- 您現在的位置：買賣IC網 > PDF目錄383586 > MCP1700T-1202EMB (Microchip Technology Inc.) Low Quiescent Current LDO PDF資料下載
參數資料
| 型號： | MCP1700T-1202EMB |
| 廠商： | Microchip Technology Inc. |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | Low Quiescent Current LDO |
| 中文描述： | 低靜態電流低壓降穩壓器 |
| 文件頁數： | 10/24頁 |
| 文件大?。?/td> | 638K |
| 代理商： | MCP1700T-1202EMB |
MCP1700
DS21826B-page 10
2007 Microchip Technology Inc.
3.0
PIN DESCRIPTIONS
The descriptions of the pins are listed in
Table 3-1
.
TABLE 3-1:
PIN FUNCTION TABLE
3.1
Ground Terminal (GND)
Regulator ground. Tie GND to the negative side of the
output and the negative side of the input capacitor.
Only the LDO bias current (1.6 μA typical) flows out of
this pin; there is no high current. The LDO output
regulation is referenced to this pin. Minimize voltage
drops between this pin and the negative side of the
load.
3.2
Regulated Output Voltage (V
OUT
)
Connect V
OUT
to the positive side of the load and the
positive terminal of the output capacitor. The positive
side of the output capacitor should be physically
located as close to the LDO V
OUT
pin as is practical.
The current flowing out of this pin is equal to the DC
load current.
3.3
Unregulated Input Voltage Pin
(V
IN
)
Connect V
IN
to the input unregulated source voltage.
Like all low dropout linear regulators, low source
impedance is necessary for the stable operation of the
LDO. The amount of capacitance required to ensure
low source impedance will depend on the proximity of
the input source capacitors or battery type. For most
applications, 1 μF of capacitance will ensure stable
operation of the LDO circuit. For applications that have
load currents below 100 mA, the input capacitance
requirement can be lowered. The type of capacitor
used can be ceramic, tantalum or aluminum
electrolytic. The low ESR characteristics of the ceramic
will yield better noise and PSRR performance at high
frequency.
Pin No.
SOT-23
Pin No.
SOT-89
Pin No.
TO-92
Name
Function
1
1
1
GND
Ground Terminal
2
3
3
V
OUT
V
IN
Regulated Voltage Output
3
2
2
Unregulated Supply Voltage
相關PDF資料 |
PDF描述 |
|---|---|
| MCP1700T-1202ETO | Low Quiescent Current LDO |
| MCP1700T-1202ETT | Low Quiescent Current LDO |
| MCP1700T-1802EMB | Low Quiescent Current LDO |
| MCP1700T-1802ETT | Low Quiescent Current LDO |
| MCP1700T-2502EMB | Low Quiescent Current LDO |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCP1700T-1502E/MB | 功能描述:低壓差穩壓器 - LDO 250mA Adj LDO 2% RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| MCP1700T-1502E/TT | 功能描述:低壓差穩壓器 - LDO 250mA Adj LDO 2% RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| MCP1700T-1802E/MAY | 制造商:Microchip Technology Inc 功能描述:250MA CMOS LDO, ISUPPLY 1UA AND 2% VOUT ACCURACY - Tape and Reel 制造商:Microchip Technology Inc 功能描述:IC REG LDO 1.8V 0.2A 6DFN |
| MCP1700T-1802E/MB | 功能描述:低壓差穩壓器 - LDO 250mA Adj LDO 2% RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| MCP1700T-1802E/TT | 功能描述:低壓差穩壓器 - LDO 250mA Adj LDO 2% RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
發布緊急采購，3分鐘左右您將得到回復。