- 您現在的位置：買賣IC網 > PDF目錄384682 > MAX5184 (Maxim Integrated Products, Inc.) 10-Bit, 40MHz, Current/Voltage-Output DACs PDF資料下載
參數資料
| 型號： | MAX5184 |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | 10-Bit, 40MHz, Current/Voltage-Output DACs |
| 中文描述： | 10位、40MHz、電流/電壓輸出DAC |
| 文件頁數： | 11/16頁 |
| 文件大?。?/td> | 285K |
| 代理商： | MAX5184 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁
M
10-Bit, 40MHz, Current/Voltage-Output DACs
______________________________________________________________________________________
11
Offset Error
Offset error (Figure 5c) is the difference between the
ideal and the actual offset point. For a DAC, the offset
point is the step value when the digital input is zero.
This error affects all codes by the same amount and
can usually be compensated by trimming.
Gain Error
Gain error (Figure 5d) is the difference between the
ideal and the actual full-scale output voltage on the
transfer curve, after nullifying the offset error. This error
alters the slope of the transfer function and corre-
sponds to the same percentage error in each step.
Settling Time
Settling time is the amount of time required from the start
of a transition until the DAC output settles its new output
value to within the converter’s specified accuracy.
Digital Feedthrough
Digital feedthrough is the noise generated on a DAC’s
output when any digital input transitions. Proper board
layout and grounding will significantly reduce this
noise, but there will always be some feedthrough
caused by the DAC itself.
Total Harmonic Distortion
Total harmonic distortion (THD) is the ratio of the RMS
sum of the input signal’s first five harmonics to the fun-
damental itself. This is expressed as:
where V
1
is the fundamental amplitude, and V
2
through
V
5
are the amplitudes of the 2nd- through 5th-order
harmonics.
Spurious-Free Dynamic Range
Spurious-free dynamic range (SFDR) is the ratio of RMS
amplitude of the fundamental (maximum signal compo-
nent) to the RMS value of the next-largest distortion com-
ponent.
Differential to Single-Ended Conversion
The MAX4108 low-distortion, high-input bandwidth
amplifier may be used to generate a voltage from the
array current output of the MAX5181. The differential
voltage across OUTP and OUTN is converted into a
single-ended voltage by designing an appropriate
operational amplifier configuration (Figure 6).
I/Q Reconstruction
in a QAM Application
The low-distortion performance of two MAX5181/
MAX5184s supports analog reconstruction of in-phase
(I) and quadrature (Q) carrier components typically
used in quadrature amplitude modulation (QAM) archi-
tectures where two separate buses carry the I and Q
data. A QAM signal is both amplitude (AM) and phase
modulated, created by summing two independently
modulated carriers of identical frequency but different
phase (90° phase difference).
In a typical QAM application (Figure 7), the modulation
occurs in the digital domain, and two DACs such as the
MAX5181/MAX5184 may be used to reconstruct the
analog I and Q components.
THD
20 log
(V
V
V
V
)
V
22
32
42
52
1
=
+
+
+
Figure 4. Timing Diagram
CLK
D0
–
D9
OUT
N - 1
N - 1
N
N
N + 1
N + 1
t
DS
t
DH
t
CH
t
CL
t
CLK
相關PDF資料 |
PDF描述 |
|---|---|
| MAX5184BEEG | 10-Bit, 40MHz, Current/Voltage-Output DACs |
| MAX5182 | Dual, 10-Bit, 40MHz Current/Voltage Alternate-Phase Output DACs |
| MAX5182BEEI | Dual, 10-Bit, 40MHz Current/Voltage Alternate-Phase Output DACs |
| MAX5185BEEI | Dual, 10-Bit, 40MHz Current/Voltage Alternate-Phase Output DACs |
| MAX5188BEEI | Dual, 8-Bit, 40MHz, Current/Voltage, Alternate-Phase Output DACs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX5184B/D | 功能描述:數模轉換器- DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MAX5184BEEG | 功能描述:數模轉換器- DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MAX5184BEEG+ | 功能描述:數模轉換器- DAC 10-Bit High Speed DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MAX5184BEEG+T | 功能描述:數模轉換器- DAC 10-Bit High Speed DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MAX5184BEEG-T | 功能描述:數模轉換器- DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。