- 您現在的位置：買賣IC網 > PDF目錄382304 > MC33591 (Motorola, Inc.) PLL Tuned UHF Receiver for Data Transfer Applications PDF資料下載
參數資料
| 型號： | MC33591 |
| 廠商： | Motorola, Inc. |
| 英文描述： | PLL Tuned UHF Receiver for Data Transfer Applications |
| 中文描述： | 鎖相環調諧UHF接收器的數據傳輸應用 |
| 文件頁數： | 10/28頁 |
| 文件大?。?/td> | 699K |
| 代理商： | MC33591 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
CONFIGURATION REGISTERS
10
MC33591 Technical Data
MOTOROLA
bits may lead to unexpected configurations. The first bit transmitted on MOSI does not change the content of the
configuration registers. Note that a low level applied on RESETB does not affect the configuration register
content.
When RESETB is set to a high level, if Data Manager is enabled (DME=1), ROMEO2 becomes master and
sends received data on the MOSI line and the recovered clock on SCLK. It is then recommended that the MCU
SPI is set as slave. If the data received does not fit in an entire number of bytes, the data manager will fill the last
byte. If the data received constitute an whole number of bytes, the data manager may generate and send an
extra byte whose content is irrelevant. If DME=0, the SPI is disabled. Raw data is sent on the MOSI line.
When ROMEO2 SPI is changed from master (run mode) to slave (configuration mode) or from slave to
master, it is recommended that the MCU SPI is set as slave before the mode transition.
At power-on, the POR resets the internal registers. This defines the receiver default configuration (see gray
rows on tables 4, 7 & 8). In this configuration, the SPI is disabled and ROMEO2 sends raw data on the MOSI line.
This default configuration enables the circuit to operate as a standalone receiver without any external control.
After POR, RESETB forces a low level. Therefore an external pull-up resistor should be used in order to avoid
entering configuration mode.
Figure 12: Writing into configuration registers
Figure 13: Reading configuration registers
CONFIGURATION REGISTERS
Table 4 describes the
Configuration Register 1
(CR1).
Table 4: Configuration Register 1
bit 7
bit 6
bit 5
R/W
CF
MOD
1
1
0
bit 4
SOE
1
bit 3
SR1
0
bit 2
SR0
1
bit 1
DME
0
bit 0
HE
0
Bit name
Reset value
MOSI line
CR1
CR2
CR3
0
SCLK line
MCU (master)
ROMEO2
MOSI line
Don’t care
Don’t care
Don’t care
1
SCLK line
MCU (master)
ROMEO2
MCU (master)
ROMEO2
MISO line
CR2
CR3
CR1
1
F
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
.
相關PDF資料 |
PDF描述 |
|---|---|
| MC33591FTA | PLL Tuned UHF Receiver for Data Transfer Applications |
| MC33680 | 0.4W, 75V, 0.3A, SIGNAL DIODE, SOD123 |
| MC33680FTBR2 | Dual DC-DC Regulator for Electronic Organizer |
| MC33680FTB | Single Output LDO, 400mA, Fixed(2.85V), Low Noise, Fast Transient Response 8-MSOP -40 to 85 |
| MC33765DTB | Very Low Dropout/Ultra Low Noise 5 Outputs Voltage Regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC33591FTA | 功能描述:射頻接收器 315 434 MHz RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel |
| MC33591FTAE | 功能描述:射頻接收器 UHF RECEIVER RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel |
| MC33591FTAER2 | 功能描述:射頻接收器 UHF RECEIVER RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel |
| MC33591FTAR2 | 功能描述:IC RF RECEIVER 315,434MHZ 24LQFP RoHS:否 類別:RF/IF 和 RFID >> RF 接收器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS 產品變化通告:Product Discontinuation 09/Jan/2012 標準包裝:50 系列:* 頻率:850MHz ~ 2.175GHz 靈敏度:- 數據傳輸率 - 最大:- 調制或協議:- 應用:* 電流 - 接收:* 數據接口:PCB，表面貼裝 存儲容量:- 天線連接器:PCB，表面貼裝 特點:- 電源電壓:4.75 V ~ 5.25 V 工作溫度:0°C ~ 85°C 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤 |
| MC33591MOD315 | 功能描述:BOARD EVALUATION FOR MC33591 RX RoHS:否 類別:RF/IF 和 RFID >> 過時/停產零件編號 系列:- 標準包裝:1 系列:- 類型:用于 200/300 系列的歐盟開發套件 適用于相關產品:Zensys RF 模塊 所含物品:開發板，模塊，編程器，軟件，線纜，電源 其它名稱:703-1019Q3225667 |
發布緊急采購，3分鐘左右您將得到回復。