- 您現在的位置：買賣IC網 > PDF目錄383512 > MAX8726EUE (MAXIM INTEGRATED PRODUCTS INC) Triple-Output TFT-LCD DC-DC Converters PDF資料下載
參數資料
| 型號： | MAX8726EUE |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | Triple-Output TFT-LCD DC-DC Converters |
| 中文描述： | 2 A SWITCHING REGULATOR, 1250 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | 4.40 MM, 1.10 MM HEIGHT, 0.65 MM PITCH, MO-153-AB, TSSOP-16 |
| 文件頁數： | 8/16頁 |
| 文件大小： | 640K |
| 代理商： | MAX8726EUE |
M
Triple-Output TFT-LCD
DC-DC Converters
8
_______________________________________________________________________________________
Detailed Description
The MAX1748/MAX8726 are highly efficient triple-output
power supplies for TFT-LCD applications. These devices
contain one high-power step-up converter and two low-
power charge pumps. The primary boost converter uses
an internal n-channel MOSFET to provide maximum
efficiency and to minimize the number of external compo-
nents. The output voltage of the main boost converter
(V
MAIN
) can be set from V
IN
to 13V with external resistors.
The dual charge pumps independently regulate a posi-
tive output (V
POS
) and a negative output (V
NEG
). These
low-power outputs use external diode and capacitor
stages (as many stages as required) to regulate output
voltages up to +40V and down to -40V. A proprietary
regulation algorithm minimizes output ripple as well as
capacitor sizes for both charge pumps.
Also included in the MAX1748/MAX8726 is a precision
1.25V reference that sources up to 50μA, logic shut-
down, soft-start, power-up sequencing, fault detection,
and an active-low open-drain ready output.
Main Boost Converter
The MAX1748/MAX8726 main step-up converter
switches at a constant 1MHz internal oscillator frequen-
cy to allow the use of small inductors and output
capacitors. The MOSFET switch pulse width is modulat-
ed to control the power transferred on each switching
cycle and to regulate the output voltage.
During PWM operation, the internal clock’s rising edge
sets a flip-flop, which turns on the n-channel MOSFET
(Figure 1). The switch turns off when the sum of the
voltage-error, slope-compensation, and current-feed-
back signals trips the multi-input comparator and
resets the flip-flop. The switch remains off for the rest of
the clock cycle. Changes in the output-voltage error
signal shift the switch current trip level, consequently
modulating the MOSFET duty cycle.
Dual Charge-Pump Regulator
The MAX1748/MAX8726 contain two individual low-
power charge pumps. One charge pump inverts the
supply voltage (SUPN) and provides a regulated nega-
tive output voltage. The second charge pump doubles
the supply voltage (SUPP) and provides a regulated
positive output voltage. The MAX1748/MAX8726 con-
tain internal p-channel and n-channel MOSFETs to con-
trol the power transfer. The internal MOSFETs switch at
a constant 500kHz (0.5 xf
OSC
).
Negative Charge Pump
During the first half-cycle, the p-channel MOSFET turns
on and the flying capacitor C5 charges to V
SUPN
minus a
diode drop (Figure 2). During the second half-cycle, the
p-channel MOSFET turns off, and the n-channel MOSFET
turns on, level shifting C5. This connects C5 in parallel
with the reservoir capacitor C6. If the voltage across C6
minus a diode drop is lower than the voltage across C5,
charge flows from C5 to C6 until the diode (D5) turns off.
The amount of charge transferred to the output is
controlled by the variable n-channel on-resistance.
Positive Charge Pump
During the first half-cycle, the n-channel MOSFET turns
on and charges the flying capacitor C3 (Figure 3). This
initial charge is controlled by the variable n-channel on-
resistance. During the second half-cycle, the n-channel
MOSFET turns off and the p-channel MOSFET turns on,
level shifting C3 by V
SUPP
volts. This connects C3 in par-
allel with the reservoir capacitor C4. If the voltage across
C4 plus a diode drop (V
POS
+ V
DIODE
) is smaller than the
level-shifted flying capacitor voltage (V
C3
+ V
SUPP
),
charge flows from C3 to C4 until the diode (D3) turns off.
Pin Description (continued)
PIN
8
9
10
11
12
13
14
NAME
FBN
FUNCTION
Negative Charge-Pump Regulator Feedback Input. Regulates to 0V nominal.
Active-Low Logic-Level Shutdown Input. Connect
SHDN
to IN for normal operation.
Negative Charge-Pump Driver Output. Output high level is V
SUPN
, and low level is PGND.
Negative Charge-Pump Driver Supply Voltage. Bypass to PGND with a 0.1μF capacitor.
Positive Charge-Pump Driver Output. Output high level is V
SUPP
, and low level is PGND.
Positive Charge-Pump Driver Supply Voltage. Bypass to PGND with a 0.1μF capacitor.
Power Ground. Connect to GND underneath the IC.
SHDN
DRVN
SUPN
DRVP
SUPP
PGND
15
LX
Main Boost Regulator Power MOSFET n-Channel Drain. Connect output diode and output capacitor
as close to PGND as possible.
16
TGND
Must be connected to ground.
相關PDF資料 |
PDF描述 |
|---|---|
| MAX8729 | Constant-Frequency, Half-Bridge CCFL Inverter Controller |
| MAX8729EEI | Constant-Frequency, Half-Bridge CCFL Inverter Controller |
| MAX8740 | TFT-LCD Step-Up DC-DC Converter |
| MAX8740ETB | TFT-LCD Step-Up DC-DC Converter |
| MAX878LCPA | Analog IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX8726EUE+ | 功能描述:LCD 驅動器 Triple-Out TFT-LCD DC/DC Converter RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube |
| MAX8726EUE+T | 功能描述:LCD 驅動器 Triple-Out TFT-LCD DC/DC Converter RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube |
| MAX8726EUE-T | 功能描述:LCD 驅動器 RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube |
| MAX8727ETB | 制造商:Maxim Integrated Products 功能描述:TFT-LCD STEP-UP DC-DC CONVERTER - Rail/Tube |
| MAX8727ETB+ | 制造商:Maxim Integrated Products 功能描述:TFT-LCD STEP-UP DC-DC CONVERTER - Rail/Tube |
發布緊急采購，3分鐘左右您將得到回復。