
MB91460D Series
137
2.8
2008-06-20
Corrected missing bullets on PDF pages 2+3
Pin Assignment, Block Diagram:
Corrected naming and assignments of TTG inputs, SGO and DACKX0
Notes on PS register: Re-formatted for better understanding
ADC Characteristics: Offset between ADC channels is max. 4 LSB
DC Characteristics: Added ILVI (ICC of internal low voltage detection),
renamed ILV into ILVE (for external low voltage detection)
AC Characteristics for external bus: Added notes that the usage of external
feedback MCLKO --> MCLKI is not recommended.
Flash parallel programming mode:
Added notes about the pins to be set fix-0 / fix-1 (MD_2:0,...)
Added section about the wait times after power on
Flash operation modes:
Added note about the BootROM fuction entry address for operation
mode switch.
Package Dimension: Updated package drawing
All pages: Corrected typos and formatting bugs found by FJ proofread
2.9
2008-06-30
EMBEDDED PROGRAM/DATA MEMORY (FLASH): Corrected "The opera-
tion mode of the flash memory ..." instead of "of the MCU"
2.10
2008-08-04
Resources,Product lineup: Added Supply Supervisor (Low voltage detection)
DC Characteristics: Updated pull-up/pull-down resistance values,
updated and re-numbered the table footnotes
2.11
2008-08-18
Interrupt Vector Table: corrected the footnotes
Flash Security: Corrected the sector assignments of FSV1/FSV2 bits
Electrical Characteristics: removed the note that analog input/output
pins cannot accept +B signal input.
Ordering information: updated the part numbers
All pages: Kilobytes are now written with "K"
3.0
2009-04-20
Added Ta=125
°C characteristics
IO-Map: Renamed registers IORW0,1,2 into IOWR0,1,2 to match the
naming in hardware manual
3.1
2009-05-26
DC Characteristics: ICCH (RTC mode) at 32kHz is the same as at 100kHz
3.2
2009-06-24
Introduced max. ambient temperature TA(max), defined in ordering information.
Ordering information:
Added MB91F467DBHPVSR-GSE2 and MB91F465DAPVSR-GSE2.
Features, Internal peripheral resources: Removed DMA fly-by transfer
support (there are no IOWRX, IORDX pins on MB91460D series).
IO-Map: Added register IOWR3 at address 0x067B.
Recommended operating conditions:
Corrected “Look-up time PLL” into “Lock-up time PLL”.
DC Characteristics,
Output "L" voltage: Condition is "IOL" (not IOH).
Corrected table footnote nr.8 that the I2C pin current is added to the
current on VDD5 (not on ICCH).
Memory Map, Flash memory and external bus area:
SA4 to SA7 are available on MB91F467Dx and F465DA too.
Version
Date
Remark