參數資料
型號: MAX9724BEBC+TG45
廠商: Maxim Integrated Products
文件頁數: 3/19頁
文件大小: 0K
描述: IC AMP AUDIO .045W STER 12UCSP
產品培訓模塊: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝: 2,500
系列: DirectDrive®
類型: AB 類
輸出類型: 耳機,2-通道(立體聲)
在某負載時最大輸出功率 x 通道數量: 45mW x 2 @ 32 歐姆
電源電壓: 2.7 V ~ 5.5 V
特點: 消除爆音,短路保護和熱保護,關閉
安裝類型: 表面貼裝
供應商設備封裝: 12-UCSP(3x4)
封裝/外殼: 12-WFBGA,WLCSP
包裝: 帶卷 (TR)
配用: MAX9724AEVKIT+-ND - EVALUATION KIT FOR MAX9724A/B
MAX9724DEVKIT+-ND - KIT EVAL FOR MAX9724D
其它名稱: MAX9724BEBC+T
MAX9724BEBC+T-ND
MAX9724A/MAX9724B
60mW, DirectDrive, Stereo Headphone Amplifier
with Low RF Susceptibility and Shutdown
______________________________________________________________________________________
11
°C/W as specified in the
Absolute Maximum Ratings
section. For example,
θJA of the thin QFN package is
+68°C/W, and 154.2°C/W for the UCSP package.
The MAX9724A/MAX9724B have two power dissipation
sources; a charge pump and the two output amplifiers.
If power dissipation for a given application exceeds the
maximum allowed for a particular package, reduce
VDD, increase load impedance, decrease the ambient
temperature, or add heatsinking to the device. Large
output, supply, and ground traces decrease
θJA, allow-
ing more heat to be transferred from the package to the
surrounding air.
Thermal-overload protection limits total power dissipa-
tion in the MAX9724A/MAX9724B. When the junction
temperature exceeds +150°C, the thermal protection
circuitry disables the amplifier output stage. The ampli-
fiers are enabled once the junction temperature cools
by approximately 12°C. This results in a pulsing output
under continuous thermal-overload conditions.
Output Dynamic Range
Dynamic range is the difference between the noise floor
of the system and the output level at 1% THD+N.
Determine the system’s dynamic range before setting the
maximum output gain. Output clipping occurs if the out-
put signal is greater than the dynamic range of the sys-
tem. The DirectDrive architecture of the MAX9724A/
MAX9724B has increased the dynamic range compared
to other single-supply amplifiers.
Maximum Output Swing
VDD < 4.35V
If the output load impedance is greater than 1kΩ, the
MAX9724A/MAX9724B can swing within a few millivolts
of their supply rail. For example, with a 3.3V supply, the
output swing is 2VRMS, or 2.83V peak while maintaining
a low 0.003% THD+N. If the supply voltage drops to
3V, the same 2.83V peak has only 0.05% THD+N.
VDD > 4.35V
Internal device structures limit the maximum voltage
swing of the MAX9724A/MAX9724B when operated at
supply voltages greater than 4.35V. The output must not
be driven such that the peak output voltage exceeds the
opposite supply voltage by 9V. For example, if VDD =
5V, the charge pump sets PVSS = -5V. Therefore, the
peak output swing must be less than ±4V to prevent
exceeding the absolute maximum ratings.
UVLO
The MAX9724A/MAX9724B feature an undervoltage
lockout (UVLO) function that prevents the device from
operating if the supply voltage is less than 2.7V. This fea-
ture ensures proper operation during brownout condi-
tions and prevents deep battery discharge. Once the
supply voltage exceeds the UVLO threshold, the
MAX9724A/MAX9724B charge pump is turned on and
the amplifiers are powered, provided that SHDN is high.
Component Selection
Input-Coupling Capacitor
The input capacitor (CIN), in conjunction with the input
resistor (RIN), forms a highpass filter that removes the
DC bias from an incoming signal (see the
Functional
Diagram/Typical Operating Circuits). The AC-coupling
capacitor allows the device to bias the signal to an opti-
mum DC level. Assuming zero-source impedance, the -
3dB point of the highpass filter is given by:
Choose the CIN such that f-3dB is well below the lowest
frequency of interest. Setting f-3dB too high affects the
device’s low-frequency response. Use capacitors
whose dielectrics have low-voltage coefficients, such
as tantalum or aluminum electrolytic. Capacitors with
high-voltage coefficients, such as ceramics, can result
in increased distortion at low frequencies.
Charge-Pump Capacitor Selection
Use ceramic capacitors with a low ESR for optimum
performance. For optimal performance over the extend-
ed temperature range, select capacitors with an X7R
dielectric. Table 2 lists suggested manufacturers.
Flying Capacitor (C1)
The value of the flying capacitor (see the
Functional
Diagram/Typical Operating Circuits) affects the charge
f
RC
dB
IN IN
=
3
1
2
π
SUPPLIER
PHONE
FAX
WEBSITE
Taiyo Yuden
800-348-2496
847-925-0899
www.t-yuden.com
TDK
847-803-6100
847-390-4405
www.component.tdk.com
Murata
770-436-1300
770-436-3030
www.murata.com
Table 2. Suggested Capacitor Manufacturers
相關PDF資料
PDF描述
D38999/20WA98BA CONN HSG RCPT 3POS WALL MT SCKT
V150A48C500BL CONVERTER MOD DC/DC 48V 500W
MAX4410EBE+T IC AMP AUDIO .08W STER AB 16UCSP
LTC1199IS8 IC ADC 10BIT 450KHZ W/SD 8-SOIC
MS27484T10F99PLC CONN HSG PLUG 7POS STRGHT PINS
相關代理商/技術參數
參數描述
MAX9724BETC 制造商:Maxim Integrated Products 功能描述:- Rail/Tube
MAX9724BETC+ 功能描述:音頻放大器 60mW DirectDrive Headphone Amplifier RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
MAX9724BETC+G126 功能描述:音頻放大器 Low RF Susceptibility DirectDrive Stereo Headphone Amplifier with 1.8V Compatible Shutdown RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
MAX9724BETC+T 功能描述:音頻放大器 60mW DirectDrive Headphone Amplifier RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
MAX9724BETC+TG126 功能描述:音頻放大器 60mW DirectDrive Stereo Headphone Amplifier with Low RF Susceptibility and Shutdown RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel