- 您現在的位置：買賣IC網 > PDF目錄2012 > MC14541BFG (ON Semiconductor)IC OSC PROG TIMER 3MHZ 14SOEIAJ PDF資料下載
參數資料
| 型號： | MC14541BFG |
| 廠商： | ON Semiconductor |
| 文件頁數： | 7/10頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OSC PROG TIMER 3MHZ 14SOEIAJ |
| 產品變化通告： | 1Q2012 Discontinuation 30/Mar/2012 |
| 標準包裝： | 50 |
| 類型： | 可編程計時器 |
| 頻率： | 3MHz |
| 電源電壓： | 3 V ~ 18 V |
| 電流 - 電源： | 15µA |
| 工作溫度： | -55°C ~ 125°C |
| 封裝/外殼： | 14-SOIC（0.209"，5.30mm 寬） |
| 包裝： | 管件 |
| 供應商設備封裝： | SOEIAJ-14 |
| 安裝類型： | 表面貼裝 |
MC14541B
http://onsemi.com
6
TYPICAL RC OSCILLATOR CHARACTERISTICS
Figure 4. RC Oscillator Stability
Figure 5. RC Oscillator Frequency as a
Function of Rtc and Ctc
8.0
4.0
0
-4.0
-8.0
-12
-16
125
100
75
50
25
0
-25
-55
TA, AMBIENT TEMPERATURE (°C)
FREQUENCY
DEVIA
TION
(%)
VDD = 15 V
10 V
5.0 V
RS = 0, f = 10.15 kHz @ VDD = 10 V, TA = 25°C
RS = 120 kW, f = 7.8 kHz @ VDD = 10 V, TA = 25°C
RTC = 56 kW,
C = 1000 pF
100
0.1
0.2
0.5
1.0
2.0
5.0
10
20
50
1.0 k
10 k
100 k
1.0 m
f,OSCILLA
T
OR
FREQUENCY
(kHz)
RTC, RESISTANCE (OHMS)
0.0001
0.001
0.01
0.1
C, CAPACITANCE (
mF)
VDD = 10 V
f AS A FUNCTION
OF RTC
(C = 1000 pF)
(RS ≈ 2RTC)
f AS A FUNCTION
OF C
(RTC = 56 kW)
(RS = 120 kW)
OPERATING CHARACTERISTICS
With Auto Reset pin set to a “0” the counter circuit is
initialized by turning on power. Or with power already on,
the counter circuit is reset when the Master Reset pin is set
to a “1”. Both types of reset will result in synchronously
resetting all counter stages independent of counter state.
Auto Reset pin when set to a “1” provides a low power
operation.
The RC oscillator as shown in Figure 3 will oscillate with
a frequency determined by the external RC network i.e.,
if (1 kHz v f v 100 kHz)
2.3 RtcCtc
1
f =
and RS ≈ 2 Rtc
where RS ≥ 10 kW
The time select inputs (A and B) provide a twobit address
to output any one of four counter stages (28, 210, 213 and
216). The 2n counts as shown in the Frequency Selection
Table represents the Q output of the Nth stage of the counter.
When A is “1”, 216 is selected for both states of B. However,
when B is “0”, normal counting is interrupted and the 9th
counter stage receives its clock directly from the oscillator
(i.e., effectively outputting 28).
The Q/Q select output control pin provides for a choice of
output level. When the counter is in a reset condition and
Q/Q select pin is set to a “0” the Q output is a “0”,
correspondingly when Q/Q select pin is set to a “1” the Q
output is a “1”.
When the mode control pin is set to a “1”, the selected
count is continually transmitted to the output. But, with
mode pin “0” and after a reset condition the RS flipflop (see
Expanded Block Diagram) resets, counting commences,
and after 2n1 counts the RS flipflop sets which causes the
output to change state. Hence, after another 2n1 counts the
output will not change. Thus, a Master Reset pulse must be
applied or a change in the mode pin level is required to reset
the single cycle operation.
DIGITAL TIMER APPLICATION
Rtc
Ctc
NC
RS
AR
MR
INPUT
tMR
VDD
B
A
N.C.
OUTPUT
VDD
MODE
Q/Q
t + tMR
1
2
3
4
5
6
78
9
10
11
12
13
14
When Master Reset (MR) receives a positive pulse, the
internal counters and latch are reset. The Q output goes high
and remains high until the selected (via A and B) number of
clock pulses are counted, the Q output then goes low and
remains low until another input pulse is received.
This “one shot” is fully retriggerable and as accurate as the
input frequency. An external clock can be used (pin 3 is the
clock input, pins 1 and 2 are outputs) if additional accuracy
is needed.
Notice that a setup time equal to the desired pulse width
output is required immediately following initial power up,
during which time Q output will be high.
相關PDF資料 |
PDF描述 |
|---|---|
| MC145423EJ | IC TXRX UDLT/ISDN 28-TSSOP |
| MC145481ENR2 | IC CODEC-FILTER PCM 3V 20-SSOP |
| MC145483EGR2 | IC CODEC-FILTER PCM 3V 20-SOIC |
| MC145484ENR2 | IC CODEC-FILTER PCM 5V 20-SSOP |
| MC145572AAC | IC TRANSCEIVER ISDN 44-LQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC14541BFL1 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MC145423DT | 功能描述:IC TXRX UDLT/ISDN 28TSSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| MC145423EG | 制造商:Freescale Semiconductor 功能描述:DATACOM, DIGITAL SLIC, 28 Pin Plastic SMT |
| MC145423EGR2 | 制造商:Freescale Semiconductor 功能描述:DATACOM, DIGITAL SLIC, 28 Pin Plastic SMT |
| MC145423EJ | 功能描述:IC TXRX UDLT/ISDN 28-TSSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:25 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:4.5 V ~ 5.5 V 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 供應商設備封裝:16-PDIP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。