- 您現在的位置：買賣IC網 > PDF目錄17100 > MAXQ7670EVKIT+ (Maxim Integrated Products)KIT EVAL FOR MAXQ7670 PDF資料下載
參數資料
| 型號： | MAXQ7670EVKIT+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 18/38頁 |
| 文件大?。?/td> | 0K |
| 描述： | KIT EVAL FOR MAXQ7670 |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 1 |
| 系列： | MAXQ® |
| 類型： | MCU |
| 適用于相關產品： | MAXQ7670 |
| 所含物品： | 板 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁
MAXQ7670
Microcontroller with 10-Bit ADC,
PGA, 64KB Flash, and CAN Interface
______________________________________________________________________________________
25
frequency is limited to SYSCLK/2 in master mode and
SYSCLK/8 in slave mode. Figure 10 shows the function-
al diagram of the SPI port. Figures 1 and 2 illustrate the
timing parameters listed in the
Electrical Characteristics
table.
General-Purpose Digital I/Os
The MAXQ7670 provides seven general-purpose digital
I/Os (GPIOs). Some of the GPIOs include an additional
special function (SF), such as a timer input/output. For
example, the state of P0.6/T0 is programmable to
depend on timer channel 0 logic. When used as a port,
each I/O is configurable for high-impedance, weak
pullup to DVDDIO or pulldown to GNDIO. At power-up,
each GPIO is configured as an input with a pullup to
DVDDIO. In addition, each GPIO can be programmed
to cause an interrupt (on falling or rising edges). In stop
mode, use any interrupt to wake-up the device.
The port direction (PD) register determines the
input/output direction of each I/O. The port output (PO)
register contains the current state of the logic output
buffers. When an I/O is configured as an output, writing
to the PO register controls the output logic state.
Reading the PO register shows the current state of the
output buffers, independent of the data direction. The
port input (PI) register is a read-only register that
always reflects the logic state of the I/Os.
SFR DATA BUS
READ BUFFER
SHIFT REGISTER
LSB(0)
MSB (15)
MISO
MASTER
SLAVE
SPI CONTROL UNIT
SYSCLK
SPI INTERRUPT
/2 MASTER (MAX)
/8 SLAVE (MAX)
SHIFT CLK
0
7
SPI CONTRL REG (SPICN)
SPI CONTRL REG (SPICF)
SPI CONTRL REG (SPICK)
MASTER/SLAVE SELECT
SCLK OUT
SCLK IN
SPI ENABLE
MASTER
MOSI
SCLK
DVDDIO
SLAVE
MASTER
MAXQ7670
SS
Figure 10. SPI Functional Diagram
相關PDF資料 |
PDF描述 |
|---|---|
| EBC28DRYS | CONN EDGECARD 56POS DIP .100 SLD |
| EBC26DRYI | CONN EDGECARD 52POS DIP .100 SLD |
| SCRH6D28-100 | INDUCTOR SMD 10UH 1.70A 10KHZ |
| EEC43DRTS | CONN EDGECARD 86POS DIP .100 SLD |
| EBC31DRTS | CONN EDGECARD 62POS DIP .100 SLD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAXQ7670EVKIT+ | 功能描述:開發板和工具包 - 其他處理器 MAXQ7670 Eval Kit RoHS:否 制造商:Freescale Semiconductor 產品:Development Systems 工具用于評估:P3041 核心:e500mc 接口類型:I2C, SPI, USB 工作電源電壓: |
| MAXQ8913 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:16-Bit, Mixed-Signal Microcontroller with Op Amps, ADC, and DACs for All-in-One Servo Loop Control |
| MAXQ8913EWG+T | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:16-Bit, Mixed-Signal Microcontroller with Op Amps, ADC, and DACs for All-in-One Servo Loop Control |
| MAXQ8913EWG-T&R+ | 制造商:Maxim Integrated Products 功能描述:MAXQ8913 IMAGE STABILIZER WLF T&R - Gel-pak, waffle pack, wafer, diced wafer on film |
| MAXQ8913X-0000+ | 功能描述:16位微控制器 - MCU 16-Bit Mxd Sgnl MCU w/Op Amp ADC & DAC RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。