- 您現在的位置：買賣IC網 > PDF目錄385547 > MAX687 (Maxim Integrated Products, Inc.) High-Accuracy, Low-Dropout Linear Regulators(3V,用于便攜電話的,高精度線性穩壓控制器) PDF資料下載
參數資料
| 型號： | MAX687 |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | High-Accuracy, Low-Dropout Linear Regulators(3V,用于便攜電話的,高精度線性穩壓控制器) |
| 中文描述： | 高精度、低壓差線性穩壓器 |
| 文件頁數： | 6/12頁 |
| 文件大?。?/td> | 128K |
| 代理商： | MAX687 |
2
M
High-Ac c urac y, Low-Dropout
Linear Regulators
6
_______________________________________________________________________________________
______________________________________________________________Pin Desc ription
NAME
FUNCTION
1
IN
Positive input voltage, 2.7V to 11.0V
2
ON
(MAX687)
ON activates the regulator when pulsed high. In order for the regulator to remain on, ON must remain high
until V
OUT
exceeds the internal shutdown threshold voltage. The MAX687 is shut down when V
OUT
< 2.96V,
and remains latched off until ON is pulsed high. When powered up, the MAX687 does not start up until ON
is pulsed high. Connect to V
IN
if not used.
PIN
SHDN
(MAX688/
MAX689)
SHDN is a three-level input that controls the mode of operation. The device is on when V
SHDN
> 1.25V.
The output is disabled and the supply current is reduced (I
IN
< 25μA, standby mode) when V
SHDN
< 1.2V,
and is fully off (I
IN
< 1μA, shutdown mode) when V
SHDN
< 0.2V. Connect SHDN to IN if the shutdown func-
tion is not used. PFO is low when SHDN is low (below 0.2V).
3
PFO
Power-Fail Output. PFO trips when V
OUT
is 170mV below nominal V
OUT
at I
BASE
= 1mA. PFO sources and
sinks current in the MAX687, but is an open drain in the MAX688/MAX689. When shut down, PFO is always
low and sinks current. Leave PFO open if not used.
7
BASE
Base drive for the external PNP transistor. Current limiting is controlled using a resistor (R
B
) connected
between BASE and BLIM. For maximum output current, connect BASE to BLIM.
6
BLIM
Base current limit. A resistor (R
B
) connected between BASE and BLIM sets the maximum base drive to the
PNP transistor: I
BASE
≤
0.1V / (R
B
+ 5
). This limits quiescent current rise during dropout and also pro-
vides current limiting without using a current-sense resistor in the collector of the external PNP, thus not
impacting dropout. Output current limiting accuracy depends on how well the external PNP beta (h
FE
) is
controlled. Connect to BASE if not used.
5
OUT
Regulator Output. MAX687/MAX688, 3.3V; MAX689, 3.0V.
4
GND
Ground
8
CC
Compensation Capacitor. Connect a non-polarized capacitor (10nF to 100nF) from CC to GND.
_______________Detailed Desc ription
The MAX687/MAX688/MAX689 are precision low-
dropout linear regulators employing external PNP tran-
sistors to achieve a wide range of output currents at
voltages of 3.0V or 3.3V. The maximum base current
for the PNP can be limited using a resistor. Limiting the
base drive keeps high currents from being wasted
when the device is in dropout (e.g., at low input volt-
ages), and limits the regulator’s output current. The
dropout voltage is limited only by the PNP transistor’s
V
CE(SAT)
. The Power-Fail Output (PFO) goes low when
the output voltage drops 170mV below the nominal
level.
The three devices differ in their output voltages, in their
shutdown-control functions, and in PFO’s output drive
(see Table 1).
The MAX687’s output voltage is internally monitored; a
falling V
OUT
is signaled by PFO going low. As the out-
put falls further, the MAX687 automatically enters a low-
power shutdown mode, where the base drive to the
external PNP is cut off. PFO trips at a minimum of
110mV below the nominal V
OUT
, and shutdown occurs
by 2.96V. PFO is guaranteed to trip before the device
Table 1. Device Functions
FUNCTION
V
OUT
MAX687
3.3V
Automatic at low
V
OUT
. Latched.
Use ON to start.
Sources & Sinks
MAX688
3.3V
MAX689
3.0V
Shutdown
Control
External
SHDN
External
SHDN
PFO
Open Drain
Open Drain
相關PDF資料 |
PDF描述 |
|---|---|
| MAX691A | Microprocessor Supervisory Circuits(帶看門狗復位、片選和支持備用電池的復位器) |
| MAX6954APL | 4-Wire Interfaced, 2.7V to 5.5V LED Display Driver with I/O Expander and Key Scan |
| MAX6954 | Dual 4-Bit Decade And Binary Counters 16-CFP -55 to 125 |
| MAX6954AAX | Dual 4-Bit Decade And Binary Counters 20-LCCC -55 to 125 |
| MAX6957 | 4-Wire-Interfaced, 2.5V to 5.5V, 20-Port and 28-Port LED Display Driver and I/O Expander |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX6870ETJ | 功能描述:監控電路 RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX6870ETJ+ | 功能描述:監控電路 EEPROM-Prog Hex Power-Sup Sequencer RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX6870ETJ+T | 功能描述:監控電路 EEPROM-Prog Hex Power-Sup Sequencer RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX6870ETJ-T | 功能描述:監控電路 RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX6870EVCMAXQ | 制造商:Maxim Integrated Products 功能描述:EEPROM-PROGRAMMABLE HEX/QUAD POWER-SUPPLY SEQ - Rail/Tube |
發布緊急采購，3分鐘左右您將得到回復。