- 您現在的位置：買賣IC網 > PDF目錄384693 > MAX683 (Maxim Integrated Products, Inc.) 3.3V-Input to Regulated 5V-Output Charge Pumps PDF資料下載
參數資料
| 型號： | MAX683 |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | 3.3V-Input to Regulated 5V-Output Charge Pumps |
| 中文描述： | 3.3V輸入、穩壓輸出5V的電荷泵 |
| 文件頁數： | 9/12頁 |
| 文件大?。?/td> | 154K |
| 代理商： | MAX683 |
M
3.3V-Input to Regulated 5V-Output
Charge Pumps
_______________________________________________________________________________________
9
Power Dissipation
The power dissipated in the MAX682/MAX683/MAX684
depends on output current and is accurately described
by:
P
DISS
= I
OUT
(2V
IN
- V
OUT
)
P
DISS
must be less than that allowed by the package
rating. See the Absolute Maximum Ratings for 8-pin
μMAX (MAX683/MAX684) and SO (MAX682) power-
dissipation limits and deratings.
Layout Considerations
All capacitors should be soldered in close proximity to
the IC. Connect ground and power ground through a
short, low-impedance trace. If a high-value resistor is
driving the shutdown input and is picking up noise (i.e.,
frequency jitter at CXP and CXN), bypass
SHDN
to
GND with a small capacitor (0.01μF).
Paralleling Devic es
The MAX682/MAX683/MAX684 can be paralleled to
yield higher load currents. The circuit of Figure 6 can
deliver 500mA at 5V. It uses two MAX682s in parallel.
The devices can share the output capacitors, but each
one requires its own transfer capacitor (C
X
) and input
capacitor. For best performance, the paralleled devices
should operate in the same mode (skip or constant fre-
quency).
Chip Information
TRANSISTOR COUNT: 659
SUBSTRATE CONNECTED TO GND
Pac kage Information
8
相關PDF資料 |
PDF描述 |
|---|---|
| MAX682 | 3.3V-Input to Regulated 5V-Output Charge Pumps(3.3V輸入電壓，可調，５V輸出電荷泵) |
| MAX683EUA | 3.3V-Input to Regulated 5V-Output Charge Pumps |
| MAX684 | 3.3V-Input to Regulated 5V-Output Charge Pumps |
| MAX684EUA | Dual D-type Positive-Edge-Triggered Flip-Flops With Preset And Clear 14-CDIP -55 to 125 |
| MAX6832 | Ultra-Low-Voltage SC70 Voltage Detectors and レP Reset Circuits |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX6830RDUT | 制造商:Maxim Integrated Products 功能描述:DUAL ULTRA LOW VOLTAGE SOT23 MICROP - Cut Tape Product |
| MAX6830RDUT+T | 功能描述:監控電路 RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX6830RDUT-T | 功能描述:監控電路 RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX6830REUT | 制造商:Maxim Integrated Products 功能描述:DUAL ULTRA LOW VOLTAGE SOT23 MICROP - Cut Tape Product |
| MAX6830REUT+T | 功能描述:監控電路 RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。