<menuitem id="x5no9"><dl id="x5no9"><legend id="x5no9"></legend></dl></menuitem>
<span id="x5no9"><input id="x5no9"><acronym id="x5no9"></acronym></input></span>
  • <rp id="x5no9"></rp>
    參數資料
    型號: MC33178DR2G
    廠商: ON SEMICONDUCTOR
    元件分類: 運動控制電子
    英文描述: Low Power, Low Noise Operational Amplifiers
    中文描述: DUAL OP-AMP, 4000 uV OFFSET-MAX, 3 MHz BAND WIDTH, PDSO8
    封裝: LEAD FREE, SOIC-8
    文件頁數: 12/19頁
    文件大?。?/td> 284K
    代理商: MC33178DR2G
    MC33178, MC33179
    http://onsemi.com
    12
    If a high source of resistance is used (R1 > 1.0 k ), a
    compensation capacitor equal to or greater than the input
    capacitance of the op amp (10 pF) placed across the
    feedback resistor (see Figure 35) can be used to neutralize
    that pole and prevent outer loop oscillation. Since the closed
    loop transient response will be a function of that
    capacitance, it is important to choose the optimum value for
    that capacitor. This can be determined by the following
    Equation:
    (1)
    CC
    (1
    [R1 R2])2
    CL(ZOR2)
    where: Z
    O
    is the output impedance of the op amp.
    For moderately high capacitive loads (500 pF < C
    L
    < 1500 pF) the addition of a compensation resistor on the
    order of 20 between the output and the feedback loop will
    help to decrease miller loop oscillation (see Figure 36). For
    high capacitive loads (C
    L
    > 1500 pF), a combined
    compensation scheme should be used (see Figure 37). Both
    the compensation resistor and the compensation capacitor
    affect the transient response and can be calculated for
    optimum performance. The value of C
    C
    can be calculated
    using Equation 1. The Equation to calculate R
    C
    is as follows:
    RC
    ZO
    (2)
    R1 R2
    Figure 35. Compensation for
    High Source Impedance
    Figure 36. Compensation Circuit for
    Moderate Capacitive Loads
    Figure 37. Compensation Circuit for
    High Capacitive Loads
    R2
    +
    R1
    Z
    L
    C
    C
    R2
    R
    C
    C
    L
    R1
    +
    R2
    C
    C
    R
    C
    C
    L
    R1
    +
    相關PDF資料
    PDF描述
    MC33178PG Low Power, Low Noise Operational Amplifiers
    MC33179DG Low Power, Low Noise Operational Amplifiers
    MC33179DR2 Low Power, Low Noise Operational Amplifiers
    MC33179DTBR2G Low Power, Low Noise Operational Amplifiers
    MC33179PG Low Power, Low Noise Operational Amplifiers
    相關代理商/技術參數
    參數描述
    MC33178DR2G-CUT TAPE 制造商:ON 功能描述:MC Series 2 V/us 36 V SMT Low Power Low Noise Operational Amplifier - SOIC-8
    MC33178P 功能描述:運算放大器 - 運放 2-18V Dual Low Power RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比(最小值):63 dB 輸入補償電壓:1 mV 輸入偏流(最大值):10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel
    MC33178PG 功能描述:運算放大器 - 運放 2-18V Dual Low Power Industrial Temp RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比(最小值):63 dB 輸入補償電壓:1 mV 輸入偏流(最大值):10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel
    MC33179 制造商:SPC Multicomp 功能描述:FUSE RESETTABLE RADIAL 1.1A 制造商:SPC Multicomp 功能描述:FUSE, PTC RESET, RADIAL, 90V, 1.1A 制造商:SPC Multicomp 功能描述:RESETTABLE FUSE RADIAL 1.1A 制造商:SPC Multicomp 功能描述:FUSE, PTC RESET, 90V, 1.1A, RADIAL; Holding Current:1.1A; Tripping Current:2.2A; Initial Resistance Max:0.38ohm; Operating Voltage:90V; Series:FRX; PTC Fuse Case:Radial Leaded; External Depth:3.1mm; Initial Resistance Min:0.15ohm ;RoHS Compliant: Yes
    MC33179 制造商:SPC Multicomp 功能描述:PTC Resettable Fuse