參數資料
型號: MC68HC05RC18FN
廠商: MOTOROLA INC
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PQCC44
封裝: PLASTIC, LCC-44
文件頁數: 60/124頁
文件大?。?/td> 457K
代理商: MC68HC05RC18FN
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁當前第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁
NON-DISCLOSURE
AGREEMENT
REQUIRED
Interrupts
General Release Specification
MC68HC05RC18 Rev. 2.0
40
Interrupts
MOTOROLA
4.3 CPU Interrupt Processing
Interrupts cause the processor to save register contents on the stack
and to set the interrupt mask (I bit) to prevent additional interrupts. Unlike
reset, hardware interrupts do not cause the current instruction execution
to be halted, but are considered pending until the current instruction is
complete.
If interrupts are not masked (I bit in the CCR is clear) when the CPU
receives an interrupt request, the processor will proceed with interrupt
processing. Otherwise, the next instruction is fetched and executed. If an
interrupt occurs, the processor completes the current instruction, stacks
the current CPU register state, sets the I bit to inhibit further interrupts,
and finally checks the pending hardware interrupts. If more than one
interrupt is pending after the stacking operation, the interrupt with the
highest vector location shown in Table 4-1 will be serviced first. The SWI
is executed the same as any other instruction, regardless of the I-bit
state.
When an interrupt is to be processed, the CPU fetches the address of
the appropriate interrupt software service routine from the vector table at
locations $3FF6–$3FFF as defined in Table 4-1.
The M68HC05 CPU does not support interruptible instructions. The
maximum latency to the first instruction of the interrupt service routine
must include the longest instruction execution time plus stacking
overhead.
Latency = (Longest instruction execution time + 10) x tcyc seconds
An RTI instruction is used to signify when the interrupt software service
routine is completed. The RTI instruction causes the register contents to
be recovered from the stack and normal processing to resume at the
next instruction that was to be executed when the interrupt took place.
Figure 4-1 shows the sequence of events that occurs during interrupt
processing.
相關PDF資料
PDF描述
MC68HC05RC18DW 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDSO28
MC68HC05SR3B 8-BIT, MROM, 2 MHz, MICROCONTROLLER, PDIP42
MC68HC705SR3CP 8-BIT, OTPROM, 2 MHz, MICROCONTROLLER, PDIP40
MC68HC705SR3CFB 8-BIT, OTPROM, 2 MHz, MICROCONTROLLER, PQFP44
MC68HC705SR3CB 8-BIT, OTPROM, 2 MHz, MICROCONTROLLER, PDIP42
相關代理商/技術參數
參數描述
MC68HC05RC8 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:General Release Specification
MC68HC05RC8DW 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:General Release Specification
MC68HC05RC8FN 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:General Release Specification
MC68HC05RC8P 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:General Release Specification
MC68HC05SC24 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Secure 8-bit microcomputer with EEPROM