參數資料
型號: MAX5394LATA+T
廠商: Maxim Integrated Products
文件頁數: 5/15頁
文件大?。?/td> 0K
描述: IC DGTL POT 256POS 10KOHM 8TDFN
標準包裝: 2,500
接片: 256
電阻(歐姆): 10k
電路數: 1
溫度系數: 標準值 50 ppm/°C
存儲器類型: 易失
接口: 3 線 SPI(芯片選擇)
電源電壓: 1.7 V ~ 5.5 V
工作溫度: -40°C ~ 125°C
安裝類型: *
封裝/外殼: *
供應商設備封裝: *
包裝: *
MAX5394
Single, 256-Tap Volatile, SPI, Low-Voltage Linear
Taper Digital Potentiometer
13
Maxim Integrated
register to be written. A RST will also deassert shutdown
mode and return the wiper to midscale (0x80). This
command does not affect the charge-pump status.
SD_L_ZERO Command
Moves wiper to zero-scale position (0x00) and opens the
L terminal. The wiper register remains unaltered. Writes
cannot be made to the wiper register while shutdown
mode is engaged. Clearing shutdown mode will return
the wiper to the position contained in the wiper register
and close the L terminal. A RST will also deassert
shutdown mode and return the wiper to midscale (0x80).
This command does not affect the charge-pump status.
SD_L_MID Command
Moves wiper to midscale position (0x80) and opens the
L terminal. The wiper register remains unaltered. Writes
cannot be made to the wiper register while shutdown
mode is engaged. Clearing shutdown mode will return
the wiper to the position contained in the wiper register
and close the L terminal. A RST will also deassert
shutdown mode and return the wiper to midscale (0x80).
This command does not affect the charge-pump status.
SD_L_FULL Command
Moves wiper to full-scale position (0xFF) and opens the
L terminal. The wiper register remains unaltered. Writes
cannot be made to the wiper register while shutdown
mode is engaged. Clearing shutdown mode will return
the wiper to the position contained in the wiper register
and close the L terminal. A RST will also deassert
shutdown mode and return the wiper to midscale (0x80).
This command does not affect the charge-pump status.
SD_W Command
Opens the W terminal keeping the internal tap position
the same as the wiper register. Writes cannot be made
to the wiper registers while shutdown mode is engaged.
Clearing shutdown mode will return the wiper to the
position contained in the wiper register and close W
terminal. A RST will also deassert shutdown mode and
return the wiper to midscale (0x80). This command does
not affect the charge-pump status.
QP_ON Command
Enables the onboard charge pump to allow low-supply
voltage operation. This is the power-on default condition.
Low supply voltage is 1.7V.
QP_OFF Command
Disables the on-board charge pump and places device
in low power mode. Low supply voltage is limited to 2.6V.
RST Command
Returns device to power-on default conditions. Resets
the wiper register to midscale (0x80), enables charge
pump, and deasserts any shutdown modes.
相關PDF資料
PDF描述
MS3450L28-9P CONN RCPT 12POS WALL MNT W/PINS
IDT72V70210DA IC DGTL SW 1024X1024 144-TQFP
MAX5435LEZT+T IC POT DGTL 32TAP NV TSOT23-6
MAX5434MEZT+T IC POT DGTL 32TAP NV TSOT23-6
MAX5433META+T IC POT DGTL 32-TAP NV I2C 8-TDFN
相關代理商/技術參數
參數描述
MAX5394MATA+T 功能描述:數字電位計 IC Sgl 256-tap Volatile DigiPot w/SPI RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
MAX5394NATA+T 功能描述:數字電位計 IC Sgl 256-tap Volatile DigiPot w/SPI RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
MAX5395LATA+T 功能描述:數字電位計 IC Sgl 256-tap Volatile DigiPot w/SPI RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
MAX5395MATA+T 功能描述:數字電位計 IC Sgl 256-tap Volatile DigiPot w/SPI RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
MAX5395NATA+T 功能描述:數字電位計 IC Sgl 256-tap Volatile DigiPot w/SPI RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel