- 您現在的位置：買賣IC網 > PDF目錄2088 > MAX4397DCTM+ (Maxim Integrated Products)IC SW A/V SCART CON 48-TQFN PDF資料下載
參數資料
| 型號： | MAX4397DCTM+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 5/30頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC SW A/V SCART CON 48-TQFN |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 43 |
| 類型： | 開關 |
| 應用： | DVD，機頂盒，電視 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 48-TQFN-EP（7x7） |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
Video Outputs
The DC level at the video outputs is controlled so that
coupling capacitors are not required, and all of the video
outputs are capable of driving a DC-coupled, 150,
back-terminated coax load with respect to ground.
In a typical television input circuit (see Figure 3), the
video output driver on the SCART chip only needs to
source current. Users should note that, while the
SCART specification states 75 impedance, in prac-
tice, typical SCART chip implementations assume 75
input resistance to ground (and source current from the
video output stage).
Since some televisions and VCRs use the horizontal
sync height for automatic gain control, the
MAX4397DA/SA accurately reproduce the sync height
to within ±2%.
Slow Switching
The MAX4397DA/SA support the IEC 933-1,
Amendment 1, tri-level slow switching that selects the
aspect ratio for the display (TV). Under I2C-compatible
control, the MAX4397DA/SA set the slow-switching out-
put voltage level. Table 1 shows the valid input levels of
the slow-switching signal and the corresponding oper-
ating modes of the display device.
Two bidirectional ports are available for slow-switching
signals for the TV and VCR. The slow-switching input
status is continuously read and stored in the register
0Eh. The slow-switching outputs can be set to a logic
level or high impedance by writing to registers 07h and
09h. See Tables 8 and 10 for details.
Fast Switching
The VCR or MPEG decoder outputs a fast-switching
signal to the display device or TV to insert an on-screen
display (OSD). The fast-switching signal can also be
set to a constant high or low output signal through the
I2C interface. The fast-switching output can be set
through writing to register 07h.
Y/C Mixer
The MAX4397DA/SA include an on-chip mixer to pro-
duce Composite video (CVBS) when S-video (Y and C)
is present. The Composite video drives the
RF_CVBS_OUT output pin. The circuit sums Y and C
signals to obtain the CVBS component. A +6dB output
buffer drives RF_CVBS_OUT.
Video Reconstruction Filter
The encoder DAC outputs need to be lowpass-filtered
to reject the out-of-band noise. The MAX4397DA/SA
integrate the reconstruction filter. The filter is fourth
order, which is composed of two Sallen-Key biquad in
cascade, implementing a Butterworth-type transfer
function. The internal reconstruction filters feature a
5.5MHz cutoff frequency and -30dB minimum attenua-
tion at 27MHz. Note that the SET pin is used to set the
accuracy of the filter cutoff frequency. Connect a
100k resistor from SET to ground.
SCART Audio Switching
Audio Inputs
All audio inputs for the MAX4397SA are single-ended
and AC-coupled. The MAX4397DA audio inputs are
singled-ended and AC-coupled except for the audio
encoder input, which is differential DC-coupled.
The audio block has three stereo audio inputs from the
TV, the VCR, and the MPEG decoder SCART. Each
input has a 100k resistor connected to an internally
generated voltage equal to 0.23 x V12, except for the
encoder input of the MAX4397DA, where the DC bias is
fixed externally.
MAX4397DA/SA
Audio/Video Switch for Dual SCART Connectors
______________________________________________________________________________________
13
Table 1. Slow-Switching Modes
SLOW-SWITCHING
SIGNAL VOLTAGE
(V)
MODE
0 to 2
Display device uses an internal source
such as a built-in tuner to provide a
video signal
4.5 to 7.0
Display device uses a video signal from
the SCART connector and sets the
display to a 16:9 aspect ratio
9.5 to 12.6
Display device uses a signal from the
SCART connector and sets the display
to a 4:3 aspect ratio
MAX4397DA/SA
SET-TOP BOX
TV
+5V
VIDEO
OUTPUT
DC
RESTORE
SCART
CABLE
0.1F
5k
75
INPUT
TERMINATION
RESISTOR
75
BACK
TERMINATION
RESISTOR
Figure 3. Typical TV Input Circuit
相關PDF資料 |
PDF描述 |
|---|---|
| MAX4397SCTM+T | IC SW A/V SCART CON 48-TQFN |
| MAX4399CTK+D | IC SW A/V SCART CON 68-TQFN |
| MAX4409ETP+T | IC AMP AUDIO .08W STER AB 20TQFN |
| MAX4410EUD+T | IC AMP AUDIO .08W STER 14TSSOP |
| MAX4411ETP+ | IC AMP AUDIO .08W STER AB 20TQFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX4397DCTM+ | 功能描述:視頻開關 IC Audio/Video Switch for Dual SCART Con RoHS:否 制造商:Texas Instruments 開關數量:4 開啟電阻（最大值）:12 Ohms 傳播延遲時間: 開啟時間（最大值）: 關閉時間（最大值）: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:WQFN-42 封裝:Reel |
| MAX4397DCTM+T | 功能描述:視頻開關 IC Audio/Video Switch for Dual SCART Con RoHS:否 制造商:Texas Instruments 開關數量:4 開啟電阻（最大值）:12 Ohms 傳播延遲時間: 開啟時間（最大值）: 關閉時間（最大值）: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:WQFN-42 封裝:Reel |
| MAX4397DCTM-T | 功能描述:視頻開關 IC RoHS:否 制造商:Texas Instruments 開關數量:4 開啟電阻（最大值）:12 Ohms 傳播延遲時間: 開啟時間（最大值）: 關閉時間（最大值）: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:WQFN-42 封裝:Reel |
| MAX4397EVKIT | 制造商:Maxim Integrated Products 功能描述:AUDIO/VIDEO SWITCH FOR DUAL SCART C - Rail/Tube |
| MAX4397SACTM+ | 功能描述:視頻開關 IC Audio/Video Switch for Dual SCART Con RoHS:否 制造商:Texas Instruments 開關數量:4 開啟電阻（最大值）:12 Ohms 傳播延遲時間: 開啟時間（最大值）: 關閉時間（最大值）: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:WQFN-42 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。
