參數資料
型號: MAX8512
廠商: Maxim Integrated Products, Inc.
英文描述: Ultra-Low-Noise.High PSRR.Low-Dropout.120mA Linear Regulators in SC70
中文描述: 超低噪聲、高PSRR、低壓差、120mA線性穩壓器
文件頁數: 8/14頁
文件大小: 296K
代理商: MAX8512
M
PWM Buc k Converters with Bypass FET
for N-CDMA/W-CDMA Handsets
8
_______________________________________________________________________________________
GND
BATT
INPUT 2.6V TO5.5V
OUTPUT 0.4V TOV
BATT
SKIP
SHDN
REF
R
8.2k
C
1000pF
LX
OUT
REFIN
PGND
COMP
10
μ
F
4.7
μ
F
4.7
μ
H
DAC
PWM
LDO
1MHz
OSC
MAX8500-
MAX8503
g
m
Figure 1. MAX8500
MAX8503 Functional Diagram and Typical Operating Circuit
PWM Control
The MAX8500
MAX8504 use a fixed-frequency, current-
mode, PWM controller capable of achieving 100% duty
cycle. Current-mode feedback provides cycle-by-cycle
current limiting, superior load and line response, as well
as overcurrent protection for the internal MOSFET and
rectifier. A comparator at the P-channel MOSFET switch
detects overcurrent at 1.5A.
During PWM operation, the MAX8500
MAX8504 regulate
output voltage by switching at a constant frequency and
then modulating the duty cycle with PWM control. The
error-amp output, the main switch current-sense signal,
and the slope compensation ramp are all summed using
a PWM comparator. The comparator modulates the out-
put power by adjusting the peak inductor current during
the first half of each cycle based on the output error volt-
age. The MAX8500
MAX8504 have relatively low AC
loop gain coupled with a high gain integrator to enable
the use of a small, low-valued output filter capacitor. The
resulting load regulation is 0.03% at 0 to 600mA.
Normal Mode Operation
Connecting
SKIP
to GND enables normal operation. This
allows automatic PWM control at medium and heavy
loads and skip mode at light loads to improve efficiency
and reduce quiescent current to 280μA. Operating in nor-
mal mode also allows the MAX8500
MAX8504 to pulse
skip when the peak inductor current drops below 148mA,
corresponding to a load current of approximately 75mA.
During skip operation, the MAX8500
MAX8504 switch
only as needed to service the load, reducing the switch-
ing frequency and associated losses in the internal switch
and synchronous rectifier.
There are three steady-state operating conditions for the
MAX8500
MAX8504 in normal mode. The device per-
forms in continuous conduction for heavy loads in a
manner identical to forced-PWM mode. The inductor cur-
rent becomes discontinuous at medium loads, requiring
the synchronous rectifier to be turned off before the end
of a cycle as the inductor current reaches zero. The
device enters into skip mode when the converter output
voltage exceeds its regulation limit before the inductor
current reaches its skip threshold level.
During skip mode, a switching cycle initiates when the
output voltage has dropped out of regulation. The
P-channel MOSFET switch turns on and conducts cur-
相關PDF資料
PDF描述
MAX8515EVKIT Evaluation Kit for the MAX8515/MAX8515A
MAX8523 High-Speed. Dual-Phase Gate Driver for Multiphase. Step-Down Converters
MAX8529 1.5MHz Dual 180&#176. Out-of-Phase PWM Step-Down Controller with POR
MAX8529EVKIT Evaluation Kit for the MAX8529
MAX8555AEVKIT Evaluation Kit for the MAX8555A
相關代理商/技術參數
參數描述
MAX8512ETA+T 功能描述:低壓差穩壓器 - LDO 120mA Linear Regulator RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓(最大值):307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20
MAX8512EXK 制造商:Maxim Integrated Products 功能描述:ULTRA-LOW NOISE, HIGH PSRR, LOW-DROPOUT, 120M - Cut Tape Product
MAX8512EXK+ 制造商:Maxim Integrated Products 功能描述:REG LDO LIN ADJ POS 1.5V TO 4.5V 0.12A 5PIN SC-70 - Bulk
MAX8512EXK+T 功能描述:低壓差穩壓器 - LDO 120mA Linear Regulator RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓(最大值):307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20
MAX8512EXK-T 功能描述:低壓差穩壓器 - LDO 120mA Linear Regulator RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓(最大值):307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20