- 您現在的位置：買賣IC網 > Datasheet目錄44 > MAX6643LBFAEE+ (Maxim Integrated)IC CTLR PWM FAN-SPEED 16QSOP Datasheet資料下載
參數資料
| 型號： | MAX6643LBFAEE+ |
| 廠商： | Maxim Integrated |
| 文件頁數： | 12/17頁 |
| 文件大小： | 208K |
| 描述： | IC CTLR PWM FAN-SPEED 16QSOP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 100 |
| 功能： | 風扇控制，溫度監控器 |
| 傳感器類型： | 內部和外部 |
| 感應溫度： | -40°C ~ 125°C，外部傳感器 |
| 精確度： | ±3.5°C 本地（最大），±3°C 遠程（最大） |
| 拓撲： | ADC，PWM 發生器，轉速計計數器 |
| 輸出類型： | PWM |
| 輸出警報： | 是 |
| 輸出風扇： | 是 |
| 電源電壓： | 3 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-SSOP（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 16-QSOP |
| 包裝： | 管件 |
Automatic PWM Fan-Speed Controllers with
Overtemperature Output
12 ______________________________________________________________________________________
Effect of Series Resistance
Series resistance in a sense diode contributes addition-
al errors. For nominal diode currents of 10礎 and
100礎, change in the measured voltage is:
Since 1癈 corresponds to 198.6礦, series resistance
contributes a temperature offset of:
Assume that the diode being measured has a series
resistance of 3? The series resistance contributes an
offset of:
The effects of the ideality factor and series resistance
are additive. If the diode has an ideality factor of 1.008
and series resistance of 3? the total offset can be cal-
culated by adding error due to series resistance with
error due to ideality factor:
1.36癈 - 0.66癈 = 0.7癈
for a diode temperature of +60.7癈.
In this example, the effect of the series resistance and
the ideality factor partially cancel each other.
For best accuracy, the discrete transistor should be a
small-signal device with its collector connected to
base, and emitter connected to GND. Table 5 lists
examples of discrete transistors that are appropriate for
use with the MAX6643/MAX6644/MAX6645.
The transistor must have a relatively high forward volt-
age; otherwise, the ADC input voltage range can be vio-
lated. The forward voltage at the highest expected
temperature must be greater than 0.25V at 10礎, and at
the lowest expected temperature, the forward voltage
must be less than 0.95V at 100礎. Large power transis-
tors must not be used. Also, ensure that the base resis-
tance is less than 100? Tight specifications for forward
current gain (50 < ?<150, for example) indicate that the
manufacturer has good process controls and that the
devices have consistent V
BE
characteristics.
ADC Noise Filtering
The integrating ADC has inherently good noise rejec-
tion, especially of low-frequency signals such as
60Hz/120Hz power-supply hum. Micropower operation
places constraints on high-frequency noise rejection.
Lay out the PCB carefully with proper external noise fil-
tering for high-accuracy remote measurements in elec-
trically noisy environments.
Filter high-frequency electromagnetic interference
(EMI) at the DXP pins with an external 2200pF capaci-
tor connected between DXP, DXP1, or DXP2 and
ground. This capacitor can be increased to about
3300pF (max), including cable capacitance. A capaci-
tance higher than 3300pF introduces errors due to the
rise time of the switched-current source.
Twisted Pairs and Shielded Cables
For remote-sensor distances longer than 8in, or in par-
ticularly noisy environments, a twisted pair is recom-
mended. Its practical length is 6ft to 12ft (typ) before
noise becomes a problem, as tested in a noisy electron-
ics laboratory. For longer distances, the best solution is
a shielded twisted pair like that used for audio micro-
phones. For example, Belden 8451 works well for dis-
tances up to 100ft in a noisy environment. Connect the
twisted pair to DXP and GND and the shield to ground,
and leave the shields remote end unterminated. Excess
capacitance at DXP limits practical remote-sensor dis-
tances (see the Typical Operating Characteristics).
For very long cable runs, the cables parasitic capaci-
tance often provides noise filtering, so the recommend-
ed 2200pF capacitor can often be removed or reduced
in value. Cable resistance also affects remote-sensor
accuracy. A 1?series resistance introduces about
+1/2癈 error.
PCB Layout Checklist
1) Place the MAX6643/MAX6644/MAX6645 as close as
practical to the remote diode. In a noisy environment,
such as a computer motherboard, this distance can
be 4in to 8in or more, as long as the worst noise
sources (such as CRTs, clock generators, memory
buses, and ISA/PCI buses) are avoided.
2) Do not route the DXP lines next to the deflection coils
of a CRT. Also, do not route the traces across a fast
memory bus, which can easily introduce +30癈 error,
even with good filtering. Otherwise, most noise
sources are fairly benign.
3
C
C
?/DIV>
?/DIV>
?/DIV>
?/DIV>
=
?/DIV>
.
.
0 453
1 36
90
198 6
0 453
?/DIV>
?/DIV>
?/DIV>
=
?/DIV>
V
V
C
C
?/DIV>
?/DIV>
.
.
擵
M
=
?nbsp ?/DIV>
(
)
= ?nbsp ?/DIV>
R
A
A
A R
S
s
100
10
90
相關PDF資料 |
PDF描述 |
|---|---|
| MAX6649MUA/V+ | IC SENSOR REMOTE SMBUS 8UMAX |
| MAX6652AUB+T | IC TEMP SENS/MON 10-UMAX |
| MAX6659MEE+T | IC TEMP SENSOR SMBUS 16-QSOP |
| MAX6661AEE+T | IC REG FAN SPEED 16-QSOP |
| MAX6664AEE+T | IC TEMP MON FAN CNTRL 16-QSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX6643LBFAEE+ | 功能描述:馬達/運動/點火控制器和驅動器 Automatic PWM Fan Speed Controller RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
| MAX6643LBFAEE+T | 功能描述:馬達/運動/點火控制器和驅動器 Automatic PWM Fan Speed Controller RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
| MAX6643LBFAEE-T | 功能描述:板上安裝溫度傳感器 RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor |
| MAX6644LBAAEE | 功能描述:板上安裝溫度傳感器 RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor |
| MAX6644LBAAEE+ | 功能描述:馬達/運動/點火控制器和驅動器 Automatic PWM Fan Speed Controller RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。