- 您現在的位置：買賣IC網 > PDF目錄3763 > MCP2200T-I/SS (Microchip Technology)IC USB 2.0 - UART 20SSOP PDF資料下載
參數資料
| 型號： | MCP2200T-I/SS |
| 廠商： | Microchip Technology |
| 文件頁數： | 28/34頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC USB 2.0 - UART 20SSOP |
| 標準包裝： | 1,600 |
| 特點： | USB 至 UART |
| 通道數： | 8 |
| FIFO's： | 256 字節 |
| 規程： | USB 2.0 |
| 電源電壓： | 3 V ~ 5.5 V |
| 帶自動流量控制功能： | 是 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 20-SSOP（0.209"，5.30mm 寬） |
| 供應商設備封裝： | 20-SSOP |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁當前第28頁第29頁第30頁第31頁第32頁第33頁第34頁
PIC16F610/616/16HV610/616
DS41288F-page 34
2009 Microchip Technology Inc.
4.2
Additional Pin Functions
Every PORTA pin on the PIC16F610/616/16HV610/
616 has an interrupt-on-change option and a weak pull-
up option. The next three sections describe these
functions.
4.2.1
ANSEL REGISTER
The ANSEL register is used to configure the Input
mode of an I/O pin to analog. Setting the appropriate
ANSEL bit high will cause all digital reads on the pin to
be read as ‘0’ and allow analog functions on the pin to
operate correctly.
The state of the ANSEL bits has no affect on digital
output functions. A pin with TRIS clear and ANSEL set
will still operate as a digital output, but the Input mode
will be analog. This can cause unexpected behavior
when executing read-modify-write instructions on the
affected port.
4.2.2
WEAK PULL-UPS
Each of the PORTA pins, except RA3, has an
individually configurable internal weak pull-up. Control
bits WPUAx enable or disable each pull-up. Refer to
Register 4-4. Each weak pull-up is automatically turned
off when the port pin is configured as an output. The
pull-ups are disabled on a Power-on Reset by the
RAPU bit of the OPTION register). A weak pull-up is
automatically enabled for RA3 when configured as
MCLR and disabled when RA3 is an input. There is no
software control of the MCLR pull-up.
4.2.3
INTERRUPT-ON-CHANGE
Each PORTA pin is individually configurable as an
interrupt-on-change pin. Control bits IOCAx enable or
disable the interrupt function for each pin. Refer to
Register 4-5. The interrupt-on-change is disabled on a
Power-on Reset.
For enabled interrupt-on-change pins, the values are
compared with the old value latched on the last read of
PORTA. The ‘mismatch’ outputs of the last read are
OR’d together to set the PORTA Change Interrupt Flag
bit (RAIF) in the INTCON register (Register 2-3).
This interrupt can wake the device from Sleep. The
user, in the Interrupt Service Routine, clears the
interrupt by:
a)
Any read or write of PORTA. This will end the
mismatch condition, then,
b)
Clear the flag bit RAIF.
A mismatch condition will continue to set flag bit RAIF.
Reading PORTA will end the mismatch condition and
allow flag bit RAIF to be cleared. The latch holding the
last read value is not affected by a MCLR nor BOR
Reset. After these resets, the RAIF flag will continue to
be set if a mismatch is present.
Note:
If a change on the I/O pin should occur
when any PORTA operation is being
executed, then the RAIF interrupt flag may
not get set.
REGISTER 4-3:
ANSEL: ANALOG SELECT REGISTER
R/W-1
ANS7
ANS6
ANS5
ANS4
ANS3(2)
ANS2(2)
ANS1
ANS0
bit 7
bit 0
Legend:
R = Readable bit
W = Writable bit
U = Unimplemented bit, read as ‘0’
-n = Value at POR
‘1’ = Bit is set
‘0’ = Bit is cleared
x = Bit is unknown
bit 7-0
ANS<7:0>: Analog Select bits
Analog select between analog or digital function on pins AN<7:0>, respectively.
1
= Analog input. Pin is assigned as analog input(1).
0
= Digital I/O. Pin is assigned to port or special function.
Note 1:
Setting a pin to an analog input automatically disables the digital input circuitry, weak pull-ups, and
interrupt-on-change if available. The corresponding TRIS bit must be set to Input mode in order to allow
external control of the voltage on the pin.
2:
PIC16F616/HV616.
相關PDF資料 |
PDF描述 |
|---|---|
| MAX3111ECNI+G36 | IC UART SPI COMPAT 28-DIP |
| MAX3110ECNI+G36 | IC TXRX RS232 SPI W/CAP 28-DIP |
| ATMEGA164PA-MCHR | MCU AVR 16KB FLASH 20MHZ 44-VQFN |
| SC16C654BIBS,551 | IC UART QUAD W/FIFO 48-HVQFN |
| SC16C654BIBS,528 | IC QUAD UART 64BYTE 48HVQFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCP-220-51202-0N | 制造商:SUPER MICRO COMPUTER, INC. 功能描述:DVD KIT - Bulk |
| MCP-220-73201-0N | 制造商:Supermicro Computer Inc 功能描述:SC732 2.5INCH HDD CAGE - Bulk |
| MCP-220-81502-0N | 制造商:Supermicro Computer Inc 功能描述:Slim SATA DVD Kit 制造商:Supermicro Computer Inc 功能描述:SLIM SATA DVD KIT - Bulk 制造商:Supermicro Computer 功能描述: 制造商:Supermicro Computer 功能描述:Slim SATA DVD Kit |
| MCP-220-81601-0N | 制造商:SUPER MICRO COMPUTER, INC. 功能描述:SUPERMICRO 2.5-IN HDD BKT - Bulk |
| MCP-220-82504-0B | 制造商:SUPER MICRO COMPUTER, INC. 功能描述:SUPERMICRO PART - Bulk |
發布緊急采購，3分鐘左右您將得到回復。