    接口: I²C(設備位址)
    電源電壓: 1.8 V ~ 5.5 V
    工作溫度: -40°C ~ 125°C
    安裝類型: 表面貼裝
    封裝/外殼: 8-TSSOP,8-MSOP(0.118",3.00mm 寬)
    供應商設備封裝: 8-MSOP
    包裝: 帶卷 (TR)
    2008 Microchip Technology Inc.
    DS22096A-page 55
    MCP453X/455X/463X/465X
    7.2
    Data Byte
    Only the Read Command and the Write Command
    have Data Byte(s).
    The Write command concatenates the 8-bits of the
    Data Byte with the one data bit (D8) contained in the
    Command Byte to form 9-bits of data (D8:D0). The
    Command Byte format supports up to 9-bits of data so
    that the 8-bit resistor network can be set to Full-Scale
    (100h or greater). This allows wiper connections to
    Terminal A and to Terminal B. The D9 bit is currently
    unused.
    7.3
    Error Condition
    If the four address bits received (AD3:AD0) and the two
    command bits received (C1:C0) are a valid combina-
    tion, the MCP4XXX will Acknowledge the I2C bus.
    If the address bits and command bits are an invalid
    combination, then the MCP4XXX will Not Acknowledge
    the I2C bus.
    Once an error condition has occurred, any following
    commands are ignored until the I2C bus is reset with a
    Start Condition.
    7.3.1
    ABORTING A TRANSMISSION
    A Restart or Stop condition in the expected data bit
    position will abort the current command sequence and
    TABLE 7-3:
    COMMANDS
    Command Name
    # of Bits
    High
    Voltage
    (VIHH) on
    HVC pin?
    29
    29
    20
    20
    High Voltage Write Data
    29
    Yes
    High Voltage Read Data
    29
    Yes
    High Voltage Increment Wiper
    20
    Yes
    High Voltage Decrement Wiper
    20
    Yes
    相關PDF資料
    PDF描述
    VE-BNR-MY-F3 CONVERTER MOD DC/DC 7.5V 50W
    MCP4551T-104E/MS IC POT DGTL 100K SGL 8-MSOP
    VE-BNR-MY-F2 CONVERTER MOD DC/DC 7.5V 50W
    MCP4551T-103E/MS IC POT DGTL 10K SGL 8-MSOP
    VE-BNP-MY-F4 CONVERTER MOD DC/DC 13.8V 50W
    相關代理商/技術參數
    參數描述
    MCP4551T-503E/MF 功能描述:數字電位計 IC Sngl 8B V I2C POT RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
    MCP4551T-503E/MS 功能描述:數字電位計 IC Sngl 8B V I2C POT RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
    MCP4552-103E/MS 功能描述:數字電位計 IC Sngl 8B V I2C Rheo RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
    MCP4552-104E/MS 功能描述:數字電位計 IC Sngl 8B V I2C Rheo RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
    MCP4552-104E/MS 制造商:Microchip Technology Inc 功能描述:; LEADED PROCESS COMPATIBLE:YES; PEAK RE