參數資料
型號： MAX8512EXK-T
廠商： MAXIM INTEGRATED PRODUCTS INC
元件分類： 基準電壓源/電流源
英文描述： Ultra-Low-Noise, High PSRR, Low-Dropout,120mA Linear Regulators in SC70
中文描述： 1.5 V-4.5 V ADJUSTABLE POSITIVE LDO REGULATOR, PDSO5
封裝： SC-70, 5 PIN
文件頁數： 6/10頁
文件大?。?/td> 604K
代理商： MAX8512EXK-T
M
Ultra-Low-Noise, High PS RR, Low-Dropout,
120mA Linear Regulators in S C70
6
_______________________________________________________________________________________
Detailed Desc ription
The MAX8510/MAX8511/MAX8512 are ultra-low-noise,
low-dropout, low-quiescent current linear regulators
designed for space-restricted applications. The parts
are available with preset output voltages ranging from
1.5V to 4.5V in 100mV increments. These devices can
supply loads up to 120mA. As shown in the
Functional
Diagram
, the MAX8510/MAX8511 consist of an innova-
tive bandgap core and noise bypass circuit, error
amplifier, P-channel pass transistor, and internal feed-
back voltage-divider. The MAX8512 allows for
adjustable output with an external feedback network.
The 1.225V bandgap reference is connected to the
error amplifier’s inverting input. The error amplifier com-
pares this reference with the feedback voltage and
amplifies the difference. If the feedback voltage is
lower than the reference voltage, the pass-transistor
gate is pulled low. This allows more current to pass to
the output and increases the output voltage. If the feed-
back voltage is too high, the pass transistor gate is
pulled high, allowing less current to pass to the output.
The output voltage is fed back through an internal resis-
tor voltage-divider connected to the OUT pin.
An external bypass capacitor connected to BP
(MAX8510) reduces noise at the output. Additional
blocks include a current limiter, thermal sensor, and
shutdown logic.
Internal P-Channel Pass T ransistor
The MAX8510/MAX8511/MAX8512 feature a 1
(typ) P-
channel MOSFET pass transistor. This provides several
advantages over similar designs using a PNP pass
transistor, including longer battery life. The P-channel
MOSFET requires no base drive, which considerably
reduces quiescent current. PNP-based regulators
waste considerable current in dropout when the pass
transistor saturates. They also use high base-drive cur-
rent under heavy loads. The MAX8510/MAX8511/
MAX8512 do not suffer from these problems and con-
sume only 40μA of quiescent current in light load and
220μA in dropout (see the
Typical Operating
Characteristics
).
Output V oltage S elec tion
The MAX8510/MAX8511 are supplied with factory-set
output voltages from 1.5V to 4.5V, in 100mV increments
(see
Ordering Information
). The MAX8512 features a
user-adjustable output through an external feedback
network (see the
Typical Operating Circuits
).
To set the output of the MAX8512, use the following
equation:
where R2 is chosen to be less than 240k
and V
REF
=
1.225V. Use 1% or better resistors.
S hutdown
The MAX8510/MAX8511/MAX8512 feature a low-power
shutdown mode that reduces quiescent current less
than 1μA. Driving
SHDN
low disables the voltage refer-
ence, error amplifier, gate-drive circuitry, and pass
transistor (see the
Functional Diagram
), and the device
output enters a high-impedance state. Connect
SHDN
to IN for normal operation.
Current Limit
The MAX8510/MAX8511/MAX8512 include a current
limiter, which monitors and controls the pass transis-
tor’s gate voltage, limiting the output current to 200mA.
R
R
X
V
V
OUT
REF
1
2
1
=
-
Pin Desc ription
PIN
MAX8510
1
2
3
MAX8511
1
2
3
MAX8512
1
2
3
NAME
FUNCTION
IN
Unregulated Input Supply
Ground
Shutdown. Pull low to disable the regulator.
GND
SHDN
4
—
—
BP
Noise Bypass for Low-Noise Operation. Connect a 10nF capacitor from
BP to OUT. It is short to OUT in shutdown mode.
—
—
4
—
—
4
N.C.
FB
Not Internally Connected
Adjustable Output Feedback Point
5
5
5
OUT
Regulated Output Voltage. Bypass with a capacitor to GND. See the
Capacitor Selection
and Regulator Stability
section for more details.
相關PDF資料
PDF描述
MAX8532EBTJ Low-Noise, Low-Dropout, 200mA Linear Regulator in UCSP
MAX8532 Low-Noise, Low-Dropout, 200mA Linear Regulator in UCSP
MAX8532EBTG Low-Noise, Low-Dropout, 200mA Linear Regulator in UCSP
MAX8535AEUA ORing MOSFET Controllers with Fastest Fault Isolation for Redundant Power Supplies
MAX8535 Triple 3-Input Positive-AND Gates 20-LCCC -55 to 125
相關代理商/技術參數
參數描述
MAX8513EEI 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
MAX8513EEI+ 功能描述:DC/DC 開關控制器 Triple-Output Supply RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
MAX8513EEI+T 功能描述:DC/DC 開關控制器 Triple-Output Supply RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
MAX8513EEI-T 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
MAX8513EVKIT 功能描述:電源管理IC開發工具 RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*