- 您現在的位置：買賣IC網 > PDF目錄9412 > MCP4019T-503E/LT (Microchip Technology)IC DGTL POT 50K 128TAPS SC70-5 PDF資料下載
參數資料
| 型號： | MCP4019T-503E/LT |
| 廠商： | Microchip Technology |
| 文件頁數： | 29/51頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DGTL POT 50K 128TAPS SC70-5 |
| 標準包裝： | 1 |
| 接片： | 128 |
| 電阻（歐姆）： | 50k |
| 電路數： | 1 |
| 溫度系數： | 標準值 150 ppm/°C |
| 存儲器類型： | 易失 |
| 接口： | I²C |
| 電源電壓： | 1.8 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 6-TSSOP（5 引線），SC-88A，SOT-353 |
| 供應商設備封裝： | SC-70-5 |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 674 (CN2011-ZH PDF) |
| 其它名稱： | MCP4019T-503E/LTDKR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁當前第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁
2009 Microchip Technology Inc.
DS22147A-page 35
MCP4017/18/19
5.2.5
STOP BIT
The Stop bit (see Figure 5-6) Indicates the end of the
I2C Data Transfer Sequence. The Stop bit is defined as
the SDA signal rising when the SCL signal is “High”.
A Stop bit resets the I2C interface of the other devices.
FIGURE 5-6:
Stop Condition Receive or
Transmit Mode.
5.2.6
CLOCK STRETCHING
“Clock Stretching” is something that the Secondary
Device can do, to allow additional time to “respond” to
the “data” that has been received.
The MCP4017/18/19 will not strech the clock signal
(SCL) since memory read accesses occur fast enough.
5.2.7
ABORTING A TRANSMISSION
If any part of the I2C transmission does not meet the
command format, it is aborted. This can be intentionally
accomplished with a START or STOP condition. This is
done so that noisy transmissions (usually an extra
START or STOP condition) are aborted before they
corrupt the device.
5.2.8
IGNORING AN I2C TRANSMISSION
AND “FALLING OFF” THE BUS
The MCP4017/18/19 expects to receive entire, valid
I2C commands and will assume any command not
defined as a valid command is due to a bus corruption
and will enter a passive high condition on the SDA
signal. All signals will be ignored until the next valid
START condition and CONTROL BYTE are received.
FIGURE 5-7:
Typical 16-bit I2C Waveform Format.
FIGURE 5-8:
I2C Data States and Bit Sequence.
SCL
SDA A / A
P
1st
SDA
SCL
S
2nd 3rd 4th 5th 6th 7th 8th
P
A/A
Bit Bit Bit Bit Bit Bit Bit Bit
1st 2nd 3rd 4th 5th 6th 7th 8th A/A
Bit Bit Bit Bit Bit Bit Bit Bit
SCL
SDA
START
Condition
STOP
Condition
Data allowed
to change
Data or
A valid
相關PDF資料 |
PDF描述 |
|---|---|
| VI-221-MY-F4 | CONVERTER MOD DC/DC 12V 50W |
| VE-J7J-MZ | CONVERTER MOD DC/DC 36V 25W |
| MS3106A32-13S | CONN PLUG 23POS STRAIGHT W/SCKT |
| VI-22N-MW | CONVERTER MOD DC/DC 18.5V 100W |
| VE-J7H-MZ | CONVERTER MOD DC/DC 52V 25W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCP401XEV | 功能描述:數字電位計開發工具 MCP401X Evaluation Board RoHS:否 制造商:Arduino 產品:TinkerKit Rotary Potentiometers 工具用于評估:TinkerKit 電阻:4.7 kOhms 工作電源電壓:0 V to 5 V |
| MCP4021 | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:Low-Cost NV Digital POT with WiperLock⑩ Technology |
| MCP4021-103E/CH | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:Low-Cost NV Digital POT with WiperLock⑩ Technology |
| MCP4021-103E/MC | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:Low-Cost NV Digital POT with WiperLock⑩ Technology |
| MCP4021-103E/MS | 功能描述:數字電位計 IC 10k U/D single 6-bit NV POT RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。