參數資料
型號: MC56F8322MFAE
廠商: Freescale Semiconductor
文件頁數: 61/136頁
文件大?。?/td> 0K
描述: IC DSP 16BIT 60MHZ 48-LQFP
標準包裝: 250
系列: 56F8xxx
核心處理器: 56800E
芯體尺寸: 16-位
速度: 60MHz
連通性: CAN,SCI,SPI
外圍設備: POR,PWM,溫度傳感器,WDT
輸入/輸出數: 21
程序存儲器容量: 40KB(20K x 16)
程序存儲器類型: 閃存
RAM 容量: 6K x 16
電壓 - 電源 (Vcc/Vdd): 2.25 V ~ 3.6 V
數據轉換器: A/D 6x12b
振蕩器型: 內部
工作溫度: -40°C ~ 125°C
封裝/外殼: 48-LQFP
包裝: 托盤
配用: MC56F8323EVME-ND - BOARD EVALUATION MC56F8323
56F8322 Techncial Data, Rev. 16
30
Freescale Semiconductor
Preliminary
3.3 Use of On-Chip Relaxation Oscillator
An internal relaxtion oscillator can supply the reference frequency when an external frequency source of
crystal is not used. During a boot or reset sequence, the relaxation oscillator is enabled by default, and the
PRECS bit in the PLLCR word is set to 0. If an external oscillator is connected, the relaxation oscillator
can be deselected instead by setting the PRECS bit in the PLLCR to 1. If a changeover between internal
and external oscillators is required at start up, internal device circuits compensate for any asynchronous
transitions between the two clock signals so that no glitches occur in the resulting master clock to the chip.
When changing clocks, the user must ensure that the clock source is not switched until the desired clock
is enabled and stable.
To compensate for variances in the device manufacturing process, the accuracy of the relaxation oscillator
can be incrementally adjusted to within + 0.1% of 8MHz by trimming an internal capacitor. Bits 0-9 of the
OSCTL (oscillator control) register allow the user to set in an additional offset (trim) to this preset value
to increase or decrease capacitance. Upon power-up, the default value of this trim is 512 units. Each unit
added or deleted changes the output frequency by about 0.1%, allowing incremental adjustment until the
desired frequency accuracy is achieved.
The internal oscillator is calibrated at the factory to 8MHz and the TRIM value is stored in the Flash
information block and loaded to the FMOPT1 register at reset. When using the relaxation oscillator, the
boot code should read the FMOPT1 register and set this value as OSCTL TRIM. For further information,
see the 56F8300 Peripheral User Manual.
3.4 Internal Clock Operation
At reset, both oscillators will be powered up; however, the relaxation oscillator will be the default clock
reference for the PLL. Software should power down the block not being used and program the PLL for the
correct frequency.
相關PDF資料
PDF描述
MC56F8146VFVE IC DSP 16BIT 40MHZ 144-LQFP
HCZ472MBCDJ0KR CAP CER 4700PF 3KV 20% RADIAL
VJ1812Y125JBAAT4X CAP CER 1.2UF 50V 5% X7R 1812
VJ1825Y155JBBAT4X CAP CER 1.5UF 100V 5% X7R 1825
VJ2225Y123JBCAT4X CAP CER 0.012UF 200V 5% X7R 2225
相關代理商/技術參數
參數描述
MC56F8322MFAER2 制造商:Freescale Semiconductor 功能描述:16 BIT HYBRID CONTROLLER - Tape and Reel
MC56F8322VFA60 功能描述:數字信號處理器和控制器 - DSP, DSC 60MHz 60MIPS RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
MC56F8322VFAE 功能描述:數字信號處理器和控制器 - DSP, DSC 16 BIT HYBRID CNTRLR RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
MC56F8322VFAER2 功能描述:數字信號處理器和控制器 - DSP, DSC 16 BIT HYBRID CNTRLR RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
MC56F8323 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:16-bit Digital Signal Controllers