- 您現在的位置：買賣IC網 > PDF目錄1953 > MCP2021A-330E/MD (Microchip Technology)IC TXRX LIN 3.3V LDO 8-DFN PDF資料下載
參數資料
| 型號： | MCP2021A-330E/MD |
| 廠商： | Microchip Technology |
| 文件頁數： | 2/48頁 |
| 文件大小： | 0K |
| 描述： | IC TXRX LIN 3.3V LDO 8-DFN |
| 產品培訓模塊： | Microchip MCP20xx LIN Transceiver Overview |
| 標準包裝： | 91 |
| 系列： | * |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁
MCP2021A/2A
DS22298A-page 10
2012 Microchip Technology Inc.
FIGURE 1-7:
VOLTAGE REGULATOR OUTPUT ON OVER-CURRENT SITUATION
1.5
Optional External Protection
1.5.1
REVERSE BATTERY PROTECTION
An external reverse-battery-blocking diode should be
used to provide polarity protection (see Figure 1-9).
1.5.2
TRANSIENT VOLTAGE
PROTECTION (LOAD DUMP)
An external 43V transient suppressor (TVS) diode,
between VBB and ground, with a transient protection
resistor (RTP) in series with the battery supply and the
VBB pin protects the device from power transients and
ESD events greater than 43V (see Figure 1-9). The
maximum value for the RTP protection resistor depends
upon two parameters: the minimum voltage the part will
start at, and the impacts of this RTP resistor on the VBB
value, thus on the Bus recessive level and slopes.
This leads to a set of three equations to fullfil.
the minimum battery voltage the user wants.
the maximum error on the recessive level, thus VBB,
since the part uses VBB as the reference value for the
recessive level.
the maximum relative variation the user can accept on
the slope when IREG varies.
Since both Equation 1-1 and Equation 1-2 must be
fulfilled, the maximum allowed value for RTP is thus the
smaller of the two values found when solving
Equation 1-1 and Equation 1-2.
Usually Equation 1-1 gives the higher constraint
(smaller value) for RTP as shown in the following exam-
ple where VBATmin is 8V.
However, the user needs to check that the value found
3 as well.
While this protection is optional, it should be
considered as good engineering practice.
Note 1: IREG less than llim, regulator on
2: After IREG exceeds llim, voltage regulator output will be reduced until
voltage regulator shutdown voltage VSD is reached.
VSD
0
(1)
(2)
t
0
t
llim
IREG
mA
VREG
V
VREG-NOM
1
2
3
4
5
6
相關PDF資料 |
PDF描述 |
|---|---|
| MCP2022PT-500E/ST | IC TXRX LIN ON-BOARD VREG 14TSSO |
| MCP2022T-330E/ST | IC LIN TXRX ON-BD VREG 14TSSOP |
| MCP2036T-I/MG | INTEGRATED CIRCUITS LINEAR - 82 |
| MCP2036T-I/ML | IC AFE KEYLESS ENTRY 16QFN |
| MCP2050-500E/SL | IC TXRX LIN 5.0V LDO/WWDT 14SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCP2021A-500E/MD | 功能描述:LIN 收發器 LIN Transceiver + 5.0V LDO RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
| MCP2021A-500E/SN | 功能描述:LIN 收發器 LIN Transceiver + 5.0V LDO RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
| MCP2021AT-330E/MD | 功能描述:LIN 收發器 LIN Transceiver + 3.3V LDO RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
| MCP2021AT-330E/SN | 功能描述:LIN 收發器 LIN Transceiver + 3.3V LDO RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
| MCP2021AT-500E/MD | 功能描述:LIN 收發器 LIN Transceiver + 5.0V LDO RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
發布緊急采購，3分鐘左右您將得到回復。