參數資料
型號: MC56F8345MFGE
廠商: Freescale Semiconductor
文件頁數: 16/172頁
文件大小: 0K
描述: IC DSP 16BIT 60MHZ 128-LQFP
標準包裝: 72
系列: 56F8xxx
核心處理器: 56800E
芯體尺寸: 16-位
速度: 60MHz
連通性: CAN,EBI/EMI,SCI,SPI
外圍設備: POR,PWM,溫度傳感器,WDT
輸入/輸出數: 49
程序存儲器容量: 136KB(68K x 16)
程序存儲器類型: 閃存
RAM 容量: 6K x 16
電壓 - 電源 (Vcc/Vdd): 2.25 V ~ 3.6 V
數據轉換器: A/D 16x12b
振蕩器型: 外部
工作溫度: -40°C ~ 125°C
封裝/外殼: 128-LQFP
包裝: 托盤
配用: MC56F8367EVME-ND - EVAL BOARD FOR MC56F83X
56F8345 Technical Data, Rev. 17
112
Freescale Semiconductor
Preliminary
6.5.6.14
Reserved—Bit 2–0
This bit field is reserved or not implemented. It is read as 0 and cannot be modified by writing.
6.5.7
CLKO Select Register (SIM_CLKOSR)
The CLKO select register can be used to multiplex out any one of the clocks generated inside the clock
generation and SIM modules. The default value is SYS_CLK. This path has been optimized in order to
minimize any delay and clock duty cycle distortion. All other clocks primarily muxed out are for test
purposes only, and are subject to significant phase shift at high frequencies.
The upper four bits of the GPIOB register can function as GPIO, [A23:A20], or as additional clock output
signals. GPIO has priority and is enabled/disabled via the GPIOB_PER. If GPIOB[7:4] are programmed
to operate as peripheral outputs, then the choice between [A23:A20] and additional clock outputs is done
here in the CLKOSR. The default state is for the peripheral function of GPIOB[7:4] to be programmed as
[A23:A20]. This can be changed by altering [A23:A20], as shown in Figure 6-9.
Figure 6-9 CLKO Select Register (SIM_CLKOSR)
6.5.7.1
Reserved—Bits 15–10
This bit field is reserved or not implemented. It is read as 0 and cannot be modified by writing.
6.5.7.2
Alternate GPIO_B Peripheral Function for A23 (A23)—Bit 9
0 = Peripheral output function of GPIOB[7] is defined to be A[23]
1 = Peripheral output function of GPIOB[7] is defined to be the oscillator clock (MSTR_OSC, see
6.5.7.3
Alternate GPIO_B Peripheral Function for A22 (A22)—Bit 8
0 = Peripheral output function of GPIOB[6] is defined to be A[22]
1 = Peripheral output function of GPIOB[6] is defined to be SYS_CLK2
6.5.7.4
Alternate GPIO_B Peripheral Function for A21 (A21)—Bit 7
0 = Peripheral output function of GPIOB[5] is defined to be A[21]
1 = Peripheral output function of GPIOB[5] is defined to be SYS_CLK
6.5.7.5
Alternate GPIO_B Peripheral Function for A20 (A20)—Bit 6
0 = Peripheral output function of GPIOB[4] is defined to be A[20]
1 = Peripheral output function of GPIOB[4] is defined to be the prescaler clock (FREF, see Figure 3-4)
Base + $A
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
Read
0
A23
A22
A21
A20
CLK
DIS
CLKOSEL
Write
RESET
0
001
0
000
0
相關PDF資料
PDF描述
MC56F8346VFVE IC DSP 16BIT 60MHZ 144-LQFP
MC56F8366VFVE IC DSP 16BIT 60MHZ 144-LQFP
MC68020RC33E IC MICROPROCESSOR 32BIT 114-PGA
MC68030RC50C IC MPU 32BIT ENHANCED 128-PGA
MC68302EH20CR2 IC MPU NETWORK 20MHZ 132-PQFP
相關代理商/技術參數
參數描述
MC56F8345VFG60 功能描述:數字信號處理器和控制器 - DSP, DSC 60MHz 60MIPS RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
MC56F8345VFGE 功能描述:數字信號處理器和控制器 - DSP, DSC 16 BIT HYBRID CONTROLLER RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
MC56F8346 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:16-bit Digital Signal Controllers
MC56F8346EVM 制造商:Freescale Semiconductor 功能描述:Tools Development kit Kit Contents:Inst
MC56F8346MFV60 功能描述:數字信號處理器和控制器 - DSP, DSC 60MHz 60MIPS RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT