- 您現在的位置：買賣IC網 > PDF目錄383511 > MAX845ESA (MAXIM INTEGRATED PRODUCTS INC) Isolated Transformer Driver for PCMCIA Applications PDF資料下載
參數資料
| 型號： | MAX845ESA |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 外設及接口 |
| 英文描述： | Isolated Transformer Driver for PCMCIA Applications |
| 中文描述： | 1 A BUF OR INV BASED PRPHL DRVR, PDSO8 |
| 封裝： | 0.150 INCH, MS-012A, SOIC-8 |
| 文件頁數： | 6/16頁 |
| 文件大?。?/td> | 213K |
| 代理商： | MAX845ESA |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁
M
The MAX845 is a versatile transformer driver, capable
of driving a center-tapped transformer primary from a
5V or 3.3V DC power supply (Figures 3 and 4). The
secondary can be wound to provide any isolated volt-
age needed at power levels up to 750mW with a 5V
supply or up to 500mW with a 3.3V supply. Figure 3
shows a typical 5V to isolated 5V application circuit that
delivers up to 150mA of isolated 5V power.
3.3V S upply
Any of the application circuits shown may be converted
to 3.3V operation by changing the turns ratio of the trans-
former and operating the MAX845 from a boost supply,
as shown in Figure 4. In normal operation, whenever one
of the MAX845 outputs goes low, the other goes to
approximately double the supply voltage. Since the cir-
cuit is symmetrical, the two outputs can be combined
with diodes, lightly filtered, then used to power the
MAX845, and possibly other light loads as well.
The diodes on the primary side may be any fast-switch-
ing small-signal diodes, such as the 1N914, 1N4148, or
CMPD2838. The value of the primary filter capacitor is
not critical and can be very small, since it only needs to
supply current to the MAX845 during the break-before-
make interval.
The transformer could be any of the same ones used for
5V operation, but for optimum performance it should
have fewer primary turns, as the ET product required is
now only 3.3V-μs. For a given power level, the currents
will be higher at 3.3V, so transformer winding resistance
will be more critical and efficiencies will be lower. The
MAX845 output current must still be limited to 200mA
(see Absolute Maximum Ratings), so the available out-
put power will be less than with a 5V power source.
Low-Noise Power S upply
The MAX845 topology is inherently low noise, in that
either one or the other of the two power devices is on at
any given time. By alternating between two identical
states with one side on and the other off, the input cur-
rent is nearly constant and secondary output power is
available at all times. There is an intentional break-
before-make action to prevent any possibility of both
power switches conducting at the same time. During
this 100ns non-overlap interval, the input current goes
to zero. This adds a small high-frequency component
to the input current waveform. This ripple current can
easily be absorbed by a small input bypass capacitor
(0.33μF) from V
CC
to ground. Figure 5 shows a low-
noise bias supply using the MAX845 transformer driver.
When using the two-diode push-pull (Figure 11a)
rectifier or the four-diode bridge (Figure 11b), the out-
put voltage tends to be more constant than in most
alternative topologies. As described above, the circuit
alternates between two identical states that both pro-
vide power to the load. The only part of the cycle that
produces output ripple is the 100ns non-overlap inter-
val, which can easily be filtered by a small ceramic
output capacitor (0.33μF).
Isolated Transformer Driver
for PCMCIA Applic ations
6
_______________________________________________________________________________________
C2
0.33μF
C1
0.1μF
5V @ 150mA
ISOOUTPUT
5V
V
IN
MAX845
D1
D2
FS
GND1 GND2
V
CC
1
8
6
2
7
3
FREQUENCY
SELECT
SD
4
ISO
GND
MBR0520
1CT
:
1.3CT
MBR0520
ON / OFF
Figure 3. 5V to Isolated 5V Application Circuit
MAX845
GND1
2
GND2
7
V
CC
1
8
6
1N4148
1N4148
D1
D2
3.3V
SUPPLY
SEE FIGURE 11
FOR RECTIFIER
CONFIGURATIONS
0.01μF
Figure 4. 3.3V Input to Isolated Output Application Circuit
相關PDF資料 |
PDF描述 |
|---|---|
| MAX845EUA | Isolated Transformer Driver for PCMCIA Applications |
| MAX8501 | SWITCH |
| MAX8551 | Integrated DDR Power-Supply Solutions for Desktops. Notebooks. and Graphic Cards |
| MAX8560 | 4MHz. 500mA Synchronous Step-Down DC-DC Converters in Thin SOT and TDFN |
| MAX8561 | 4MHz. 500mA Synchronous Step-Down DC-DC Converters in Thin SOT and TDFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX845ESA/GH9 | 功能描述:功率驅動器IC RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| MAX845ESA/GH9-T | 功能描述:功率驅動器IC RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| MAX845ESA+ | 功能描述:功率驅動器IC Isolated Transformer Driver for PCMCIA RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| MAX845ESA+T | 功能描述:功率驅動器IC Isolated Transformer Driver for PCMCIA RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| MAX845ESA-T | 功能描述:功率驅動器IC RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。