- 您現在的位置：買賣IC網 > PDF目錄383491 > MAX6958AAPE (MAXIM INTEGRATED PRODUCTS INC) Dual 4-Bit Binary Counters 14-CFP -55 to 125 PDF資料下載
參數資料
| 型號： | MAX6958AAPE |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 顯示驅動器 |
| 英文描述： | Dual 4-Bit Binary Counters 14-CFP -55 to 125 |
| 中文描述： | LED DISPLAY DRIVER, PDIP16 |
| 封裝： | PLASTIC, DIP-16 |
| 文件頁數： | 16/19頁 |
| 文件大?。?/td> | 270K |
| 代理商： | MAX6958AAPE |
M
Key Debounced Register (MAX6959 Only)
The key debounced register shows which keys have
been detected as debounced by the keyscanning cir-
cuit (Table 17). Each bit in the register corresponds to
one key switch. The bit is set to 1 if the switch has been
correctly debounced since the last key debounced reg-
ister read operation.
Reading the key debounced register clears the register
(after the data has been read) so that future key presses
can be identified. If the key debounced register is not
read, the keyscan data accumulates. There is no FIFO
register in the MAX6959. Key-press order, or whether a
key has been pressed more than once, cannot be
determined unless the key debounced register is read
after each interrupt and before completion of the next
keyscan cycle.
Reading the key debounced register clears the IRQ
output. If a key is pressed and held down, the key is
reported as debounced (and an IRQ is issued) only
once. The key must be detected as released by the
keyscanning circuit before it is debounced again.
The key debounced register is read only. A write to
address 0x08 is ignored.
Key Pressed Register (MAX6959 Only)
The key pressed register shows which keys have been
detected as pressed by the keyscanning circuit during
the last test. Each bit in the register corresponds to one
key switch. The bit is set if the switch has been detect-
ed as pressed by the keyscanning circuit during the
last test. The bit is cleared if the switch has not been
detected as pressed by the keyscanning circuit during
the last test. Reading the key pressed register does not
clear either the key pressed register, or the key
debounced register, and does not clear the IRQ output.
The key pressed register is read only. A write to
address 0x0C is ignored.
Display Test Register
The display test register operates in two modes: normal
and display test (Table 19). Display test mode turns on
all LEDs by overriding, but not altering, all control and
digit registers (including the shutdown register) except
for the port configuration register. The duty cycle while
in display test mode is 28/64.
Applications Information
Driving Bicolor LEDs
Bicolor digits combine a red and a green die for each
display element, so that the element displays red or
green (or orange), depending on which die (or both) is
lit. The MAX6958/MAX6959 treat a bicolor digit as two
monocolor digits.
Low-Voltage Operation
The MAX6958/MAX6959 are guaranteed to drive a 23mA
segment current into 2.4V (or lower) LEDs when operat-
ed from a supply voltage of 4.5V to 5.5V. Operating the
MAX6958/MAX6959 from a supply voltage lower than
4.5V reduces the LED drive current. The drivers drive at
least 15.5mA segment current into 2V (or lower) LEDs
when operated from a 3V supply voltage.
2-Wire Interfaced, 3V to 5.5V, 4-Digit,
9-Segment LED Display Drivers with Keyscan
16
______________________________________________________________________________________
REGISTER DATA
WITH APPROPRIATE SWITCH NAMED BELOW
KEY DEBOUNCED REGISTER
ADDRESS
CODE (HEX)
D7
Key7
D6
Key6
D5
Key5
D4
Key4
D3
Key3
D2
Key2
D1
Key1
D0
Key0
Key debounced register
0x08
Table 17. Key Debounced Register Format
REGISTER DATA
WITH APPROPRIATE SWITCH NAMED BELOW
KEY PRESSED REGISTER
ADDRESS
CODE (HEX)
D7
Key7
D6
Key6
D5
Key5
D4
Key4
D3
Key3
D2
Key2
D1
Key1
D0
Key0
Key pressed register
0x0C
Table 18. Key Pressed Register Format
REGISTER DATA
D4
X
X
MODE
ADDRESS
CODE (HEX)
D7
X
X
D6
X
X
D5
X
X
D3
X
X
D2
X
X
D1
X
X
D0
0
1
Normal operation
Display test mode
0x07
0x07
Table 19. Display Test Register
相關PDF資料 |
PDF描述 |
|---|---|
| MAX6959 | 2-Wire Interfaced, 3V to 5.5V, 4-Digit, 9-Segment LED Display Drivers with Keyscan |
| MAX6959AAPE | 2-Wire Interfaced, 3V to 5.5V, 4-Digit, 9-Segment LED Display Drivers with Keyscan |
| MAX6958-MAX6959 | 2-Wire Interfaced, 3V to 5.5V, 4-Digit, 9-Segment LED Display Drivers with Keyscan |
| MAX6959AAEE | Circular Connector; MIL SPEC:MIL-C-5015; Body Material:Metal; Series:GT; No. of Contacts:8; Connector Shell Size:22; Connecting Termination:Solder; Circular Shell Style:Square Flange Receptacle; Body Style:Straight |
| MAX6959BAEE | 2-Wire Interfaced, 3V to 5.5V, 4-Digit, 9-Segment LED Display Drivers with Keyscan |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX6958AAPE+ | 功能描述:LED顯示驅動器 3-5.5V 4-Digit 9-Seg LED Display Driver RoHS:否 制造商:Micrel 數位數量:5 片段數量: 安裝風格:SMD/SMT 封裝 / 箱體:PLCC-44 工作電源電壓:4.75 V to 11 V 最大電源電流:10 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Tube |
| MAX6958BAEE | 功能描述:LED顯示驅動器 3-5.5V 4-Digit 9-Seg LED Display Driver RoHS:否 制造商:Micrel 數位數量:5 片段數量: 安裝風格:SMD/SMT 封裝 / 箱體:PLCC-44 工作電源電壓:4.75 V to 11 V 最大電源電流:10 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Tube |
| MAX6958BAEE+ | 功能描述:LED顯示驅動器 3-5.5V 4-Digit 9-Seg LED Display Driver RoHS:否 制造商:Micrel 數位數量:5 片段數量: 安裝風格:SMD/SMT 封裝 / 箱體:PLCC-44 工作電源電壓:4.75 V to 11 V 最大電源電流:10 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Tube |
| MAX6958BAEE+T | 功能描述:LED顯示驅動器 3-5.5V 4-Digit 9-Seg LED Display Driver RoHS:否 制造商:Micrel 數位數量:5 片段數量: 安裝風格:SMD/SMT 封裝 / 箱體:PLCC-44 工作電源電壓:4.75 V to 11 V 最大電源電流:10 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Tube |
| MAX6958BAEE-T | 功能描述:LED顯示驅動器 3-5.5V 4-Digit 9-Seg LED Display Driver RoHS:否 制造商:Micrel 數位數量:5 片段數量: 安裝風格:SMD/SMT 封裝 / 箱體:PLCC-44 工作電源電壓:4.75 V to 11 V 最大電源電流:10 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。