- 您現在的位置：買賣IC網 > PDF目錄8562 > MAX9503GETE+T (Maxim Integrated Products)IC VIDEO AMP W/FILTER 16-TQFN PDF資料下載
參數資料
| 型號： | MAX9503GETE+T |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 12/13頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC VIDEO AMP W/FILTER 16-TQFN |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 1 |
| 系列： | DirectDrive® |
| 應用： | 濾波器 |
| 電路數： | 1 |
| 電流 - 電源： | 12mA |
| 電流 - 輸出 / 通道： | 50mA |
| 電壓 - 電源，單路/雙路(±)： | 2.7 V ~ 3.6 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 16-TQFN-EP（3x3） |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 1392 (CN2011-ZH PDF) |
| 其它名稱： | MAX9503GETE+TDKR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁
MAX9503
Detailed Description
The MAX9503 completely eliminates the need for
capacitors in the video output by using Maxim’s
DirectDrive technology that includes an inverting charge
pump and linear regulator. The charge pump and linear
regulator create a clean negative supply allowing the
amplifier output to swing below ground. The amplifier
output can swing both positive and negative so that the
video signal black level can be placed at ground. The
MAX9503 features a six-pole, Butterworth filter to per-
form reconstruction filtering on the video input signal
from the DAC.
DirectDrive
Background
Integrated video filter/amplifier circuits operating from a
single, positive supply usually create video output sig-
nals that are level-shifted above ground to keep the
signal within the linear range of the output amplifier. For
applications in which the positive DC level shift of the
video signal is not acceptable, a series capacitor can
be inserted in the output connection in an attempt to
eliminate the positive DC level shift. The series capaci-
tor cannot truly level shift a video signal because the
average level of the video varies with picture content.
The series capacitor biases the video output signal
around ground, but the actual level of the video signal
can vary significantly depending upon the RC time con-
stant and the picture content.
The series capacitor creates a highpass filter. Since
the lowest frequency in video is the frame rate, which
can be between 24Hz and 30Hz, the pole of the high-
pass filter should ideally be an order of magnitude
lower in frequency than the frame rate. Therefore, the
series capacitor must be very large, typically from
220F to 3000F. For space-constrained equipment,
the series capacitor is unacceptable. Changing from a
single series capacitor to a SAG network that requires
two smaller capacitors can only reduce space and
cost slightly.
The series capacitor in the usual output connection
also prevents damage to the output amplifier if the con-
nector is shorted to a supply or to ground. While the
output connection of the MAX9503 does not have a
series capacitor, the MAX9503 will not be damaged if
the connector is shorted to a supply or to ground (see
the Short-Circuit Protection section).
Video Amplifier
Typically, the black level of the video signal created by
the video DAC is around 300mV. The MAX9503 shifts
the black level to ground at the output so that the active
video is above ground, and sync is below ground. The
amplifier needs a negative supply for its output stage to
remain in its linear region when driving sync below
ground.
DirectDrive Video Amplifier with
Reconstruction Filter
8
_______________________________________________________________________________________
Pin Description
PIN
QSOP
TQFN
NAME
FUNCTION
115
VSS
Negative Power Supply. Connect to CPVSS.
216
CPVSS
Charge-Pump Negative Power Supply. Bypass with a 1F capacitor to CPGND.
3
1
C1N
Charge-Pump Flying Capacitor Negative Terminal. Connect a 1F capacitor from C1P to C1N.
42
CPGND
Charge-Pump Power Ground
5
3
C1P
Charge-Pump Flying Capacitor Positive Terminal. Connect a 1F capacitor from C1P to C1N.
64
CPVDD
Charge-Pump Positive Power Supply. Bypass with a 1F capacitor to CPGND.
7
5
BIAS
Common-Mode Voltage. Connect a 100k
Ω resistor from BIAS to SGND.
86
SGND
Signal Ground. Connect to GND.
9
7
VIDIN
Video Input
10, 14, 15
8, 12, 14
N.C.
No Connection. Not internally connected. Connect to SGND.
11
9
SHDN
Active-Low Shutdown. Connect to VDD for normal operation.
12
10
GND
Ground. Connect to SGND.
13
11
VDD
Positive Power Supply. Bypass with a 1F capacitor to SGND.
13
VIDOUT
Video Output
—
EP
Exposed Paddle. Connect to GND.
相關PDF資料 |
PDF描述 |
|---|---|
| MAX9503MEEE+ | IC AMP VIDEO W/FILTER 16-QSOP |
| AD9779BSVZRL | IC DAC 16BIT DUAL 1GSPS 100TQFP |
| MAX9503GEEE+ | IC AMP VIDEO W/FILTER 16-QSOP |
| MAX9507ATE+ | IC DIRECTDRIVE FILTER AMP 16TQFN |
| AD7549JP | IC DAC 12BIT DUAL LC2MOS 20-PLCC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX9503GEVKIT | 功能描述:視頻放大器 Evaluation Kit for the MAX9503G MAX9503M MAX9505 RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
| MAX9503MEEE | 功能描述:視頻放大器 RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
| MAX9503MEEE+ | 功能描述:視頻放大器 DirectDrive Video Amplifier RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
| MAX9503MEEE+T | 功能描述:視頻放大器 DirectDrive Video Amplifier RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
| MAX9503MEEE-T | 功能描述:視頻放大器 RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。