<tbody id="sueob"></tbody>
  • 參數資料
    型號: MAX562EAI+T
    廠商: Maxim Integrated Products
    文件頁數: 7/8頁
    文件大?。?/td> 0K
    描述: IC INTERFACE SER NOTEBOOK 28SSOP
    產品培訓模塊: Lead (SnPb) Finish for COTS
    Obsolescence Mitigation Program
    標準包裝: 2,000
    類型: 收發器
    驅動器/接收器數: 3/5
    規程: RS232
    電源電壓: 2.7 V ~ 5.25 V
    安裝類型: 表面貼裝
    封裝/外殼: 28-SSOP(0.209",5.30mm 寬)
    供應商設備封裝: 28-SSOP
    包裝: 帶卷 (TR)
    MAX562
    Complete 230kbps, 2.7V to 5.25V
    Serial Interface for Notebook Computers
    _______________________________________________________________________________________
    7
    the MAX562 transmitter outputs when
    SHDN rises. Two
    transmitter outputs are shown going to opposite EIA/TIA-
    562 levels (one transmitter input is high, the other is low).
    Each transmitter is loaded with 3k
    in parallel with
    2500pF. The transmitter outputs are well behaved, with
    no ringing or undesirable transients as they come out of
    shutdown.
    Driving Multiple Receivers
    Each transmitter is designed to drive a single receiver.
    Transmitters can be paralleled to drive multiple
    receivers.
    EIA/TIA-562 Receivers
    All 5 receivers are identical and accept EIA/TIA-562 or
    EIA/TIA-232 signals. The CMOS receiver outputs swing
    between VCC and GND. They are inverting, maintaining
    compatibility with the driver outputs.
    The guaranteed 0.8V and 2.4V receiver input thresh-
    olds are significantly tighter than the ±3.0V thresholds
    required by the EIA/TIA-562 specification. This allows
    the receiver inputs to respond to TTL/CMOS logic lev-
    els as well as EIA/TIA-562/232 levels. Also, the
    MAX562's guaranteed 0.8V lower threshold ensures
    that receivers shorted to ground will have a logic 1 out-
    put. The 5k
    input resistance to ground ensures that a
    receiver with its input left open will also have a logic 1
    output.
    The receiver inputs have approximately 0.3V hysteresis
    when
    SHDN is high. This provides clean output transi-
    tions, even with slowly moving input signals with mod-
    erate noise and ringing.
    The receivers are active when EN is high. When EN is
    low, the receiver outputs are high impedance. This
    allows wire-OR connection of two EIA/TIA-562 ports (or
    ports of different types) at the UART.
    The receivers are always active,when EN is high, irre-
    spective of
    SHDN's state. When SHDN is high, the
    receivers have hysteresis and experience the shortest
    propagation delays (typically 100ns falling, 250ns ris-
    ing). When
    SHDN is low, the receivers have longer
    propagation delays (typically 3s falling, 2s rising)
    and have no hysteresis. The receiver outputs are not
    valid for 50s after
    SHDN goes low.
    Shutdown and Enable Control
    SHDN and EN determine the operation of the MAX562
    as shown in Table 1.
    __________Applications Information
    Capacitor Selection
    The capacitor type is not critical for proper MAX562
    operation. Any low cost ceramic capacitor (e.g., Z5U,
    Y5V) is acceptable for operating at room temperature,
    0
    200
    300
    100
    SHDN
    5
    0
    6
    4
    2
    0
    -2
    -4
    VCC = +2.2V VCC = +2.7V
    VCC = +5.0V
    VCC = +3.3V
    TIME (
    s)
    VOLTS
    (V)
    Figure 5. Time for Transmitters to Exit Shutdown
    Table 1. MAX562 Control Pin Configurations
    SHDN
    EN
    CHARGE-PUMP
    OPERATION
    STATUS
    TRANSMITTERS
    T1-T3
    RECEIVERS
    R1-R5
    SUPPLY
    CURRENT
    TYP (A)
    0
    Shutdown
    High-Z
    1
    0
    1
    Shutdown
    High-Z
    Active*
    45
    1
    0
    Normal Operation
    Active
    High-Z
    24m
    1
    Normal Operation
    Active
    24m
    * Active, but with reduced performance (see
    EIA/TIA-562 Receivers section). This is “keep-awake” mode.
    相關PDF資料
    PDF描述
    VE-24P-MX-F4 CONVERTER MOD DC/DC 13.8V 75W
    MS27499E20A2S CONN RCPT 65POS BOX MNT W/SCKT
    MAX562EWI+T IC INTERFACE SER NOTEBOOK 28SOIC
    VE-26B-IU-F2 CONVERTER MOD DC/DC 95V 200W
    MS27467E17A6SB CONN PLUG 6POS STRAIGHT W/SCKT
    相關代理商/技術參數
    參數描述
    MAX562EWI 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝:
    MAX562EWI+ 功能描述:RS-232接口集成電路 230kbps 2.7-5.25V Serial Interface RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝:
    MAX562EWI+T 功能描述:RS-232接口集成電路 230kbps 2.7-5.25V Serial Interface RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝:
    MAX562EWI-T 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝:
    MAX5631AEVKIT 制造商:Maxim Integrated Products 功能描述:16-BIT 32 CHANNEL S&H VOUT DAC W/ 5 - Rail/Tube