- 您現在的位置：買賣IC網 > PDF目錄384688 > MAX5877 (Maxim Integrated Products, Inc.) Replaced by SN55189A : Quadruple Line Receiver 14-CDIP -55 to 125 PDF資料下載
參數資料
| 型號： | MAX5877 |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | Replaced by SN55189A : Quadruple Line Receiver 14-CDIP -55 to 125 |
| 中文描述： | 14位、250Msps、高動態性能、雙路DAC，LVDS輸入 |
| 文件頁數： | 17/18頁 |
| 文件大?。?/td> | 511K |
| 代理商： | MAX5877 |
M
16-Bit, 250Msps, High-Dynamic-Performance,
Dual DAC with LVDS Inputs
______________________________________________________________________________________
17
Dynamic Performance Parameter Definitions
Signal-to-Noise Ratio (SNR)
For a waveform perfectly reconstructed from digital sam-
ples, the theoretical maximum SNR is the ratio of the full-
scale analog output (RMS value) to the RMS quantization
error (residual error). The ideal, theoretical minimum can
be derived from the DAC’s resolution (N bits):
SNR
dB
= 6.02
dB
x N + 1.76
dB
However, noise sources such as thermal noise, reference
noise, clock jitter, etc., affect the ideal reading; therefore,
SNR is computed by taking the ratio of the RMS signal to
the RMS noise, which includes all spectral components
minus the fundamental, the first four harmonics, and the
DC offset.
Noise Spectral Density
The DAC output noise floor is the sum of the quantiza-
tion noise and the output amplifier noise (thermal and
shot noise). Noise spectral density is the noise power in
1Hz bandwidth, specified in dBFS/Hz.
Spurious-Free Dynamic Range (SFDR)
SFDR is the ratio of RMS amplitude of the carrier fre-
quency (maximum signal components) to the RMS
value of their next-largest distortion component. SFDR
is usually measured in dBc and with respect to the car-
rier frequency amplitude or in dBFS with respect to the
DAC’s full-scale range. Depending on its test condition,
SFDR is observed within a predefined window or to
Nyquist.
Two-/Four-Tone Intermodulation Distortion (IMD)
The two-tone IMD is the ratio expressed in dBc (or dBFS)
of the worst 3rd-order (or higher) IMD product(s) to either
output tone; 2nd-order IMD products usually fall at fre-
quencies that digital filtering easily removes. Therefore,
they are not as critical as 3rd-order IMDs. The two-tone
IMD performance of the MAX5878 is tested with the two
individual output tone levels set to at least -6dBFS and
the four-tone performance was tested according to the
GSM model at an output frequency of 16MHz and ampli-
tude of -12dBFS.
Adjacent Channel Leakage Power Ratio (ACLR)
Commonly used in combination with wideband code-
division multiple-access (W-CDMA), ACLR reflects the
leakage power ratio in dB between the measured
power within a channel relative to its adjacent channel.
ACLR provides a quantifiable method of determining
out-of-band spectral energy and its influence on an
adjacent channel when a bandwidth-limited RF signal
passes through a nonlinear device.
Settling Time
The settling time is the amount of time required from the
start of a transition until the DAC output settles its new
output value to within the converter’s specified accuracy.
Glitch Impulse
A glitch is generated when a DAC switches between
two codes. The largest glitch is usually generated
around the midscale transition, when the input pattern
transitions from 011...111 to 100...000. The glitch
impulse is found by integrating the voltage of the glitch
at the midscale transition over time. The glitch impulse
is usually specified in pV
s.
相關PDF資料 |
PDF描述 |
|---|---|
| MAX5878 | 16-Bit, 250Msps, High-Dynamic-Performance, Dual DAC with LVDS Inputs |
| MAX5878EGK | 16-Bit, 250Msps, High-Dynamic-Performance, Dual DAC with LVDS Inputs |
| MAX5887EGK | 3.3V, 14-Bit, 500Msps High Dynamic Performance DAC with Differential LVDS Inputs |
| MAX5887 | 3.3V, 14-Bit, 500Msps High Dynamic Performance DAC with Differential LVDS Inputs |
| MAX5916 | Quadruple 2-Line To 1-Line Data Selectors/Multiplexers 16-CDIP -55 to 125 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX5877EGK+D | 功能描述:數模轉換器- DAC 14-Bit 2Ch 250Msps DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MAX5877EGK+TD | 功能描述:數模轉換器- DAC 14-Bit 2Ch 250Msps DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MAX5877EGK-D | 功能描述:數模轉換器- DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MAX5877EGK-TD | 功能描述:數模轉換器- DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MAX5877EVKIT# | 功能描述:數模轉換器- DAC Evaluation Kit for the MAX5876/MAX5877/MAX5878 RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。