- 您現在的位置：買賣IC網 > PDF目錄385567 > MC34151 (ON SEMICONDUCTOR) High Speed Dual MOSFET Drivers(高速雙MOSFET驅動器) PDF資料下載
參數資料
| 型號： | MC34151 |
| 廠商： | ON SEMICONDUCTOR |
| 英文描述： | High Speed Dual MOSFET Drivers(高速雙MOSFET驅動器) |
| 中文描述： | 高速雙MOSFET驅動器（高速雙MOSFET的驅動器） |
| 文件頁數： | 7/12頁 |
| 文件大?。?/td> | 174K |
| 代理商： | MC34151 |
MC34151, MC33151
http://onsemi.com
7
LAYOUT CONSIDERATIONS
High frequency printed circuit layout techniques are
imperative to prevent excessive output ringing and overshoot.
Do not attempt to construct the driver circuit on
wirewrap or plugin prototype boards.
When driving
large capacitive loads, the printed circuit board must contain
a low inductance ground plane to minimize the voltage spikes
induced by the high ground ripple currents. All high current
loops should be kept as short as possible using heavy copper
runs to provide a low impedance high frequency path. For
optimum drive performance, it is recommended that the
initial circuit design contains dual power supply bypass
capacitors connected with short leads as close to the V
CC
pin
and ground as the layout will permit. Suggested capacitors are
a low inductance 0.1 F ceramic in parallel with a 4.7 F
tantalum. Additional bypass capacitors may be required
depending upon Drive Output loading and circuit layout.
Proper printed circuit board layout is extremely
critical and cannot be over emphasized.
The MC34151 greatly enhances the drive capabilities of common switching
regulators and CMOS/TTL logic devices.
Figure 19. Enhanced System Performance with
Common Switching Regulators
Figure 20. MOSFET Parasitic Oscillations
Figure 21. Direct Transformer Drive
Figure 22. Isolated MOSFET Drive
Series gate resistor R
g
may be needed to damp high frequency parasitic
oscillations caused by the MOSFET input capacitance and any series
wiring inductance in the gatesource circuit. R
g
will decrease the
MOSFET switching speed. Schottky diode D
1
can reduce the driver’s
power dissipation due to excessive ringing, by preventing the output pin
from being driven below ground.
Output Schottky diodes are recommended when driving inductive loads at
high frequencies. The diodes reduce the driver’s power dissipation by
preventing the output pins from being driven above V
CC
and below ground.
+
V
CC
47
0.1
6
5.7V
TL494
or
TL594
2
4
3
1
1
7
5
V
in
+
+
+
+
+
+
1
1N5819
D
1
R
g
V
in
+
+
1
1
3
7
5
4 X
1N5819
+
+
+
+
3
1
1N
5819
Isolation
Boundary
相關PDF資料 |
PDF描述 |
|---|---|
| MC34166 | 500kHz and 1MHz High Efficiency 1.5A Switching Regulators; Package: SO; No of Pins: 8; Temperature Range: -40?°C to 85?°C |
| MC34167 | 500kHz and 1MHz High Efficiency 1.5A Switching Regulators; Package: SO; No of Pins: 8; Temperature Range: -40?°C to 85?°C |
| MC34262D | POWER FACTOR CONTROLLERS |
| MC34262P | POWER FACTOR CONTROLLERS |
| MC34262 | Power Factor Controllers(功率因數控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC34151_04 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:High Speed Dual MOSFET Drivers |
| MC34151_13 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:High Speed Dual MOSFET Drivers |
| MC34151D | 功能描述:功率驅動器IC 1.5A High Speed Dual RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| MC34151DG | 功能描述:功率驅動器IC 1.5A High Speed Dual Inverting MOSFET RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| MC34151DR2 | 功能描述:功率驅動器IC 1.5A High Speed Dual RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。