參數資料
型號: MC33065-L
廠商: ON SEMICONDUCTOR
英文描述: High Performance Dual Channel Current Mode Controllers
中文描述: 高性能雙通道電流模式控制器
文件頁數: 9/18頁
文件大?。?/td> 583K
代理商: MC33065-L
MC34065
H, L
http://onsemi.com
9
When designing a high power switching regulator it may
be desirable to reduce the internal clamp voltage in order to
keep the power dissipation of R
S
to a reasonable level. A
simple method to adjust this voltage is shown in Figure 19.
The two external diodes are used to compensate the internal
diodes, yielding a constant clamp voltage over temperature.
Erratic operation due to noise pickup can result if there is an
excessive reduction of the I
pk(max)
clamp voltage.
A narrow spike on the leading edge of the current
waveform can usually be observed and may cause the power
supply to exhibit an instability when the output is lightly
loaded. This spike is due to the power transformer
interwinding capacitance and output rectifier recovery time.
The addition of an RC filter on the Current Sense input with
a time constant that approximates the spike duration will
usually eliminate the instability, refer to Figure 24.
Undervoltage Lockout
Two Undervoltage Lockout comparators have been
incorporated to guarantee that the IC is fully functional
before the output stages are enabled. The positive power
supply terminal (V
CC
) and the reference output (V
ref
) are
each monitored by separate comparators. Each has built
in
hysteresis to prevent erratic output behavior as their
respective thresholds are crossed. The V
CC
comparator
upper and lower thresholds are 14 V/10 V for
H suffix, and
8.4 V/7.6 V for
L suffix. The V
ref
comparator upper and
lower thresholds are 3.6 V/3.4 V respectively. The large
hysteresis and low startup current of the
H suffix version
makes it ideally suited in off
line converter applications
where efficient bootstrap startup techniques are required
(Figure 28). The
L suffix version is intended for lower
voltage dc
to
dc converter applications. The minimum
operating voltage for the
H suffix is 11 V and 8.2 V for the
L suffix.
Drive Outputs and Drive Ground
Each section contains a single totem
pole output stage
that is specifically designed for direct drive of power
MOSFETs. The Drive Outputs are capable of up to
±
400 mA
peak current with a typical rise and fall time of 50 ns with a
1.0 nF load. Additional internal circuitry has been added to
keep the outputs in a sinking mode whenever an
Undervoltage Lockout is active. This characteristic
eliminates the need for an external pull
down resistor. The
totem
pole output has been optimized to minimize
cross
conduction current in high speed operation. The
addition of two 10
Ω
resistors, one in series with the source
output transistor and one in series with the sink output
transistor, reduces the cross
conduction current to minimal
levels, as shown in Figure 13.
Although the Drive Outputs were optimized for
MOSFETs, they can easily supply the negative base current
required by bipolar NPN transistors for enhanced turn
off
(Figure 25).
相關PDF資料
PDF描述
MC33067DWG High Performance Resonant Mode Controllers
MC33067DWR2 High Performance Resonant Mode Controllers
MC33067DWR2G High Performance Resonant Mode Controllers
MC33067PG High Performance Resonant Mode Controllers
MC33151DR2G High Speed Dual MOSFET Drivers
相關代理商/技術參數
參數描述
MC33065P 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:HIGH PERFORMANCE DUAL CHANNEL CURRENT MODE CONTROLLER
MC33065P-H 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:High Performance Dual Channel Current Mode Controllers
MC33065P-L 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:High Performance Dual Channel Current Mode Controllers
MC33066 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:High Performance Resonant Mode Controllers
MC33066DW 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:HIGH PERFORMANCE RESONANT MODE CONTROLLERS